Description: The highly active subduction zone of southern Chile was the source region of the 1960 Valdivia megathrust earthquake (Mw= 9.5), the largest earthquake ever recorded.This region is currently under investigation by the multidisciplinary TIPTEQ (From the Incoming Plate to Mega-Thrust Earthquake Processes) project, which is studying the structure, state, and deformation of the subduction zone lithosphere. Over 90 days, from December 2004 to February 2005,TIPTEQ scientists on cruise S0181 of the German research vessel (R/V Sonne acquired a broad variety of geophysical and geological data in the research area offshore Chile between 35°S and 48°S (Figure 1).These data include active and passive source seismics, heat flow probing, magnetics, magnetotellurics for studying Earth conductivity, highresolution multibeam bathymetry, and sediment probes from gravity cores.

Description: The southern central Chilean margin at the site of the largest historically recorded earthquake in the Valdivia region, in 1960 (Mw = 9.5), is part of the 5000-km-long active subduction system whose geodynamic evolution is controversially debated and poorly understood. Covering the area between 36° and 40°S, the oceanic crust is segmented by prominent fracture zones. The offshore forearc and its onshore continuation show a complex image with segments of varying geophysical character, and several fault systems active during the past 24 m.y. In autumn 2001, the project SPOC was organized to study the Subduction Processes Off Chile, with a focus on the seismogenic coupling zone and the forearc. The acquired seismic data crossing the Chilean subduction system were gathered in a combined offshore-onshore survey and provide new insights into the lithospheric structure and evolution of active margins with insignificant frontal accretion.

Description: Seismic investigations across the convergent Sunda margin off Indonesia provide a detailed image of the crustal architecture of the Sunda plate boundary. The combined analysis and interpretation of wide-angle and reflection seismic data along two coincident profiles across the subduction zone are complemented by additional lines within the forearc domain, which yield some three-dimensional (3-D) constraints on the velocity-depth structure across the margin. A detailed cross section of the subduction zone is presented, which is confirmed by supplementary gravity modeling. The Sunda convergence zone is a prime example of an accretionary margin, where sediment accretion has led to the formation of a massive accretionary prism, with a total width of 〉110 km between the trench and the forearc basin. It is composed of a frontal wedge which documents ongoing accretion and a fossil part behind the present backstop structure which constitutes the outer high. Moderate seismic velocities derived from wide-angle modeling indicate a sedimentary composition of the outer high. The subducting oceanic slab is traced to a depth of almost 30 km underneath the accretionary prism. The adjacent forearc domain is characterized by a pronounced morphological basin which is underlain by a layer of increased seismic velocities and a shallow upper plate Moho at 16 km depth. We speculate that remnant fragments of oceanic crust might be involved in the formation of this oceanic-type crust found at the leading edge of the upper plate beneath the forearc basin.

Description: The deep structure of the south-central Costa Rican subduction zone has not been studied in great detail so far because large parts of the area are virtually inaccessible. We present a receiver function study along a transect of broadband seismometers through the northern flank of the Cordillera de Talamanca (south Costa Rica). Below Moho depths, the receiver functions image a dipping positive conversion signal. This is interpreted as the subducting Cocos Plate slab, compatible with the conversions in the individual receiver functions. In finite difference modeling, a dipping signal such as the one imaged can only be reproduced by a steeply (80°) dipping structure present at least until a depth of about 70–100 km; below this depth, the length of the slab cannot be determined because of possible scattering effects. The proposed position of the slab agrees with previous results from local seismicity, local earthquake tomography, and active seismic studies, while extending the slab location to greater depths and steeper dip angle. Along the trench, no marked change is observed in the receiver functions, suggesting that the steeply dipping slab continues until the northern flank of the Cordillera de Talamanca, in the transition region between the incoming seamount segment and Cocos Ridge. Considering the time predicted for the establishment of shallow angle underthrusting after the onset of ridge collision, the southern Costa Rican subduction zone may at present be undergoing a reconfiguration of subduction style, where the transition to shallow underthrusting may be underway but still incomplete.

