Description: Highlights • The Lofoten/Vesterålen margin has less Early Cenozoic lava flows than believed. • Breakup of the L/V margin is delayed ∼1 m.y. from the Vøring Plateau to the south. • Late arrival of the Iceland Plume may explain delayed breakup and prolonged extension. The Early Eocene continental breakup was magma-rich and formed part of the North Atlantic Igneous Province. Extrusive and intrusive magmatism was abundant on the continental side, and a thick oceanic crust was produced up to a few m.y. after breakup. However, the extensive magmatism at the Vøring Plateau off mid-Norway died down rapidly northeastwards towards the Lofoten/Vesterålen Margin. In 2003 an Ocean Bottom Seismometer profile was collected from mainland Norway, across Lofoten, and into the deep ocean. Forward/inverse velocity modeling by raytracing reveals a continental margin transitional between magma-rich and magma-poor rifting. For the first time a distinct lower-crustal body typical for volcanic margins has been identified at this outer margin segment, up to 3.5. km thick and ∼50. km wide. On the other hand, expected extrusive magmatism could not be clearly identified here. Strong reflections earlier interpreted as the top of extensive lavas may at least partly represent high-velocity sediments derived from the shelf, and/or fault surfaces. Early post-breakup oceanic crust is moderately thickened (∼8. km), but is reduced to 6. km after 1. m.y. The adjacent continental crystalline crust is extended down to a minimum of 4.5. km thickness. Early plate spreading rates derived from the Norway Basin and the northern Vøring Plateau were used to calculate synthetic magnetic seafloor anomalies, and compared to our ship magnetic profile. It appears that continental breakup took place at ∼53.1. Ma, ∼1. m.y. later than on the Vøring Plateau, consistent with late strong crustal extension. The low interaction between extension and magmatism indicates that mantle plume material was not present at the Lofoten Margin during initial rifting, and that the observed excess magmatism was created by late lateral transport from a nearby pool of plume material into the lithospheric rift zone at breakup time.

Description: The continuation of the Caledonides into the Barents Sea has long been a subject of discussion, and two major orientations of the Caledonian deformation fronts have been suggested: NNW-SSE striking and NE-SW striking. A regional NW-SE oriented ocean bottom seismic profile across the western Barents Sea was acquired in 2014. In this paper we map the crust and upper mantle structure along this profile in order to discriminate between different interpretations of Caledonian structural trends and orientation of rift basins in the western Barents Sea. Modeling of P-wave travel times has been done using a ray-tracing method, and combined with gravity modeling. The results show high P-wave velocities (4 km/s) close to the seafloor, as well as localized sub-horizontal high velocity zones (6.0 km/s and 6.9 km/s) at shallow depths which are interpreted as magmatic sills. Refractions from the top of the crystalline basement together with reflections from the Moho give basement velocities from 6.0 km/s at the top to 6.7 km/s at the base of the crust. P-wave travel time modeling of the OBS profile indicate an eastwards increase in velocities from 6.4 km/s to 6.7 km/s at the base of the crystalline crust, and the western part of the profile is characterized by a higher seismic reflectivity than the eastern part. This change in seismic character is consistent with observations from vintage reflection seismic data and is interpreted as a Caledonian suture extending through the Barents Sea, separating Barentsia and Baltica. Local deepening of Moho (from 27 km to 33 km depth) creates “root structures” that can be linked to the Caledonian compressional deformation or a suture zone imprinted in the lower crust. Our model supports a separate NE-SW Caledonian trend extending into the central Barents Sea, branching off from the northerly trending Svalbard Caledonides, implying the existence of Barentsia as an independent microcontinent between Laurentia and Baltica.

Description: Highlights • The basement at the mid-Norwegian Møre Margin is dominantly felsic in composition. • A lower crustal body is interpreted as a mixture of continental blocks and eclogite. • The thickness of the outer lower crustal body is twice as thick on the East Greenland Margin. • The thinning during this first phase of post-Caledonian extension was highest for proto Norway. Abstract The inner part of the volcanic, passive Møre Margin, mid-Norway, expresses an unusual abrupt thinning from high onshore topography with a thick crust to an offshore basin with thin crystalline crust. Previous P-wave modeling of wide-angle seismic data revealed the presence of a high-velocity (7.7–8.0 km/s) body in the lower crust in this transitional region. These velocities are too high to be readily interpreted as Early Cenozoic intrusions, a model often invoked to explain lower crustal high-velocity bodies in the region. We present a Vp/Vs model, derived from the modeling of wide-angle seismic data, acquired by use of Ocean Bottom Seismograph horizontal components. The modeling suggests dominantly felsic composition of the crust. An average Vp/Vs value for the lower crustal body is modeled at 1.77, which is compatible with a mixture of continental blocks and Caledonian eclogites. The results are compiled with earlier results into a transect extending from onshore Norway to onshore Greenland. Back-stripping of the transect to Early Cenozoic indicates asymmetric conjugate magmatism related to the continental break-up. Further back-stripping to the time when most of the Caledonian mountain range had collapsed indicates that the thinning during the first phase of extension was about 25% higher for proto Norway than proto Greenland.

