Description: Identification of methane sources controlling hydrate distribution and concentrations in continental margins remains a major challenge in gas hydrate research. Lack of deep fluid samples and high quality regional scale seismic reflection data may lead to underestimation of the significance of fluid escape from subducting and compacting sediments in the global inventory of methane reaching the hydrate zone, the water column and the atmosphere. The distribution of concentrated hydrate zones in relation to focused fluid flow across the southern Hikurangi subduction margin was investigated using high quality, long offset (10 km streamer), pre-stack depth migrated multichannel seismic data. Analysis of low P wave velocity zones, bright-reverse polarity reflections and dim-amplitude anomalies reveals pathways for gas escape and zones of gas accumulation. The study shows the structural and stratigraphic settings of three main areas of concentrated hydrates: (1) the Opouawe Bank, dominated by focused periodic fluid input along thrust faults sustaining dynamic hydrate concentrations and gas chimneys development; (2) the frontal anticline, with a basal set of protothrusts controlling permeability for fluids from deeply buried and subducted sediments sustaining hydrate concentrations at the crest of the anticline; and (3) the Hikurangi Channel, with buried sand dominated channels hosting significant amounts of gas beneath the base of the hydrate zone. In sand dominated channels gas injection into the hydrate zone favors highly concentrated hydrate accumulations. The evolution of fluid expulsion controlling hydrate formation offshore southern Hikurangi is described in stages during which different methane sources (in situ, buried and thermogenic) have been dominant.

Description: Gas seepage from marine sediments has implications for understanding feedbacks between the global carbon reservoir, seabed ecology and climate change. Although the relationship between hydrates, gas chimneys and seafloor seepage is well established, the nature of fluid sources and plumbing mechanisms controlling fluid escape into the hydrate zone and up to the seafloor remain one of the least understood components of fluid migration systems. In this study we present the analysis of new three-dimensional high-resolution seismic data acquired to investigate fluid migration systems sustaining active seafloor seepage at Omakere Ridge, on the Hikurangi subduction margin, New Zealand. The analysis reveals at high resolution, complex overprinting fault structures (i.e. protothrusts, normal faults from flexural extension, and shallow (〈1 km) arrays of oblique shear structures) implicated in fluid migration within the gas hydrate stability zone in an area of 2x7 km. In addition to fluid migration systems sustaining seafloor seepage on both sides of a central thrust fault, the data show seismic evidence for sub-seafloor gas-rich fluid accumulation associated with proto-thrusts and extensional faults. In these latter systems fluid pressure dissipation through time has been favored, hindering the development of gas chimneys. We discuss the elements of the distinct fluid migration systems and the influence that a complex partitioning of stress may have on the evolution of fluid flow systems in active subduction margins.

Description: Recent years have seen a steady increase in gas hydrate-related research in New Zealand, driven by several large-scale projects and strong international collaboration. The Hikurangi Margin, east of New Zealand’s North Island, is the country’s premier gas hydrate province. Here, much of the research has been focused on processes surrounding methane seepage out of the sea floor and on geological conditions that are likely to promote the deposition of concentrated hydrate deposits. Studies into submarine erosion and landslides related to gas hydrate systems have also been a major focus in this province. In particular, flattened ridge tops and submarine mass wasting deposits have been investigated that appear to be related to the up-slope termination of gas hydrate stability. Research is also being carried out to characterise animal communities of the seabed where methane seepage occurs, in order to provide ecological risk assessments for drilling activities. Elsewhere on New Zealand’s continental margins research is also accelerating. Several “frontier” basins around New Zealand are currently being explored with respect to their potential for hosting attractive gas hydrate deposits. A primary focus is to identify and characterise key elements of favourable depositional environments, with a longer-term aim of gas hydrate exploration drilling.

