GLORIA

GEOMAR Library Ocean Research Information Access

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
Document type
Years
  • 1
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Sedimentology 41 (1994), S. 0 
    ISSN: 1365-3091
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences
    Notes: Subaqueous tuff deposits within the lower Miocene Lospe Formation of the Santa Maria Basin, California, are up to 20 m thick and were deposited by high density turbidity flows after large volumes of ash were supplied to the basin and remobilized. Tuff units in the Lospe Formation include a lower lithofacies assemblage of planar bedded tuff that grades upward into massive tuff, which in turn is overlain by an upper lithofacies assemblage of alternating thin bedded, coarse grained tuff beds and tuffaceous mudstone. The planar bedded tuff ranges from 0.3 to 3 m thick and contains 1-8 cm thick beds that exhibit inverse grading, and low angle and planar laminations. The overlying massive tuff ranges from 1 to 10 m thick and includes large intraclasts of pumiceous tuff and stringers of pumice grains aligned parallel to bedding. The upper lithofacies assemblage of thin bedded tuff ranges from 0.4 to 3 m thick; individual beds are 6-30 cm thick and display planar laminae and dewatering structures. Pumice is generally concentrated in the upper halves of beds in the thin bedded tuff interval.The association of sedimentary structures combined with semi-quantitative analysis for dispersive and hydraulic equivalence of bubble-wall vitric shards and pumice grains reveals that particles in the planar bedded lithofacies are in dispersive, not settling, equivalence. This suggests deposition under dispersive pressures in a tractive flow. Grains in the overlying massive tuff are more closely in settling equivalence as opposed to dispersive equivalence, which suggests rapid deposition from a suspended sediment load. The set of lithofacies that comprises the lower lithofacies assemblage of each of the Lospe Formation tuff units is analogous to those of traction carpets and subsequent suspension sedimentation deposits often attributed to high density turbidity flows. Grain distributions in the upper thin bedded lithofacies do not reveal a clear relation for dispersive or settling equivalence. This information, together with the association of sedimentary features in the thin bedded lithofacies, including dewatering structures, suggests a combination of tractive and liquefied flows.Absence of evidence for elevated emplacement temperatures (e.g. eutaxitic texture or shattered crystàls) suggests emplacement of the Lospe Formation tuff deposits in a cold state closely following pyroclastic eruptions. The tuff deposits are not only a result of primary volcanic processes which supplied the detritus, but also of processes which involved remobilization of unconsolidated ash as subaqueous sediment gravity flows. These deposits provide an opportunity to study the sedimentation processes that may occur during subaqueous volcaniclastic flows and demonstrate similarities with existing models for sediment gravity flow processes.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1432-0967
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences
    Notes: Abstract The early miocene Tecuya volcanic center in the southern San Joaquin basin of California consists of flows and tuffs of basalt and rhyolite that erupted, closely spaced in time, in both submarine and subaerial conditions. The rhyolites are overlain by the basalts and constitute approximately 45% of a total of at least 180 km3 of the Tecuya volcanic rocks. The basalts have ε Nd(t) values of +2 to +6 and (87Sr/86Sr)i values between 0.7035 and 0.7052. These rocks show LREE enrichment [(La/Yb)N =2.4–5.5; La=28–150 times chondrite] and higher Th/U, Th/Ta, Rb/Ta, Ba/Ta, Cs/Rb but lower K/Rb ratios than MORB. Combined major- and trace-element, and Sr−Nd isotopic data suggest the involvement of subcontinental lithosphere, depleted upper mantle source (MORB), and local continental crust in the basalt petrogenesis. ε Nd(t) values in rhyolites vary from +1.5 to +3.7 while (87Sr/86Sr)i ratios range from 0.7051 to 0.7064. The rhyolites display LREE enrichment [(La/Yb)N=10; La=100 times chondrite] along with a distinct negative Eu anomaly (Eu/Eu*=0.75) and depletion of Ti and P. Mixing relations in (87/86Sr)i − ε Nd(t) space among basalts, rhyolites, and local continental crust indicate that the Tecuya rhyolites were produced by assimilation of variable amounts of continental crust by MORB-related magmas and subcontinental lithosphere-derived melts. This conclusion is supported by the synchroneity of Tecuya volcanism at 22 Ma with interaction of a segment of the East Pacific Rise along the southern California margin. The Tecuya volcanic rocks thus provide an example for the generation of rhyolitic melts owing to crustal assimilation by basaltic melts during mid-oceanic ridge-induced magmatism along a continental margin.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...