Description: A joint interpretation of swath bathymetric, seismic refraction, wide-angle reflection, and multichannel seismic data was used to derive a detailed tomographic image of the Nazca-South America subduction zone system offshore southern Arauco peninsula, Chile at similar to 38 degrees S. Here, the trench basin is filled with up to 2.2 km of sediments, and the Mocha Fracture Zone (FZ) is obliquely subducting underneath the South American plate. The velocity model derived from the tomographic inversion consists of a similar to 7-km-thick oceanic crust and shows P wave velocities typical for mature fast spreading crust in the seaward section of the profile, with uppermost mantle velocities >8.4 km s(-1). In the trench-outer rise area, the top of incoming oceanic plate is pervasively fractured and likely hydrated as shown by extensional faults, horst-and-graben structures, and a reduction of both crustal and mantle velocities. These slow velocities are interpreted in terms of extensional bending-related faulting leading to fracturing and hydration in the upper part of the oceanic lithosphere. The incoming Mocha FZ coincides with an area of even slower velocities and thinning of the oceanic crust (10-15% thinning), suggesting that the incoming fracture zone may enhance the flux of chemically bound water into the subduction zone. Slow mantle velocities occur down to a maximum depth of 6-8 km into the upper mantle, where mantle temperatures are estimated to be 400-430 degrees C. In the overriding plate, the tomographic model reveals two prominent velocity transition zones characterized by steep lateral velocity gradients, resulting in a seismic segmentation of the marine fore arc. The margin is composed of three main domains: (1) a similar to 20 km wide frontal prism below the continental slope with Vp 〈= 3.5 km s(-1), (2) a similar to 50 km area with Vp = 4.5-5.5 km s(-1), interpreted as a paleoaccretionary complex, and (3) the seaward edge of the Paleozoic continental framework with Vp >= 6.0 km s(-1). Frontal prism velocities are noticeably lower than those found in the northern erosional Chile margin, confirming recent accretionary processes in south central Chile.

Description: A seismic wide‐angle and refraction experiment was conducted offshore of Nicaragua in the Middle American Trench to investigate the impact of bending‐related normal faulting on the seismic properties of the oceanic lithosphere prior to subduction. On the basis of the reflectivity pattern of multichannel seismic reflection (MCS) data it has been suggested that bending‐related faulting facilitates hydration and serpentinization of the incoming oceanic lithosphere. Seismic wide‐angle and refraction data were collected along a transect which extends from the outer rise region not yet affected by subduction into the trench northwest of the Nicoya Peninsula, where multibeam bathymetric data show prominent normal faults on the seaward trench slope. A tomographic joint inversion of seismic refraction and wide‐angle reflection data yield anomalously low seismic P wave velocities in the crust and uppermost mantle seaward of the trench axis. Crustal velocities are reduced by 0.2–0.5 km s−1 compared to normal mature oceanic crust. Seismic velocities of the uppermost mantle are 7.6–7.8 km s−1 and hence 5–7% lower than the typical velocity of mantle peridotite. These systematic changes in P wave velocity from the outer rise toward the trench axis indicate an evolutionary process in the subducting slab consistent with percolation of seawater through the faulted and fractured lithosphere and serpentinization of mantle peridotites. If hydration is indeed affecting the seismic properties of the mantle, serpentinization might be reaching 12–17% in the uppermost 3–4 km of the mantle, depending on the unknown degree of fracturing and its impact on the elastic properties of the subducting lithosphere.

Description: A seismic wide-angle section offshore Costa Rica is presented across the boundary between oceanic crust generated at the East Pacific rise (EPR) and at the Galápagos spreading center (GSC) as indicated by magnetic anomalies. This suture, where the Farallon plate broke up ∼23 Ma ago, is marked by pronounced velocity variations throughout the crust including a low-velocity body in the lower crust. This body is well constrained by refracted waves above the inversion zone and by strong PmP reflections from its lower boundary. The distinctness of this body and the local gravity field point to an igneous intrusion rather than serpentinized rock. Typical oceanic crust is found adjacent to the suture zone.

