Description: Increasing interest in deep-sea mineral resources, such as polymetallic nodules, calls for environmental research about possible impacts of mineral exploitation on the deep-sea ecosystem. So far, little geochemical comparisons of deep-sea sediments before and after mining induced disturbances have been made, and thus long-term environmental effects of deep-sea mining are unknown. Here we present geochemical data from sediment cores from an experimental disturbance area at 4,100 m water depth in the Peru Basin. The site was revisited in 2015, 26 years after a disturbance experiment mimicking nodule mining was carried out and compared to sites outside the experimental zone which served as a pre-disturbance reference. We investigated if signs of the disturbance are still visible in the solid phase and the pore water after 26 years or if pre-disturbance conditions have been re-established. Additionally, a new disturbance was created during the cruise and sampled 5 weeks later to compare short- and longer-term impacts. The particulate fraction and pore water were analyzed for major and trace elements to study element distribution and processes in the surface sediment. Pore water and bottom water samples were also analyzed for oxygen, nitrate, dissolved organic carbon, and dissolved amino acids, to examine organic matter degradation processes. The study area of about 11 km2 was found to be naturally more heterogeneous than expected, requiring an analysis of spatial variability before the disturbed and undisturbed sites can be compared. The disturbed sites exhibit various disturbance features: some surface sediments were mixed through, others had the top layer removed and some had additional material deposited on top. Pore water constituents have largely regained pre-disturbance gradients after 26 years. The solid phase, however, shows clear differences between disturbed and undisturbed sites in the top 20 cm so that the impact is still visible in the plowed tracks after 26 years. Especially the upper layer, usually rich in manganese-oxide and associated metals, such as Mo, Ni, Co, and Cu, shows substantial differences in metal distribution. Hence, it can be expected that disturbances from polymetallic nodule mining will have manifold and long-lasting impacts on the geochemistry of the underlying sediment.

Description: Shallow gas migration along hydrocarbon wells constitutes a potential methane emission pathway that currently is not recognized in any regulatory framework or greenhouse gas inventory. Recently, the first methane emission measurements at three abandoned offshore wells in the Central North Sea (CNS) were conducted showing that considerable amounts of biogenic methane originating from shallow gas accumulations in the overburden of deep reservoirs were released by the boreholes. Here, we identify numerous wells poking through shallow gas pockets in 3D seismic data of the CNS indicating that about one third of the wells may leak, potentially releasing a total of 3-17 kt of methane per year into the North Sea. This poses a significant contribution to the North Sea methane budget. A large fraction of this gas (~42 %) may reach the atmosphere via direct bubble transport (0-2 kt yr-1) and via diffusive exchange of methane dissolving in the surface mixed layer (1-5 kt yr-1), as indicated by numerical modeling. In the North Sea and in other hydrocarbon-prolific provinces of the world shallow gas pockets are frequently observed in the sedimentary overburden and aggregate leakages along the numerous wells drilled in those areas may be significant.

Description: Injection of CO2 into CH4-hydrate bearing sediments, and the resulting in-situ replacement of CH4-hydrate by CO2-hydrate, has been proposed as a technique for the emission-free production of natural gas from gas hydrates. While the hydrate conversion is thermodynamically feasible, many studies conclude that the overall process suffers from mass transfer limitations and CH4 production is limited after short time. To improve CH4 production various technical concepts have been considered, including the injection of heated supercritical CO2 combining chemical activation and thermalstimulation. While the feasibility of the concept was demonstrated in high-pressure flow-through experiments and high CH4 production efficiencies were observed, it was evident that overall yields and efficiencies were influenced by a variety of processes which could not be disclosed through bulk mass and volume analysis. Here we present different numerical simulation strategies which were developed and tested as tools to better understand the importance of mass and heat transport relative to reaction and phase transition kinetics for CH4 release and production, or for CO2 retention, respectively. The modeling approaches are discussed with respect to applicability for experimental design, process development or prediction of CH4 production from natural gas hydrate reservoirs on larger scales.

