Description: In April and May 1996, a geophysical study of the Cascadia continental margin off Oregon and Washington was carried out aboard the German RV Sonne as a cooperative experiment between GEOMAR, the USGS and COAS. Offshore central Oregon, which is the subject of this study, the experiment involved the collection of wide-angle refraction and reflection data along three profiles across the continental margin using ocean-bottom seismometers (OBS) and hydrophones (OBH) as well as land recorders. Two-dimensional modelling of the travel times provides a detailed velocity structure beneath these profiles. The subducting oceanic crust of the Juan de Fuca plate can be traced from the trench to its position some 10 km landward of the coastline. At the coastline, the Moho has a depth of 30 km. The dip of the plate changes from 1.5° westward of the trench to about 6.5° below the accretionary complex and to about 16° further eastward below the coast. The backstop forming western edge of the Siletz terrane, an oceanic plateau that was accreted to North America about 50 Ma ago, is well defined by the observations. It is located about 60 km to the east of the deformation front and has a seaward dip of 40°. At its seaward edge, the base of the Siletz terrane seems to be in contact with the subducting oceanic crust implying that sediments are unlikely to be subducted to greater depths. The upper oceanic crust is thinner to the east of this contact than to the west. At depths greater than 18 km, the top of the oceanic crust is the origin of pre-critical reflections observable in several land recordings and in the data of one ocean bottom instrument. These reflections are most likely caused by fluids that are released from the oceanic crust by metamorphic facies transition.

Description: High-resolution seismic experiments, employing arrays of closely spaced, four-component ocean-bottom seismic recorders, were conducted at a site off western Svalbard and a site on the northern margin of the Storegga slide, off Norway to investigate how well seismic data can be used to determine the concentration of methane hydrate beneath the seabed. Data from P-waves and from S-waves generated by P–S conversion on reflection were inverted for P- and S-wave velocity (Vp and Vs), using 3D travel-time tomography, 2D ray-tracing inversion and 1D waveform inversion. At the NW Svalbard site, positive Vp anomalies above a sea-bottom-simulating reflector (BSR) indicate the presence of gas hydrate. A zone containing free gas up to 150-m thick, lying immediately beneath the BSR, is indicated by a large reduction in Vp without significant reduction in Vs. At the Storegga site, the lateral and vertical variation in Vp and Vs and the variation in amplitude and polarity of reflectors indicate a heterogeneous distribution of hydrate that is related to a stratigraphically mediated distribution of free gas beneath the BSR. Derivation of hydrate content from Vp and Vs was evaluated, using different models for how hydrate affects the seismic properties of the sediment host and different approaches for estimating the background-velocity of the sediment host. The error in the average Vp of an interval of 20-m thickness is about 2.5%, at 95% confidence, and yields a resolution of hydrate concentration of about 3%, if hydrate forms a connected framework, or about 7%, if it is both pore-filling and framework-forming. At NW Svalbard, in a zone about 90-m thick above the BSR, a Biot-theory-based method predicts hydrate concentrations of up to 11% of pore space, and an effective-medium-based method predicts concentrations of up to 6%, if hydrate forms a connected framework, or 12%, if hydrate is both pore-filling and framework-forming. At Storegga, hydrate concentrations of up to 10% or 20% were predicted, depending on the hydrate model, in a zone about 120-m thick above a BSR. With seismic techniques alone, we can only estimate with any confidence the average hydrate content of broad intervals containing more than one layer, not only because of the uncertainty in the layer-by-layer variation in lithology, but also because of the negative correlation in the errors of estimation of velocity between adjacent layers. In this investigation, an interval of about 20-m thickness (equivalent to between 2 and 5 layers in the model used for waveform inversion) was the smallest within which one could sensibly estimate the hydrate content. If lithological layering much thinner than 20-m thickness controls hydrate content, then hydrate concentrations within layers could significantly exceed or fall below the average values derived from seismic data.

