Description: This study shows that macrofaunal irrigation traits constitute a valuable complement to sediment reworking traits in estimating macrofaunal impact on nutrient fluxes across the sediment-water interface. We correlated density, biomass, community bioturbation potential (BPc, an index based on reworking traits, body mass and density) and community irrigation potential (IPc, an index based on irrigation traits, body mass and density) with nitrite, nitrate, ammonium, silicate and phosphate flux data under different environmental conditions. Generalized linear models performed best with a combination of environmental conditions and irrigation trait-based indices. This was not only a direct effect of the irrigation traits, but also of the scaling factor 0.75 employed in IPc to infer metabolic activity from body mass. Accordingly, predictive models of nutrient flux across the sediment-water interface will profit greatly from incorporating macrofaunal irrigation behaviour by means of trait-based indices.

Description: Macrofaunal sediment reworking activity is a key driver of ecosystem functioning in marine systems. So far sediment reworking rates can only accurately be assessed by measurements as inference from community parameters is limited. In this case study we test the applicability of 2-D optical florescent sediment profile imaging (f-SPI) on multi corer type incubation cylinders. f-SPI has to date been applied to flat-surfaced (i.e. rectangular) cores only, while multi corer type incubation cylinders were analyzed by the spatially low resolved and invasive slicing technique. Here we apply both methods to cylindrical sediment cores (10 cm diameter). Cores were taken from by two common communities (i.e. Nucula-community and Amphiura-community) in the southern German Bight. Both f-SPI and the slicing technique showed similar vertical luminophore profiles. However the slicing technique found no significant differences between the two communities, whereas f-SPI showed significant differences for all investigated sediment reworking parameters: sediment reworking rate, non-locality index, mean weighted luminophore depth, and the maximal luminophore depth. Consequently, this may lead to different conclusions about the sediment reworking behaviors of the two communities. Likely the slicing method failed to detect significant differences between the Nucula- and Amphiura-community, owing to insufficient spatial accuracy. The f-SPI method, on the other hand, did not capture the full extent of maximal sediment reworking depth due to wall-effects. We conclude that both methods have specific drawbacks and advantages. While slicing is preferable when focusing on the absolute maximal sediment reworking depth especially with predominantly sessile communities, f-SPI is better suited to capture general sediment reworking patterns of most other communities. We demonstrate further that the bias, which is introduced by the distortion effect on imaging due to optical perspective and cylinder wall curvature of rounded cylinders using f-SPI, is negligible. Accordingly our results indicate that the distortion effects by curvature of the rounded cylinder walls will not cause underestimations of sediment reworking parameters in the f-SPI approach. Consequently f-SPI is suitable for the investigation of sediment reworking in natural communities by means of multi corer type samples.

Description: Owing to its extremely long life span and occurrence in the entire North Atlantic, the Arctic boreal Arctica islandica has become of particular significance for monitoring the environment, because information on past environmental conditions is archived in morphological and biogeochemical properties of the calcareous shell. To evaluate whether such properties are comparable between different localities, shell and soft body morphometry of six A. islandica populations, Norwegian Coast, Kattegat, Kiel Bay (Baltic), White Sea, German Bight (North Sea), and off NE Iceland, were compared. Discriminant analysis indicated distinct differences between populations, albeit not related to geographical distance, but more likely to local hydrography, bottom morphology, and food regime.

Description: Understanding past seasonal temperature variability in the ocean is essential to evaluate the effects of future climate change on marine ecosystems. Here, we estimate seasonal water temperature amplitudes from stable oxygen isotope (δ18Oshell) values of fossil shells of Arctica islandica (assuming δ18Owater = + 0.9 ± 0.1‰ V-SMOW). Specimens were collected from three Pleistocene successions (Emilian and Sicilian substages of the Calabrian) in Central and Southern Italy (i.e., Rome, Lecce and Sicily). Biostratigraphic analyses from Rome Quarry deposits indicate an age between 1.6 and 1.2 Ma, whereas Sicily and Lecce successions are slightly more recent (between 1.1 and 0.62 Ma). Prior to carbonate geochemical analysis, we checked the shells for potential diagenetic alterations (e.g., from aragonite to calcite) using confocal Raman microscopy. δ18Oshell transects indicate an annual temperature amplitude of about 3 °C during the Early Pleistocene. This is in sharp contrast to reconstructions based on faunal assemblages, according to which the simultaneous occurrence of boreal and warm-water species in the Calabrian Mediterranean Sea suggests a much higher seasonality (ca. 10 °C). The low seasonality and the relatively cold water (9–10 °C) indicate the outcrops represent colder climatic conditions compared to modern times, and suggest the occurrence of a maximum glacial phase.