Description: We use seismic reflection and refraction data to determine crustal structure, to map a fore-arc basin containing 12 km of sediment, and to image the subduction thrust at 35 km depth. Seismic reflection megasequences within the basin are correlated with onshore geology: megasequence X, Late Cretaceous and Paleogene marine passive margin sediments; megasequence Y, a similar to 10,000 km(3) submarine landslide emplaced during subduction initiation at 22 Ma; and megasequence Z, a Neogene subduction margin megasequence. The Moho lies at 17 km beneath the basin center and at 35 km at the southern margin. Beneath the western basin margin, we interpret reflective units as deformed Gondwana fore-arc sediment that was thrust in Cretaceous time over oceanic crust 7 km thick. Raukumara Basin has normal faults at its western margin and is uplifted along its eastern and southern margins. Raukumara Basin represents a rigid fore-arc block > 150 km long, which contrasts with widespread faulting and large Neogene vertical axis rotations farther south. Taper of the western edge of allochthonous unit Y and westward thickening and downlap of immediately overlying strata suggest westward or northwestward paleoslope and emplacement direction rather than southwestward, as proposed for the correlative onshore allochthon. Spatial correlation between rock uplift of the eastern and southern basin margins with the intersection between Moho and subduction thrust leads us to suggest that crustal underplating is modulated by fore-arc crustal thickness. The trench slope has many small extensional faults and lacks coherent internal reflections, suggesting collapse of indurated rock, rather than accretion of > 1 km of sediment from the downgoing plate. The lack of volcanic intrusion east of the active arc, and stratigraphic evidence for the broadening of East Cape Ridge with time, suggests net fore-arc accretion since 22 Ma. We propose a cyclical fore-arc kinematic: rock moves down a subduction channel to near the base of the crust, where underplating drives rock uplift, oversteepens the trench slope, and causes collapse toward the trench and subduction channel. Cyclical rock particle paths led to persistent trench slope subsidence during net accretion. Existing global estimates of fore-arc loss are systematically too high because they assume vertical particle paths. Citation: Sutherland, R., et al. (2009), Reactivation of tectonics, crustal underplating, and uplift after 60 Myr of passive subsidence, Raukumara Basin, Hikurangi-Kermadec fore arc, New Zealand: Implications for global growth and recycling of continents, Tectonics, 28, TC5017, doi: 10.1029/2008TC002356.

Description: The Cascadia convergent margin is a first-order research target to study the impact of rapid sedimentation processes on the mechanics of frontal subduction zone accretion. The near-trench part of the accretionary prism offshore Washington is affected by strongly increased glacial age sedimentation and fan formation that led to an outstanding Quaternary growth rate with landward vergent thrust faulting that is rarely observed elsewhere in accretionary wedges. Multichannel seismic reflection data acquired on the ORWELL project allows us to study the structure and dynamics of the atypical frontal accretion processes. We performed a kinematical and mechanical analysis of the frontal accretion structures, and developed a dynamic Coulomb-wedge model for the landward-verging backthrust formation. Backthrusting results from heterogeneous diffuse strain accumulation in the mechanically heterogeneous Cascadia basin sediment succession entering the subduction zone, and strain partitioning along a midlevel detachment that is activated by gravitational loading caused by rapid glacial age sedimentation. These complex deformation processes cause the passive “upward” delamination of the upper turbidite beds from the basal pelagic carbonate section similar to triangle-zone formation and passive backthrust wedging in foreland thrust belts caused by rapid burial beneath syntectonic sediment deposits. The deformation mechanism at the tectonic front of the Cascadia margin is an immediate response to the strongly increased late Pleistocene sediment flux rather than to atypical physical boundary conditions as generally thought.