Description: Water permeability in gas hydrate bearing sediments is a crucial parameter for the prediction of gas production scenarios. So far, the commonly used permeability models are backed by very few experimental data. Furthermore, detailed knowledge of the exact formation mechanism leads to severe uncertainties in the interpretation of the experimental data. We formed CH4 hydrates from a methane saturated water solution and used Magnetic Resonance Imaging (MRI) to measure time resolved maps of the three-dimensional gas hydrate saturation. These maps were used for 3D Finite Elements Method (FEM) simulations. The simulation results enabled us to optimize existing models for permeabilities as function of gas hydrate saturation.

Description: The Alaska North Slope comprises an area of about 400,000 km2 including prominent gas and oil fields. Gas hydrates occur widely at the Alaska North Slope. A recent assessment by the USGS estimates 0.7-4.47 x 1012 m3 of technically recoverable gas hydrates based on well data and drilled hydrate accumulations. In spring 2012 a production field trial, testing CO2/N2 injection and depressurization, was conducted by USDOE/JOGMEC/ConocoPhillips at the Ignik Sikumi site. The 3D geological model of the Alaska North Slope developed by the USGS and Schlumberger is used to test the new gas hydrate module in the petroleum systems modeling software PetroMod®. Model results of the present extent of the gas hydrate stability zone (GHSZ) are in good agreement with results from well data. The model simulations reveal that the evolution of the GHSZ over time is primarily controlled by the climatic conditions regulating the extent of the permafrost during the last 1 Myr. Preliminary model runs predict the highest gas hydrate saturations near the major faults and at the bottom of the GHSZ, where thermogenic methane gas accumulates after migration through the most permeable stratigraphic layers (e.g. Sag River Sandstone Fm, Ivishak Fm). Gas hydrate saturations predicted for the Mount Elbert Stratigraphic Test Well and the Ignik Sikumi sites are basically controlled by the alternation of layers with different permeability and the fault properties (time of opening, permeability, etc). Further results including a total gas hydrate assessment for the Alaska North Slope will be presented during the conference.

Description: Due to their favorable P-T conditions and organic-rich deposits, sub-seafloor sediments in the northern Gulf of Mexico are known to have a large potential for gas hydrate accumulations. The presence of gas hydrates within sediments of the Green Canyon block has been proven by various methods, incl. seismic imaging, geochemical analysis, and drilling conducted mainly as a part of Joint Industry Project (JIP) Phase II. Gas hydrates reported therein usually occur as tens up to hundreds of meters thick sections with moderate to high concentrations within a range of 50 – 70 vol. % of pore space, and hence, seem to offer a considerable natural deposit of methane gas. The main focus of this study was to explore the complex effects of a set of control- parameters responsible for hydrocarbon migration and storage within the Gas Hydrate Stability Zone (GHSZ) on the accumulation of gas hydrates. To investigate the processes of basin formation and its subsidence history, source rock maturation, hydrocarbon migration and expulsion, and to quantify the gas hydrate accumulation potential, 3-D numerical study has been conducted using PetroMod. The area of interest extends over ~14 km x 33 km and covers the edge of the Sigsbee Escarpment representing the main salt mobility front in the region. The simulation contains full depositional history of the Green Canyon block, incl. salt deposition and re-mobilization as well as its further implications for temperature field, fluids migration and sedimentary layers distribution. Methane generation has been resolved by in-situ POC degradation and deep thermogenic mobilization from two distinct hydrocarbon sources. As a result, we present a number of likely scenarios of gas hydrate formation and accumulation in the study area that have been calibrated against available data.

