Description: Abstract:Based on a sediment vibro corer, a tool for the sampling of sub-seafloor groundwater aquifershas been developed and successfully deployed in a coastal area of the western Baltic. Thedevice was designed to obtain pure groundwater samples from coarse sediments to be used fortracer investigations and CFC age dating.Operated from a medium size research vessel, a well pipe tipped with a filter segment isvibrated into the sediment down to the aquifer. Groundwater entering the filter is pumped tothe ship by a conventional submersible pump situated in the well's filter tip. Groundwater iscontinuously analysed on board for O2, salinity, pH, Eh and temperature, prior to sampling forCFC and radioisotope analysis. All parametres indicate that pure groundwater had beenobtained.CFC concentrations are very low suggesting that the groundwater of this shallow sub-seaflooraquifer recharged prior to 1950. This finding is in accordance with other hydrogeologicalevidence that this aquifer, located only 4-5 metres below the seafloor, is connected to fairlydeep confined sandy aquifers on land of Pleistocene or Miocene age.Applying the method described, it is possible to obtain sufficient sample volumes foranalyses of natural groundwater tracers such as radon-222 and CFCs which can beused to trace submarine groundwater discharge as well as the origin ofgroundwater in such environments.Keywords: submarine springs, groundwater, pockmark, submarine well, CFC, radon

Description: Logs collected while drilling measured density in situ, through the accretionary prism and decollement zone of the northern Barbados Ridge. Consolidation tests relate void ratio (derived from density) to effective stress and predict a fluid pressure profile, assuming that the upper 100 m of the prism is at a hydrostatic pressure gradient. The calculated fluid pressure curve rises to 〉90% of lithostatic below thrusts in the prism, presumably due to the increase in overburden and lateral tectonic loading. Thin (0.5–2.0 m) intervals of anomalously low density and resistivity in the logs through the basal decollement zone suggest dilation and perhaps hydrofracturing. A peak in hydraulic head in the upper half of the decollement zone requires lateral influx of fluid, a conclusion consistent with previous geochemical studies. Although the calculated fluid-pressure profile is model dependent, its inherent character ties to major structural features.

Description: Methane seeps in shallow waters in the northern Kattegat off the Danish coast form spectacular submarine landscapes - the 'bubbling reefs' - due to carbonate-cemented sandstone structures which are colonized by brightly coloured animals and plants. These structures may be 100 m2 in area and consist of pavements, complex formations of overlying slab-type layers, and pillars up to 4 m high. The carbonate cement (high-magnesium calcite, dolomite or aragonite) is 13C-depleted, indicating that it originated as a result of microbial methane oxidation. It is believed that the cementation occurred in the subsurface and that the rocks were exposed by subsequent erosion of the surrounding unconsolidated sediment. The formations are interspersed with gas vents that intermittently release gas, primarily methane, at up to 25 1 h-' The methane most likely originated from the microbial decomposition of plant material eposited during the Eemian and early Weichselian periods, i.e. l00 000 to 125 000 years B.P. Aerobic methane oxidation in the sediment was restricted Lo the upper 4 cm in muddy sand and to the upper 13 cm In coarse sand. Maximum aerobic methane oxidation rates ranged from 4.8 to 45.6 pm01 dm-3 d". The rock surfaces and epifauna around the seeps were also sites of methane-oxidizing activity. Integrated sulphate reduction rates for the upper 10 cm of muddy sand gave 4.2 to 26.6 mm01 m-2 d-' These rates are higher than those previously reported from similar water depths in the Kattegat but did not relate to the sediment methane content. Since gas venting occurs over several km2 of the sea floor in the Kattegat it is likely to make a significant local contribution to the cycling of elements in the sediment and the water column. The rocks support a diverse ecosystem ranging from bacteria to macroalgae and anthozoans. Many animals live within the rocks in holes bored by sponges, polychaetes and bivalves. Stable carbon isotope composition (6'") of tissues of invertebrates from the rocks were in the range -17 to -24 'A, indicating that methane-derived carbon makes little direct contribution to their nutrition. Within the sediments surrounding the seeps there is a poor metazoan fauna, in terms of abundance, diversity and biomass. This may be a result of toxicity due to hydrogen sulphide input from the gas.

Description: Logs collected while drilling measured density in situ, through the accretionary prism and decollement zone of the northern Barbados Ridge. Consolidation tests relate void ratio (derived from density) to effective stress and predict a fluid pressure profile, assuming that the upper 100 m of the prism is at a hydrostatic pressure gradient. The calculated fluid pressure curve rises to 〉90% of lithostatic below thrusts in the prism, presumably due to the increase in overburden and lateral tectonic loading. Thin (0.5–2.0 m) intervals of anomalously low density and resistivity in the logs through the basal decollement zone suggest dilation and perhaps hydrofracturing. A peak in hydraulic head in the upper half of the decollement zone requires lateral influx of fluid, a conclusion consistent with previous geochemical studies. Although the calculated fluid-pressure profile is model dependent, its inherent character ties to major structural features.

Description: The interrelation between deformation styles and behavior of fluids in accretionary prisms is under debate, particularly the possibility that overpressuring within the basal decollement may enable mechanical decoupling of the prism from the subducting material. Anisotropy of magnetic susceptibility (AMS) data from sediments spanning the basal decollement of the Barbados accretionary prism show a striking progression across this structure that strongly supports the hypothesis that it is markedly overpressured. In the accretionary prism, above the decollement, the minimum AMS axes are subhorizontal and oriented nearly east-west, whereas the maximum AMS axes are oriented nearly north-south and shallowly inclined. At the top of the decollement, the minimum AMS axes orientations abruptly change to nearly vertical; this orientation is maintained throughout the decollement and in the underthrust sediments below. The AMS orientations in the prism sediments above the decollement are consistent with lateral shortening due to regional tectonic stress, as the minimum axes generally parallel the convergence vector of the subducting South American plate and the maximum axes are trench-parallel. Because the orientations of the AMS axes in deformed sediments usually parallel the orientations of the principal strains, the AMS results indicate that the incremental strain state in the Barbados prism is one dominated by subhorizontal shortening. In contrast, the AMS axes within and below the decollement are consistent with a strain state dominated by vertical shortening (compaction). This abrupt change in AMS orientations at the top of the decollement at Site 948 is a direct manifestation of mechanical decoupling of the off-scraped prism sediments from the underthrust sediments. The decoupling horizon occurs at the top of the decollement zone, coinciding with the location of flowing, high-pressure fluids.