Description: The transient ice-sheet predictions are forced by multiple climate snapshots derived from a climate model set up with Late Pliocene boundary conditions, forced with different orbital forcing scenarios appropriate to two Marine Isotope Stages (MIS), MIS KM5c and K1.

Description: The Arctic cryosphere is changing and making significant contributions to 21st century sea level rise. The Pliocene epoch had similar CO2 levels to present and a warming comparable to model predictions for the end of this century, providing an opportunity to investigate the operation of Arctic climate in a warm world. The Late Pliocene has well documented climatic conditions. However, the state of the Arctic cryosphere remains partially constrained. Here, for the first time, we couple outputs from a Pliocene climate model with a thermodynamic iceberg model to simulate likely source regions for Ice Rafted Debris (IRD) found in the Nordic Seas from Marine Isotope Stage M2 to the mid Pliocene Warm Period (mPWP). We compare the fraction of melt given by the model scenarios with IRD data from four Ocean Drilling Program (ODP) sites within the Nordic Seas region. Marine sites 911A, 909C and 907A show a persistent occurrence of IRD that modeling results suggest is consistent with permanent ice on Svalbard. Our model results indicate that icebergs sourced from the east coast of Greenland do not reach the Nordic Seas sites during the warm late Pliocene, but instead travel south into the North Atlantic. Small amounts of IRD are found at Hole 642B in the Late Pliocene. Model results identify coastal Norway as the potential source, however this is inconsistent with current understanding of the Late Pliocene Scandinavian climate.

Description: The Pliocene epoch has great potential to improve our understanding of the long-term climatic and environmental consequences of an atmospheric CO2 concentration near ∼400 parts per million by volume. Here we present the large-scale features of Pliocene climate as simulated by a new ensemble of climate models of varying complexity and spatial resolution based on new reconstructions of boundary conditions (the Pliocene Model Intercomparison Project Phase 2; PlioMIP2). As a global annual average, modelled surface air temperatures increase by between 1.7 and 5.2 °C relative to the pre-industrial era with a multi-model mean value of 3.2 °C. Annual mean total precipitation rates increase by 7 % (range: 2 %–13 %). On average, surface air temperature (SAT) increases by 4.3 °C over land and 2.8 °C over the oceans. There is a clear pattern of polar amplification with warming polewards of 60°N and 60°S exceeding the global mean warming by a factor of 2.3. In the Atlantic and Pacific oceans, meridional temperature gradients are reduced, while tropical zonal gradients remain largely unchanged. There is a statistically significant relationship between a model's climate response associated with a doubling in CO2 (equilibrium climate sensitivity; ECS) and its simulated Pliocene surface temperature response. The mean ensemble Earth system response to a doubling of CO2 (including ice sheet feedbacks) is 67 % greater than ECS; this is larger than the increase of 47 % obtained from the PlioMIP1 ensemble. Proxy-derived estimates of Pliocene sea surface temperatures are used to assess model estimates of ECS and give an ECS range of 2.6–4.8°C. This result is in general accord with the ECS range presented by previous Intergovernmental Panel on Climate Change (IPCC) Assessment Reports.

Description: Understanding the dominant climate forcings in the Pliocene is crucial to assessing the usefulness of the Pliocene as an analogue for our warmer future. Here, we implement a novel yet simple linear factorisation method to assess the relative influence of CO2 forcing in seven models of the Pliocene Model Intercomparison Project Phase 2 (PlioMIP2) ensemble. Outputs are termed “FCO2” and show the fraction of Pliocene climate change driven by CO2. The accuracy of the FCO2 method is first assessed through comparison to an energy balance analysis previously used to assess drivers of surface air temperature in the PlioMIP1 ensemble. After this assessment, the FCO2 method is applied to achieve an understanding of the drivers of Pliocene sea surface temperature and precipitation for the first time. CO2 is found to be the most important forcing in the ensemble for Pliocene surface air temperature (global mean FCO2=0.56), sea surface temperature (global mean FCO2=0.56), and precipitation (global mean FCO2=0.51). The range between individual models is found to be consistent between these three climate variables, and the models generally show good agreement on the sign of the most important forcing. Our results provide the most spatially complete view of the drivers of Pliocene climate to date and have implications for both data–model comparison and the use of the Pliocene as an analogue for the future. That CO2 is found to be the most important forcing reinforces the Pliocene as a good palaeoclimate analogue, but the significant effect of non-CO2 forcing at a regional scale (e.g. orography and ice sheet forcing at high latitudes) reminds us that it is not perfect, and these additional influencing factors must not be overlooked. This comparison is further complicated when considering the Pliocene as a state in quasi-equilibrium with CO2 forcing compared to the transient warming being experienced at present.