Description: The imbricated frontal wedge of the central Hikurangi subduction margin is characteristic of wide (ca. 150 km), poorly drained and over pressured, low taper (not, vert, similar 4°) thrust systems associated with a relatively smooth subducting plate, a thick trench sedimentary sequence (not, vert, similar 3–4 km), weak basal décollement, and moderate convergence rate (not, vert, similar 40 mm/yr). New seismic reflection and multibeam bathymetric data are used to interpret the regional tectonic structures, and to establish the geological framework for gas hydrates and fluid seeps. We discuss the stratigraphy of the subducting and accreting sequences, characterize stratigraphically the location of the interplate décollement, and describe the deformation of the upper plate thrust wedge together with its cover sequence of Miocene to Recent shelf and slope basin sediments. We identify approximately the contact between an inner foundation of deforming Late Cretaceous and Paleogene rocks, in which widespread out-of-sequence thrusting occurs, and a 65–70 km-wide outer wedge of late Cenozoic accreted turbidites. Although part of a seamount ridge is presently subducting beneath the deformation front at the widest part of the margin, the morphology of the accretionary wedge indicates that frontal accretion there has been largely uninhibited for at least 1–2 Myr. This differs from the offshore Hawkes Bay sector of the margin to the north where a substantial seamount with up to 3 km of relief has been subducted beneath the lower margin, resulting in uplift and complex deformation of the lower slope, and a narrow (10–20 km) active frontal wedge. Five areas with multiple fluid seep sites, referred to informally as Wairarapa, Uruti Ridge, Omakere Ridge, Rock Garden, and Builders Pencil, typically lie in 700–1200 m water depth on the crests of thrust-faulted, anticlinal ridges along the mid-slope. Uruti Ridge sites also lie in close proximity to the eastern end of a major strike-slip fault. Rock Garden sites lie directly above a subducting seamount. Structural permeability is inferred to be important at all levels of the thrust system. There is a clear relationship between the seeps and major seaward-vergent thrust faults, near the outer edge of the deforming Cretaceous and Paleogene inner foundation rocks. This indicates that thrust faults are primary fluid conduits and that poor permeability of the Cretaceous and Paleogene inner foundation focuses fluid flow to its outer edge. The sources of fluids expelling at active seep sites along the middle slope may include the inner parts of the thrust wedge and subducting sediments below the décollement. Within anticlinal ridges beneath the active seep sites there is a conspicuous break in the bottom simulating reflector (BSR), and commonly a seismically-resolvable shallow fault network through which fluids and gas percolate to the seafloor. No active fluid venting has yet been recognized over the frontal accretionary wedge, but the presence of a widespread BSR, an extensive protothrust zone (〉 200 km by 20 km) in the Hikurangi Trough, and two unconfirmed sites of possible previous fluid expulsion, suggest that the frontal wedge could be actively dewatering. There are presently no constraints on the relative fluid flux between the frontal wedge and the active mid-slope fluid seeps. Article Outline

Description: Hydrogeological processes influence the morphology, mechanical behavior, and evolution of subduction margins. Fluid supply, release, migration, and drainage control fluid pressure and collectively govern the stress state, which varies between accretionary and nonaccretionary systems. We compiled over a decade of published and unpublished acoustic data sets and seafloor observations to analyze the distribution of focused fluid expulsion along the Hikurangi margin, New Zealand. The spatial coverage and quality of our data are exceptional for subduction margins globally. We found that focused fluid seepage is widespread and varies south to north with changes in subduction setting, including: wedge morphology, convergence rate, seafloor roughness, and sediment thickness on the incoming Pacific plate. Overall, focused seepage manifests most commonly above the deforming backstop, is common on thrust ridges, and is largely absent from the frontal wedge despite ubiquitous hydrate occurrences. Focused seepage distribution may reflect spatial differences in shallow permeability architecture, while diffusive fluid flow and seepage at scales below detection limits are also likely. From the spatial coincidence of fluids with major thrust faults that disrupt gas hydrate stability, we surmise that focused seepage distribution may also reflect deeper drainage of the forearc, with implications for pore-pressure regime, fault mechanics, and critical wedge stability and morphology. Because a range of subduction styles is represented by 800 km of along-strike variability, our results may have implications for understanding subduction fluid flow and seepage globally.

Description: Slow slip events (SSEs) accommodate a significant proportion of tectonic plate motion at subduction zones, yet little is known about the faults that actually host them. The shallow depth (〈2 km) of well-documented SSEs at the Hikurangi subduction zone offshore New Zealand offers a unique opportunity to link geophysical imaging of the subduction zone with direct access to incoming material that represents the megathrust fault rocks hosting slow slip. Two recent International Ocean Discovery Program Expeditions sampled this incoming material before it is entrained immediately down-dip along the shallow plate interface. Drilling results, tied to regional seismic reflection images, reveal heterogeneous lithologies with highly variable physical properties entering the SSE source region. These observations suggest that SSEs and associated slow earthquake phenomena are promoted by lithological, mechanical, and frictional heterogeneity within the fault zone, enhanced by geometric complexity associated with subduction of rough crust.

Description: The Hikurangi Subduction Margin was the recent focus of two IODP expeditions seeking to explore the cause and effect of slow slip earthquake generation at this plate boundary. Characterising the stress field across the Hikurangi Subduction Margin is a crucial element of to understanding the relationship between the contemporary in-situ stress state, active and inactive structures along the subduction front, and fluid pressures and the observed spatial variation in subduction behaviour. Existing stress observations rely on earthquake focal mechanisms and limited onshore borehole data from industry wells on the overriding plate. Reported pore pressures within the over-riding plate are often close to vertical stress magnitudes at shallow depths. Variability of in-situ stress orientations occur along strike of the subduction trench, with a subduction trench parallel SHmax in the south transitioning to a plate motion parallel, trench-oblique SHmax further north. This spatially correlates with observed changes in subduction interface coupling and earthquake behaviour. Here we present new stress field orientation data acquired from resistivity image logging carried out in IODP Expedition 372 using the logging while drilling GeoVision Resistivity tool. We report Shmin orientations from borehole breakout observations of N-S at Site U1518 near the deformation front, and NW-SE from Site U1519 within the upper plate. These data represent the first estimates of stress field orientation (from drilling data) in the outer forarc, near the deformation front of the Hikurangi Margin, an area characterised by shallow slow slip.