Description: We describe the deep structure of the south Colombian–northern Ecuador convergent margin using travel time inversion of wide-angle seismic data recently collected offshore. The margin appears segmented into three contrasting zones. In the North Zone, affected by four great subduction earthquakes during the 20th century, normal oceanic crust subducts beneath the oceanic Cretaceous substratum of the margin underlined by seismic velocities as high as 6.0–6.5 km/s. In the Central Zone the subducting oceanic crust is over-thickened beneath the Carnegie Ridge. A steeper slope and a well-developed, high velocity, Cretaceous oceanic basement characterizes the margin wedge. This area coincides with a gap in significant subduction earthquake activity. In the South Zone, the subducting oceanic crust is normal. The fore-arc is characterized by large sedimentary basins suggesting significant subsidence. Velocities in the margin wedge are significantly lower and denote a different nature or a higher degree of fracturing. Even if the distance between the three profiles exceeds 150 km, the structural segmentation obtained along the Ecuadorian margin correlates well with the distribution of seismic activity and the neotectonic zonation.

Description: Marine seismic wide-angle data acquisition and earthquake seismology observations are at the verge of a quantum leap in data quality and density. Advances in micro-electronic technology facilitates the construction of instrumcnts that enable large data volumes to be collected and that are small and cheap enough so that large numbers can be built and operated economically. The main improvements are a dramatic decrease of power consumption ( 〈 250 m W) and increase in clock stability ( 〈 0.05 ppm}. Several scenarios for future experiments arc discussed in this contrihution

Description: Oceanic island arcs are sites of high magma production and contribute to the formation of continental crust. Geophysical studies may provide information on the configuration and composition of island arc crust, however, to date only few seismic profiles exist across active island arcs, limiting our knowledge on the deep structure and processes related to the production of arc crust. We acquired active-source wide-angle seismic data crossing the central Lesser Antilles island arc north of Dominica where the oceanic Tiburon Ridge subducts obliquely beneath the forearc. A combined analysis of wide-angle seismics and pre-stack depth migrated reflection data images the complex structure of the backstop and its segmentation into two individual ridges, suggesting an intricate relation between subducted basement relief and forearc deformation. Tomographic imaging reveals three distinct layers composing the island arc crust. A three kilometer thick upper crust of volcanogenic sedimentary rocks and volcaniclastics is underlain by intermediate to felsic middle crust and plutonic lower crust. The island arc crust may comprise inherited elements of oceanic plateau material contributing to the observed crustal thickness. A high density ultramafic cumulates layer is not detected, which is an important observation for models of continental crust formation. The upper plate Moho is found at a depth of 24 km below the sea floor. Upper mantle velocities are close to the global average. Our study provides important information on the composition of the island arc crust and its deep structure, ranging from intermediate to felsic and mafic conditions. In this study we model the deep structure of the Lesser Antilles Island Arc. We use a hybrid analysis of refraction and reflection seismic data. We image the complex structure of two ridges forming the backstop. Island arc crust composition ranges from intermediate to felsic to mafic conditions. We discuss the formation of island arc and continental crust.

Description: The 27 February, 2010 Maule earthquake (Mw=8.8) ruptured ~400 km of the Nazca-South America plate boundary and caused hundreds of fatalities and billions of dollars in material losses. Here we present constraints on the fore-arc structure and subduction zone of the rupture area derived from seismic refraction and wide-angle data. The results show a wedge shaped body ~40 km wide with typical sedimentary velocities interpreted as a frontal accretionary prism (FAP). Landward of the imaged FAP, the velocity model shows an abrupt velocity-contrast, suggesting a lithological change which is interpreted as the contact between the FAP and the paleo accretionary prism (backstop). The backstop location is coincident with the seaward limit of the aftershocks, defining the updip limit of the co-seismic rupture and seismogenic zone. Furthermore, the seaward limit of the aftershocks coincides with the location of the shelf break in the entire earthquake rupture area (33°S–38.5°S), which is interpreted as the location of the backstop along the margin. Published seismic profiles at the northern and southern limit of the rupture area also show the presence of a strong horizontal velocity gradient seismic backstop at a distance of ~30 km from the deformation front. The seismic wide-angle reflections from the top of the subducting oceanic crust constrain the location of the plate boundary offshore, dipping at ~10°. The projection of the epicenter of the Maule earthquake onto our derived interplate boundary yielded a hypocenter around 20 km depth, this implies that this earthquake nucleated somewhere in the middle of the seismogenic zone, neither at its updip nor at its downdip limit.

