Description: The Chile Triple Junction (CTJ) is the place where the Chile Ridge (Nazca–Antarctic spreading center) is subducting beneath the continental South American plate. Sediment accretion is active to the south of the CTJ in the area where the northward migrating Chile Ridge has collided with the continent since 14 Ma. At the CTJ, tectonic erosion of the overriding plate narrows and steepens the continental slope. We present here a detailed tomographic image of the upper lithospheric Antarctic–South America subduction zone where the Chile Ridge collided with the continent 3–6 Ma off Golfo de Penas. Results reveal that a large portion of trench sediment has been scraped off and frontally accreted to the forearc forming a 70–80 km wide accretionary prism. The velocity–depth model shows a discontinuity at 30–40 km landward of the deformation front, which is interpreted as the contact between the frontal (poorly consolidated sedimentary unit) and middle (more compacted sedimentary unit) accretionary prism. The formation of this discontinuity could be related to a short term episode of reduced trench sedimentation. In addition, we model the shape of the continental slope using a Newtonian fluid rheology to study the convergence rate at which the accretionary prism was formed. Results are consistent with an accretionary prism formed after the collision of the Chile Ridge under slow convergence rate similar to those observed at present between Antarctic and South America (∼2.0 cm/a). Based on the kinematics of the Chile Ridge subduction during the last 13 Ma, we propose that the accretionary prism off Golfo de Penas was formed recently (∼5 Ma) after the collision of the Chile Ridge with South America.

Description: Subduction zone earthquakes are known to create segmented patches of co-seismic rupture along-strike of a margin. Offshore Sumatra, repeated rupture occurred within segments bounded by permanent barriers, whose origin however is still not fully understood. In this study we image the structural variations across the rupture segment boundary between the Mw 9.1 December 26, 2004 and the Mw 8.6 March 28, 2005 Sumatra earthquakes. A set of collocated reflection and wide-angle seismic profiles are available on both sides of the segment boundary, located offshore Simeulue Island. We present the results of the seismic tomography modeling of wide-angle ocean bottom data, enhanced with MCS data and gravity modeling for the southern 2005 segment of the margin and compare it to the published model for the 2004 northern segment. Our study reveals principal differences in the structure of the subduction system north and south of the segment boundary, attributed to the subduction of 96°E fracture zone. The key differences include a change in the crustal thickness of the oceanic plate, a decrease in the amount of sediment in the trench as well as variations in the morphology and volume of the accretionary prism. These differences suggest that the 96°E fracture zone acts as an efficient barrier in the trench parallel sediment transport, as well as a divider between oceanic crustal blocks of different structure. The variability of seismic behavior is caused by the distinct changes in the morphology of the subduction complex across the boundary related to the difference in the sediment supply.

Description: Highlights • The basement at the mid-Norwegian Møre Margin is dominantly felsic in composition. • A lower crustal body is interpreted as a mixture of continental blocks and eclogite. • The thickness of the outer lower crustal body is twice as thick on the East Greenland Margin. • The thinning during this first phase of post-Caledonian extension was highest for proto Norway. Abstract The inner part of the volcanic, passive Møre Margin, mid-Norway, expresses an unusual abrupt thinning from high onshore topography with a thick crust to an offshore basin with thin crystalline crust. Previous P-wave modeling of wide-angle seismic data revealed the presence of a high-velocity (7.7–8.0 km/s) body in the lower crust in this transitional region. These velocities are too high to be readily interpreted as Early Cenozoic intrusions, a model often invoked to explain lower crustal high-velocity bodies in the region. We present a Vp/Vs model, derived from the modeling of wide-angle seismic data, acquired by use of Ocean Bottom Seismograph horizontal components. The modeling suggests dominantly felsic composition of the crust. An average Vp/Vs value for the lower crustal body is modeled at 1.77, which is compatible with a mixture of continental blocks and Caledonian eclogites. The results are compiled with earlier results into a transect extending from onshore Norway to onshore Greenland. Back-stripping of the transect to Early Cenozoic indicates asymmetric conjugate magmatism related to the continental break-up. Further back-stripping to the time when most of the Caledonian mountain range had collapsed indicates that the thinning during the first phase of extension was about 25% higher for proto Norway than proto Greenland.