Description: The injection of CO2 into CH4-hydrate-bearing sediments has the potential to drive natural gas production and simultaneously sequester CO2 by hydrate conversion. Currently, process conditions under which this goal can be achieved efficiently are largely unknown. While the recent Ignik Sikumi field test suggests that a combination of N2/CO2 injection with depressurization yields effective CH4 production, in a previous study (Deusner et al., 2012) we showed that a combination of CO2 injection and thermal stimulation eliminates mass transfer limitations observed at cold reservoir temperatures. These high-pressure flow-through studies revealed that the injection of supercritical CO2 at 95 °C triggers dissociation of CH4-hydrates and counters rapid CO2-hydrate formation in the near-injection region. We also observed a strong effect of reservoir temperature on CH4 production and CO2 retention. The efficiency and yield of CH4 production was highest at a sediment temperature of 8 °C compared to 2 °C and 10 °C. At 2 °C CO2 hydrate formation was rapid and clogged the sediment at the injection spot. Outside the CO2-hydrate stability region, at 10 °C, we observed fast CO2 breakthrough and a comparably low CH4 production. Experiments comparing discontinuous and continuous CO2 injection showed that alternating periods of equilibration and CO2 injection improved the overall CH4 production. We hypothesize that slow formation of secondary CO2-rich hydrate improves the accessibility of the CH4-hydrate distributed in the sediment by locally changing permeability and fluid flow patterns. In situ measurements showed dynamic changes of local p-/T-gradients due to gas hydrate dissociation or dissolution and secondary gas hydrate formation. In addition, continued reconfiguration of guest molecules in transiently formed mixed hydrates maintain elevated gas exchange kinetics. Online effluent fluid analysis under in-situ pressure conditions indicated that CH4 released from CH4-hydrates is largely dissolved in liquid CO2.. It is a current objective of our studies to further elucidate rheological properties and gas exchange efficiencies of CO2-CH4 mixed fluids that approach equilibrium with gas hydrates and to study the effect of in situ CH4-CO2-hydrate conversion and secondary gas hydrate formation on sediment geomechanical parameters.

Description: Following several small-scale benthic disturbance experiments, an industrial polymetallic nodule collector trial was conducted by the company Global Sea mineral Resources (GSR) in their exploration contract area in the Clarion-Clipperton Zone using the pre-prototype vehicle Patania II (PATII). In this study, meiofaunal (i.e., nematode abundance, ASV diversity and genus composition) and environmental (i.e., grain size, total organic carbon/total nitrogen and pigment) properties are compared between disturbance categories (i.e., Pre-impact, Collector Impact and Plume Impact). One week after the trial, proxies for food availability within the Collector Impact sediments were altered with lower total organic carbon (TOC) and pigment (i.e., CPE: sum of Chlorophyll a and phaeopigments) values. Albeit not significant, the observed decrease of nematode abundance and ASV diversity, further indicate the consequences of the removal of the ecologically important surface sediment layer within the PATII tracks. Next to sediment removal, exposed sediments were modified in different ways (e.g., central strips, parallel caterpillar imprints with alternating bands of depressions/ripples and interface patches) and were also subject to heavy collector-induced sediment blanketing. We propose that these cumulative impacts have led to intricate seabed modifications with various levels of disturbance intensity which resulted in the high meiofaunal variability observed. Adjacent nodule-rich areas (i.e., Plume Impact) received considerable levels of sediment deposition (2-3 cm) and were defined by significantly lower food sources (CPE, TOC, carbon to nitrogen ratio) and an observation of meiofaunal enrichment (i.e., higher average nematode abundance and ASV diversity; although statistically non-significant), but mechanisms behind these ecological changes (e.g., suspended material-surface fluxes, passive dispersal of fauna in the plume vs. active upward migration and “viability” of redeposited fauna) remain unresolved. We conclude that complex benthic pressure-response relationships associated with the PATII trial, combined with the high degree of natural spatial and temporal variability in abyssal meiofaunal communities and sedimentary parameters, complicates the quantitative assessment of deep-sea mining associated disturbances.