Description: In April and May 1996, a geophysical study of the Cascadia continental margin off Oregon and Washington was carried out aboard the German RV Sonne as a cooperative experiment between GEOMAR, the USGS and COAS. Offshore central Oregon, which is the subject of this study, the experiment involved the collection of wide-angle refraction and reflection data along three profiles across the continental margin using ocean-bottom seismometers (OBS) and hydrophones (OBH) as well as land recorders. Two-dimensional modelling of the travel times provides a detailed velocity structure beneath these profiles. The subducting oceanic crust of the Juan de Fuca plate can be traced from the trench to its position some 10 km landward of the coastline. At the coastline, the Moho has a depth of 30 km. The dip of the plate changes from 1.5° westward of the trench to about 6.5° below the accretionary complex and to about 16° further eastward below the coast. The backstop forming western edge of the Siletz terrane, an oceanic plateau that was accreted to North America about 50 Ma ago, is well defined by the observations. It is located about 60 km to the east of the deformation front and has a seaward dip of 40°. At its seaward edge, the base of the Siletz terrane seems to be in contact with the subducting oceanic crust implying that sediments are unlikely to be subducted to greater depths. The upper oceanic crust is thinner to the east of this contact than to the west. At depths greater than 18 km, the top of the oceanic crust is the origin of pre-critical reflections observable in several land recordings and in the data of one ocean bottom instrument. These reflections are most likely caused by fluids that are released from the oceanic crust by metamorphic facies transition.

Description: The southern central Chilean margin at the site of the largest historically recorded earthquake in the Valdivia region, in 1960 (Mw = 9.5), is part of the 5000-km-long active subduction system whose geodynamic evolution is controversially debated and poorly understood. Covering the area between 36° and 40°S, the oceanic crust is segmented by prominent fracture zones. The offshore forearc and its onshore continuation show a complex image with segments of varying geophysical character, and several fault systems active during the past 24 m.y. In autumn 2001, the project SPOC was organized to study the Subduction Processes Off Chile, with a focus on the seismogenic coupling zone and the forearc. The acquired seismic data crossing the Chilean subduction system were gathered in a combined offshore-onshore survey and provide new insights into the lithospheric structure and evolution of active margins with insignificant frontal accretion.

Description: Seismic investigations across the convergent Sunda margin off Indonesia provide a detailed image of the crustal architecture of the Sunda plate boundary. The combined analysis and interpretation of wide-angle and reflection seismic data along two coincident profiles across the subduction zone are complemented by additional lines within the forearc domain, which yield some three-dimensional (3-D) constraints on the velocity-depth structure across the margin. A detailed cross section of the subduction zone is presented, which is confirmed by supplementary gravity modeling. The Sunda convergence zone is a prime example of an accretionary margin, where sediment accretion has led to the formation of a massive accretionary prism, with a total width of 〉110 km between the trench and the forearc basin. It is composed of a frontal wedge which documents ongoing accretion and a fossil part behind the present backstop structure which constitutes the outer high. Moderate seismic velocities derived from wide-angle modeling indicate a sedimentary composition of the outer high. The subducting oceanic slab is traced to a depth of almost 30 km underneath the accretionary prism. The adjacent forearc domain is characterized by a pronounced morphological basin which is underlain by a layer of increased seismic velocities and a shallow upper plate Moho at 16 km depth. We speculate that remnant fragments of oceanic crust might be involved in the formation of this oceanic-type crust found at the leading edge of the upper plate beneath the forearc basin.

Description: Marine seismic wide-angle data acquisition and earthquake seismology observations are at the verge of a quantum leap in data quality and density. Advances in micro-electronic technology facilitates the construction of instrumcnts that enable large data volumes to be collected and that are small and cheap enough so that large numbers can be built and operated economically. The main improvements are a dramatic decrease of power consumption ( 〈 250 m W) and increase in clock stability ( 〈 0.05 ppm}. Several scenarios for future experiments arc discussed in this contrihution

Description: A seismic wide-angle section offshore Costa Rica is presented across the boundary between oceanic crust generated at the East Pacific rise (EPR) and at the Galápagos spreading center (GSC) as indicated by magnetic anomalies. This suture, where the Farallon plate broke up ∼23 Ma ago, is marked by pronounced velocity variations throughout the crust including a low-velocity body in the lower crust. This body is well constrained by refracted waves above the inversion zone and by strong PmP reflections from its lower boundary. The distinctness of this body and the local gravity field point to an igneous intrusion rather than serpentinized rock. Typical oceanic crust is found adjacent to the suture zone.

Description: The Cascadia convergent margin is a first-order research target to study the impact of rapid sedimentation processes on the mechanics of frontal subduction zone accretion. The near-trench part of the accretionary prism offshore Washington is affected by strongly increased glacial age sedimentation and fan formation that led to an outstanding Quaternary growth rate with landward vergent thrust faulting that is rarely observed elsewhere in accretionary wedges. Multichannel seismic reflection data acquired on the ORWELL project allows us to study the structure and dynamics of the atypical frontal accretion processes. We performed a kinematical and mechanical analysis of the frontal accretion structures, and developed a dynamic Coulomb-wedge model for the landward-verging backthrust formation. Backthrusting results from heterogeneous diffuse strain accumulation in the mechanically heterogeneous Cascadia basin sediment succession entering the subduction zone, and strain partitioning along a midlevel detachment that is activated by gravitational loading caused by rapid glacial age sedimentation. These complex deformation processes cause the passive “upward” delamination of the upper turbidite beds from the basal pelagic carbonate section similar to triangle-zone formation and passive backthrust wedging in foreland thrust belts caused by rapid burial beneath syntectonic sediment deposits. The deformation mechanism at the tectonic front of the Cascadia margin is an immediate response to the strongly increased late Pleistocene sediment flux rather than to atypical physical boundary conditions as generally thought.