Description: In April and May 1996, a geophysical study of the Cascadia continental margin off Oregon and Washington was carried out aboard the German RV Sonne as a cooperative experiment between GEOMAR, the USGS and COAS. Offshore central Oregon, which is the subject of this study, the experiment involved the collection of wide-angle refraction and reflection data along three profiles across the continental margin using ocean-bottom seismometers (OBS) and hydrophones (OBH) as well as land recorders. Two-dimensional modelling of the travel times provides a detailed velocity structure beneath these profiles. The subducting oceanic crust of the Juan de Fuca plate can be traced from the trench to its position some 10 km landward of the coastline. At the coastline, the Moho has a depth of 30 km. The dip of the plate changes from 1.5° westward of the trench to about 6.5° below the accretionary complex and to about 16° further eastward below the coast. The backstop forming western edge of the Siletz terrane, an oceanic plateau that was accreted to North America about 50 Ma ago, is well defined by the observations. It is located about 60 km to the east of the deformation front and has a seaward dip of 40°. At its seaward edge, the base of the Siletz terrane seems to be in contact with the subducting oceanic crust implying that sediments are unlikely to be subducted to greater depths. The upper oceanic crust is thinner to the east of this contact than to the west. At depths greater than 18 km, the top of the oceanic crust is the origin of pre-critical reflections observable in several land recordings and in the data of one ocean bottom instrument. These reflections are most likely caused by fluids that are released from the oceanic crust by metamorphic facies transition.

Description: High-resolution seismic experiments, employing arrays of closely spaced, four-component ocean-bottom seismic recorders, were conducted at a site off western Svalbard and a site on the northern margin of the Storegga slide, off Norway to investigate how well seismic data can be used to determine the concentration of methane hydrate beneath the seabed. Data from P-waves and from S-waves generated by P–S conversion on reflection were inverted for P- and S-wave velocity (Vp and Vs), using 3D travel-time tomography, 2D ray-tracing inversion and 1D waveform inversion. At the NW Svalbard site, positive Vp anomalies above a sea-bottom-simulating reflector (BSR) indicate the presence of gas hydrate. A zone containing free gas up to 150-m thick, lying immediately beneath the BSR, is indicated by a large reduction in Vp without significant reduction in Vs. At the Storegga site, the lateral and vertical variation in Vp and Vs and the variation in amplitude and polarity of reflectors indicate a heterogeneous distribution of hydrate that is related to a stratigraphically mediated distribution of free gas beneath the BSR. Derivation of hydrate content from Vp and Vs was evaluated, using different models for how hydrate affects the seismic properties of the sediment host and different approaches for estimating the background-velocity of the sediment host. The error in the average Vp of an interval of 20-m thickness is about 2.5%, at 95% confidence, and yields a resolution of hydrate concentration of about 3%, if hydrate forms a connected framework, or about 7%, if it is both pore-filling and framework-forming. At NW Svalbard, in a zone about 90-m thick above the BSR, a Biot-theory-based method predicts hydrate concentrations of up to 11% of pore space, and an effective-medium-based method predicts concentrations of up to 6%, if hydrate forms a connected framework, or 12%, if hydrate is both pore-filling and framework-forming. At Storegga, hydrate concentrations of up to 10% or 20% were predicted, depending on the hydrate model, in a zone about 120-m thick above a BSR. With seismic techniques alone, we can only estimate with any confidence the average hydrate content of broad intervals containing more than one layer, not only because of the uncertainty in the layer-by-layer variation in lithology, but also because of the negative correlation in the errors of estimation of velocity between adjacent layers. In this investigation, an interval of about 20-m thickness (equivalent to between 2 and 5 layers in the model used for waveform inversion) was the smallest within which one could sensibly estimate the hydrate content. If lithological layering much thinner than 20-m thickness controls hydrate content, then hydrate concentrations within layers could significantly exceed or fall below the average values derived from seismic data.

Description: We describe the deep structure of the south Colombian–northern Ecuador convergent margin using travel time inversion of wide-angle seismic data recently collected offshore. The margin appears segmented into three contrasting zones. In the North Zone, affected by four great subduction earthquakes during the 20th century, normal oceanic crust subducts beneath the oceanic Cretaceous substratum of the margin underlined by seismic velocities as high as 6.0–6.5 km/s. In the Central Zone the subducting oceanic crust is over-thickened beneath the Carnegie Ridge. A steeper slope and a well-developed, high velocity, Cretaceous oceanic basement characterizes the margin wedge. This area coincides with a gap in significant subduction earthquake activity. In the South Zone, the subducting oceanic crust is normal. The fore-arc is characterized by large sedimentary basins suggesting significant subsidence. Velocities in the margin wedge are significantly lower and denote a different nature or a higher degree of fracturing. Even if the distance between the three profiles exceeds 150 km, the structural segmentation obtained along the Ecuadorian margin correlates well with the distribution of seismic activity and the neotectonic zonation.

