Description: Increasing interest in deep-sea mineral resources, such as polymetallic nodules, calls for environmental research about possible impacts of mineral exploitation on the deep-sea ecosystem. So far, little geochemical comparisons of deep-sea sediments before and after mining induced disturbances have been made, and thus long-term environmental effects of deep-sea mining are unknown. Here we present geochemical data from sediment cores from an experimental disturbance area at 4,100 m water depth in the Peru Basin. The site was revisited in 2015, 26 years after a disturbance experiment mimicking nodule mining was carried out and compared to sites outside the experimental zone which served as a pre-disturbance reference. We investigated if signs of the disturbance are still visible in the solid phase and the pore water after 26 years or if pre-disturbance conditions have been re-established. Additionally, a new disturbance was created during the cruise and sampled 5 weeks later to compare short- and longer-term impacts. The particulate fraction and pore water were analyzed for major and trace elements to study element distribution and processes in the surface sediment. Pore water and bottom water samples were also analyzed for oxygen, nitrate, dissolved organic carbon, and dissolved amino acids, to examine organic matter degradation processes. The study area of about 11 km2 was found to be naturally more heterogeneous than expected, requiring an analysis of spatial variability before the disturbed and undisturbed sites can be compared. The disturbed sites exhibit various disturbance features: some surface sediments were mixed through, others had the top layer removed and some had additional material deposited on top. Pore water constituents have largely regained pre-disturbance gradients after 26 years. The solid phase, however, shows clear differences between disturbed and undisturbed sites in the top 20 cm so that the impact is still visible in the plowed tracks after 26 years. Especially the upper layer, usually rich in manganese-oxide and associated metals, such as Mo, Ni, Co, and Cu, shows substantial differences in metal distribution. Hence, it can be expected that disturbances from polymetallic nodule mining will have manifold and long-lasting impacts on the geochemistry of the underlying sediment.

Description: The interplay between sediment deposition patterns, organic matter type and the quantity and quality of reactive mineral phases determines the accumulation, speciation, and isotope composition of pore water and solid phase sulfur constituents in marine sediments. Here, we present the sulfur geochemistry of siliciclastic sediments from two sites along the Argentine continental slope—a system characterized by dynamic deposition and reworking, which result in non-steady state conditions. The two investigated sites have different depositional histories but have in common that reactive iron phases are abundant and that organic matter is refractory—conditions that result in low organoclastic sulfate reduction rates (SRR). Deposition of reworked, isotopically light pyrite and sulfurized organic matter appear to be important contributors to the sulfur inventory, with only minor addition of pyrite from organoclastic sulfate reduction above the sulfate-methane transition (SMT). Pore-water sulfide is limited to a narrow zone at the SMT. The core of that zone is dominated by pyrite accumulation. Iron monosulfide and elemental sulfur accumulate above and below this zone. Iron monosulfide precipitation is driven by the reaction of low amounts of hydrogen sulfide with ferrous iron and is in competition with the oxidation of sulfide by iron (oxyhydr)oxides to form elemental sulfur. The intervals marked by precipitation of intermediate sulfur phases at the margin of the zone with free sulfide are bordered by two distinct peaks in total organic sulfur (TOS). Organic matter sulfurization appears to precede pyrite formation in the iron-dominated margins of the sulfide zone, potentially linked to the presence of polysulfides formed by reaction between dissolved sulfide and elemental sulfur. Thus, SMTs can be hotspots for organic matter sulfurization in sulfide-limited, reactive iron-rich marine sedimentary systems. Furthermore, existence of elemental sulfur and iron monosulfide phases meters below the SMT demonstrates that in sulfide-limited systems metastable sulfur constituents are not readily converted to pyrite but can be buried to deeper sediment depths. Our data show that in non-steady state systems, redox zones do not occur in sequence but can reappear or proceed in inverse sequence throughout the sediment column, causing similar mineral alteration processes to occur at the same time at different sediment depths.