Description: Following the devastating 2004 tsunami that hit the southwestern coast of Thailand, the need for detailed bathymetric data of the Andaman Sea outer shelf became evident in order to better predict tsunami wave propagation and coastal impact. Bathymetric data and subbottom profiler records covering the outer shelf and upper slope of the Thai exclusive economic zone (EEZ) were collected onboard Thai RV Chakratong Tongyai in 2006 and 2007. The data cover an area of approximately 3000 km2 between 500 and 1600 m water depth. The soundings allowed generating a final bathymetric grid with 50 m grid cell spacing. The outer shelf is rather smooth and slightly inclined southward, while the upper slope is strongly dissected by gullies. Several previously unknown features are identified including mud-domes, pockmarks, three large plateaus surrounded by moats, gas-charged sediment on subbottom profiler records, and only few indications for small submarine landslides on the upper slope. The largest of these possibly translational submarine landslides involved 2.2×107 m3 of sediment. This slide would have generated a tsunami wave of less than 0.12 m wave height. Considering the entire data, there is no evidence that landslides have been the source of tsunami waves in recent geological time. Highlights

Description: A seismic refraction and reflection tomography experiment was performed across the igneous province east of Svalbard which is a part of the Cretaceous High Arctic Large Igneous Province. Seismic travel times from 12 ocean bottom seismometers/hydrophones deployed along a 170 km line are inverted to produce smooth 2D images of the crustal P-wave velocity and geometry of the acoustic basement and Moho. The inversion of travel times was complemented by forward elastic wave propagation modeling. Integration with onshore geology as well as multichannel seismic, magnetic and gravity data have provide additional constraints used in the geological interpretation. The seismic P-wave velocity increases rapidly with depth, starting with 3 km/s at the sea floor and reaching 5.5 km/s at the bottom of the upper sedimentary layer. The thickness of this layer increases eastward from 2 km to 3.5 km. On average the P-wave velocity in the crystalline crust increases with depth from 5.5 km/s to 6.8 km/s. The crustal thickness is typical for continental shelf regions (30–34 km). Finger-shaped high-velocity anomalies, one reaching 12% and two of 4–6% velocity perturbation, are obtained. These velocity anomalies are concomitant with Lower Cretaceous basaltic lava flows and sills in the shallow sediments and elongated gravity and magnetic highs, traced towards the northern Barents Sea passive continental margin. We interpret the obtained velocity anomalies as signatures of dikes emplaced in the basement during breakup and subsequent spreading in the Arctic Amerasia Basin.

Description: This work focuses on the analysis of a unique set of seismological data recorded by two temporary networks of seismometers deployed onshore and offshore in the Central Lesser Antilles Island Arc from Martinique to Guadeloupe islands. During the whole recording period, extending from January to the end of August 2007, more than 1300 local seismic events were detected in this area. A subset of 769 earthquakes was located precisely by using HypoEllipse. We also computed focal mechanisms using P-wave polarities of the best azimuthally constrained earthquakes. We detected earthquakes beneath the Caribbean forearc and in the Atlantic oceanic plate as well. At depth seismicity delineates the Wadati–Benioff Zone down to 170 km depth. The main seismic activity is concentrated in the lower crust and in the mantle wedge, close to the island arc beneath an inner forearc domain in comparison to an outer forearc domain where little seismicity is observed. We propose that the difference of the seismicity beneath the inner and the outer forearc is related to a difference of crustal structure between the inner forearc interpreted as a dense, thick and rigid crustal block and the lighter and more flexible outer forearc. Seismicity is enhanced beneath the inner forearc because it likely increases the vertical stress applied to the subducting plate.