Description: Marine seismic wide-angle data acquisition and earthquake seismology observations are at the verge of a quantum leap in data quality and density. Advances in micro-electronic technology facilitates the construction of instrumcnts that enable large data volumes to be collected and that are small and cheap enough so that large numbers can be built and operated economically. The main improvements are a dramatic decrease of power consumption ( 〈 250 m W) and increase in clock stability ( 〈 0.05 ppm}. Several scenarios for future experiments arc discussed in this contrihution

Description: Oceanic island arcs are sites of high magma production and contribute to the formation of continental crust. Geophysical studies may provide information on the configuration and composition of island arc crust, however, to date only few seismic profiles exist across active island arcs, limiting our knowledge on the deep structure and processes related to the production of arc crust. We acquired active-source wide-angle seismic data crossing the central Lesser Antilles island arc north of Dominica where the oceanic Tiburon Ridge subducts obliquely beneath the forearc. A combined analysis of wide-angle seismics and pre-stack depth migrated reflection data images the complex structure of the backstop and its segmentation into two individual ridges, suggesting an intricate relation between subducted basement relief and forearc deformation. Tomographic imaging reveals three distinct layers composing the island arc crust. A three kilometer thick upper crust of volcanogenic sedimentary rocks and volcaniclastics is underlain by intermediate to felsic middle crust and plutonic lower crust. The island arc crust may comprise inherited elements of oceanic plateau material contributing to the observed crustal thickness. A high density ultramafic cumulates layer is not detected, which is an important observation for models of continental crust formation. The upper plate Moho is found at a depth of 24 km below the sea floor. Upper mantle velocities are close to the global average. Our study provides important information on the composition of the island arc crust and its deep structure, ranging from intermediate to felsic and mafic conditions. In this study we model the deep structure of the Lesser Antilles Island Arc. We use a hybrid analysis of refraction and reflection seismic data. We image the complex structure of two ridges forming the backstop. Island arc crust composition ranges from intermediate to felsic to mafic conditions. We discuss the formation of island arc and continental crust.

Description: The 27 February, 2010 Maule earthquake (Mw=8.8) ruptured ~400 km of the Nazca-South America plate boundary and caused hundreds of fatalities and billions of dollars in material losses. Here we present constraints on the fore-arc structure and subduction zone of the rupture area derived from seismic refraction and wide-angle data. The results show a wedge shaped body ~40 km wide with typical sedimentary velocities interpreted as a frontal accretionary prism (FAP). Landward of the imaged FAP, the velocity model shows an abrupt velocity-contrast, suggesting a lithological change which is interpreted as the contact between the FAP and the paleo accretionary prism (backstop). The backstop location is coincident with the seaward limit of the aftershocks, defining the updip limit of the co-seismic rupture and seismogenic zone. Furthermore, the seaward limit of the aftershocks coincides with the location of the shelf break in the entire earthquake rupture area (33°S–38.5°S), which is interpreted as the location of the backstop along the margin. Published seismic profiles at the northern and southern limit of the rupture area also show the presence of a strong horizontal velocity gradient seismic backstop at a distance of ~30 km from the deformation front. The seismic wide-angle reflections from the top of the subducting oceanic crust constrain the location of the plate boundary offshore, dipping at ~10°. The projection of the epicenter of the Maule earthquake onto our derived interplate boundary yielded a hypocenter around 20 km depth, this implies that this earthquake nucleated somewhere in the middle of the seismogenic zone, neither at its updip nor at its downdip limit.

Description: Following the devastating 2004 tsunami that hit the southwestern coast of Thailand, the need for detailed bathymetric data of the Andaman Sea outer shelf became evident in order to better predict tsunami wave propagation and coastal impact. Bathymetric data and subbottom profiler records covering the outer shelf and upper slope of the Thai exclusive economic zone (EEZ) were collected onboard Thai RV Chakratong Tongyai in 2006 and 2007. The data cover an area of approximately 3000 km2 between 500 and 1600 m water depth. The soundings allowed generating a final bathymetric grid with 50 m grid cell spacing. The outer shelf is rather smooth and slightly inclined southward, while the upper slope is strongly dissected by gullies. Several previously unknown features are identified including mud-domes, pockmarks, three large plateaus surrounded by moats, gas-charged sediment on subbottom profiler records, and only few indications for small submarine landslides on the upper slope. The largest of these possibly translational submarine landslides involved 2.2×107 m3 of sediment. This slide would have generated a tsunami wave of less than 0.12 m wave height. Considering the entire data, there is no evidence that landslides have been the source of tsunami waves in recent geological time. Highlights