Description: The geochemical cycling of barium was investigated in sediments of pockmarks of the northern Congo Fan, characterized by surface and subsurface gas hydrates, chemosynthetic fauna, and authigenic carbonates. Two gravity cores retrieved from the so-called Hydrate Hole and Worm Hole pockmarks were examined using high-resolution pore-water and solid-phase analyses. The results indicate that, although gas hydrates in the study area are stable with respect to pressure and temperature, they are and have been subject to dissolution due to methane-undersaturated pore waters. The process significantly driving dissolution is the anaerobic oxidation of methane (AOM) above the shallowest hydrate-bearing sediment layer. It is suggested that episodic seep events temporarily increase the upward flux of methane, and induce hydrate formation close to the sediment surface. AOM establishes at a sediment depth where the upward flux of methane from the uppermost hydrate layer counterbalances the downward flux of seawater sulfate. After seepage ceases, AOM continues to consume methane at the sulfate/methane transition (SMT) above the hydrates, thereby driving the progressive dissolution of the hydrates “from above”. As a result the SMT migrates downward, leaving behind enrichments of authigenic barite and carbonates that typically precipitate at this biogeochemical reaction front. Calculation of the time needed to produce the observed solid-phase barium enrichments above the present-day depths of the SMT served to track the net downward migration of the SMT and to estimate the total time of hydrate dissolution in the recovered sediments. Methane fluxes were higher, and the SMT was located closer to the sediment surface in the past at both sites. Active seepage and hydrate formation are inferred to have occurred only a few thousands of years ago at the Hydrate Hole site. By contrast, AOM-driven hydrate dissolution as a consequence of an overall net decrease in upward methane flux seems to have persisted for a considerably longer time at the Worm Hole site, amounting to a few tens of thousands of years.

Description: We investigated gas hydrate in situ inventories as well as the composition and principal transport mechanisms of fluids expelled at the Amsterdam mud volcano (AMV; 2,025 m water depth) in the Eastern Mediterranean Sea. Pressure coring (the only technique preventing hydrates from decomposition during recovery) was used for the quantification of light hydrocarbons in near-surface deposits. The cores (up to 2.5 m in length) were retrieved with an autoclave piston corer, and served for analyses of gas quantities and compositions, and pore-water chemistry. For comparison, gravity cores from sites at the summit and beyond the AMV were analyzed. A prevalence of thermogenic light hydrocarbons was inferred from average C1/C2+ ratios 〈35 and δ13C-CH4 values of −50.6‰. Gas venting from the seafloor indicated methane oversaturation, and volumetric gas–sediment ratios of up to 17.0 in pressure cores taken from the center demonstrated hydrate presence at the time of sampling. Relative enrichments in ethane, propane, and iso-butane in gas released from pressure cores, and from an intact hydrate piece compared to venting gas suggest incipient crystallization of hydrate structure II (sII). Nonetheless, the co-existence of sI hydrate can not be excluded from our dataset. Hydrates fill up to 16.7% of pore volume within the sediment interval between the base of the sulfate zone and the maximum sampling depth at the summit. The concave-down shapes of pore-water concentration profiles recorded in the center indicate the influence of upward-directed advection of low-salinity fluids/fluidized mud. Furthermore, the SO42− and Ba2+ pore-water profiles in the central part of the AMV demonstrate that sulfate reduction driven by the anaerobic oxidation of methane is complete at depths between 30 cm and 70 cm below seafloor. Our results indicate that methane oversaturation, high hydrostatic pressure, and elevated pore-water activity caused by low salinity promote fixing of considerable proportions of light hydrocarbons in shallow hydrates even at the summit of the AMV, and possibly also of other MVs in the region. Depending on their crystallographic structure, however, hydrates will already decompose and release hydrocarbon masses if sediment temperatures exceed ca. 19.3°C and 21.0°C, respectively. Based on observations from other mud volcanoes, the common occurrence of such temperatures induced by heat flux from below into the immediate subsurface appears likely for the AMV.

Description: In order to analyse differences in concentration, speciation and total mobility of arsenic two different locations were studied near the Helgoland Mud Area, North Sea. The first location is characterised by natural sedimentation, the second by deposited sediments dredged from the port of Hamburg. Porewater as well as sediment profiles were analysed with respect to arsenic compounds (As (III) and total As) and major redox species as total and reactive manganese and iron. The sediment samples were handled under inert atmosphere before and during extraction by water, phosphate, hydrochloric acid and aqua regia. Total element contents in porewater and leachable extracts of sediment fractions were analysed. The results show a strong redox coupling of arsenic with manganese and iron. Oxidized arsenic seems to adsorb to manganese- and iron-oxyhydroxides in surface sediments. In contrast to the solid samples, the pore water data shows a release of As (III) into porewater when manganese- and ironoxyhydroxides are reduced in the upper part of the cores. Also a remobilisation of As (V) occurs. Downward diffusing arsenic can be fixed by carbonate below the zone of manganese and iron reduction. In the anoxic parts of the sediments As (III) and As (V) are released and could be fixed at authigenic iron sulphide or arsenic sulphides formation. A sulfidic precipitation of arsenic in iron-dominated systems is limited by the occurrence of HS-. Total solid-phase contents in leachable extracts of sediment fractions of the natural area show significant higher arsenic concentrations than the core of the anthropogenic dumping area. This is due to the higher fines content of the Helgoland mud area. Higher total porewater contents of iron and arsenic in the core of the anthropogenic dumping area thus due to higher turnover rates of organic matter by iron reduction. Higher concentrations of arsenic may be due to a higher availability of iron in the dumped sediments.

Description: Oceanic anoxic events (OAEs) were a frequent occurrence in the Cretaceous greenhouse ocean. Based on a variety of paleoredox indicators, euxinic water column conditions are commonly invoked for these OAEs. However, in a high resolution study of OAE3 deep sea sediments [1], revised paleoredox indicators suggest that euxinic conditions fluctuated with anoxic ferruginous conditions on orbital timescales. Building upon this, we here present new data for a continental shelf setting at Tarfaya, Morocco, that spans a period prior to, and during, the onset of OAE2. We again find strong evidence for orbital transitions from euxinic to ferruginous conditions. The presence of this distinct cyclicity during OAE2 and OAE3 in shallow and deep water settings, coupled with its occurrence on the anoxic shelf prior to the global onset of anoxia, suggests that these fluctuations were a fundamental feature of anoxia in the Cretaceous ocean. The observed redox cyclicity has major implications for the cycling of phosphorus, and hence the maintenance and longevity of OAEs. However, despite this significance, controls on the observed redox cyclicity are essentially unknown. Here, we utilize S isotope measurements (pyrite S and carbonate-associated S) from the deep sea and shelf settings to model oceanic sulphate concentrations across the redox transitions. Perhaps surprisingly, we find no evidence to suggest that ferruginous conditions arose due to extensive drawdown of seawater sulphate (as pyrite-S and organic-S) under euxinic conditions. Instead, S isotope systematics in the deep sea imply increased sulphate concentrations during ferruginous intervals. Based on these observations and other major element data, we infer that the redox cyclicity instead relates to orbitally-paced fluctuations in continental hydrology and weathering, linking the redox state of the global ocean to climate-driven processes on land. [1] März et al (2008) GCA, 72, 3703-3717.

Description: The partitioning of Fe in sediments and soils has traditionally been studied by applying sequential leaching methods. These are based on reductive dissolution and exploit differences in dissolution rates between different reactive Fe (oxyhydr)oxide minerals. We used lab-made ferrihydrite, goethite, hematite and magnetite spiked with 58Fe and leached two-mineral mixtures with both phases abundant in excess of the methods dissolution capacity. Leaching was performed with 1) hydroxylamine-HCl and 2) Na-dithionite as the reactive agent. Following Poulton & Canfield (2005) [1], the first dissolution is designed to selectively leach the most reactive Fe-phases, ferrihydrite and lepidocrocite, whereas the second dissolution is designed to leach goethite and hematite. Magnetite would then be dissolved in a third dissolution step with oxalic acid. First results show that the hydroxylamine-HCl method for ferrihydrite dissolves only insignificant amounts of goethite and hematite. However, magnetite-Fe constitutes about 10% of the total dissolved Fe. The Na-dithionite dissolved Fe from goethite-magnetite and hematite-magnetite mixtures contain about 30% of magnetite-Fe. We applied selective sequential leaching and Fe isotope analysis to fine-grained marine sediments from a depocenter in the North Sea, which contain abundant reactive Fe (oxyhydr)oxides and show evidence for Fe sulfide formation within the upper 10 cm. Fe isotopes of the hydroxylamine-HCl leach targeting ferrihydrite shows a downcore increase of !56Fe typical for sediments undergoing microbial reductive Fe dissolution, whereas Fe isotopes of the Na-dithionite leach (goethite and hematite) and oxalic acid leach (magnetite) are identical and show no downcore variation in !56Fe. This means, that only the most reactive Fe phases participate in the Fe redox cycle in this location. The similar isotopic composition of goethite + hematite and magnetite suggests a detrital source, which is not utilized possibly due to the abundant ferrihydrite and lepidocrocite present. [1] Poulton & Canfield (2005), Chemical Geology 214, 209– 221