Description: We present geochemical data collected from volcanic ash-bearing sediments on the upper slope of the northern Hikurangi margin during the RV SONNE SO247 expedition in 2016. Gravity coring and seafloor drilling with the MARUM-MeBo200 allowed for collection of sediments down to 105 meters below seafloor (mbsf). Release of dissolved Sr2+with isotopic composition enriched in 86Sr (87Sr/86Sr minimum = 0.708461 at 83.5 mbsf) is indicative of ash alteration. This reaction releases other cations in the 30-70 mbsf depth interval as reflected by maxima in pore-water Ca2+and Ba2+concentrations. In addition, we posit that Fe(III) in volcanogenic glass serves as an electron acceptor for methane oxidation, a reaction that releases Fe2+measured in the pore fluids to a maximum concentration of 184 μM. Several lines of evidence support our proposed coupling of ash alteration with Fe-mediated anaerobic oxidation of methane (Fe-AOM) beneath the sulfate-methane transition (SMT), which lies at ∼7 mbsf at this site. In the ∼30-70 mbsf interval, we observe a concurrent increase in Fe2+and a depletion of CH4with a well-defined decrease in δ13C-CH4values indicative of microbial fractionation of carbon. The negative excursions in δ13C values of both DIC and CH4are similar to that observed by sulfate-driven AOM at low SO2−4concentrations, and can only be explained by the microbially-mediated carbon isotope equilibration between CH4and DIC. Mass balance considerations reveal that the iron cycled through the coupled ash alteration and AOM reactions is consumed as authigenic Fe-bearing minerals. This iron sink term derived from the mass balance is consistent with the amount of iron present as carbonate minerals, as estimated from sequential extraction analyses. Using a numerical modeling approach we estimate the rate of Fe-AOM to be on the order of 0.4μmol cm−2yr−1, which accounts for ∼12% of total CH4removal in the sediments. Although not without uncertainties, the results presented reveal that Fe-AOM in ash-bearing sediments is significantly lower than the sulfate-driven CH4consumption, which at this site is 3.0μmol cm−2yr−1. We highlight that Fe(III) in ash can potentially serve as an electron acceptor for methane oxidation in sulfate-depleted settings. This is relevant to our understanding of C-Fe cycling in the methanic zone that typically underlies the SMT and could be important in supporting the deep biosphere.

Description: The Argentina Continental Margin represents a unique geologic setting to study interactions between bottom currents and sediment deposition as well as their impact on (bio)geochemical processes, particularly the cycling of iron (Fe). Our aim was to determine (1) how different depositional conditions control post-depositional (bio)geochemical processes and (2) how stable Fe isotopes (δ56Fe) of pore water and solid phases are affected accordingly. Furthermore, we (3) evaluated the applicability of δ56Fe of solid Fe pools as a proxy to trace past diagenetic alteration of Fe, which might be decoupled from current redox conditions. Sediments from two different depositional environments were sampled during RV SONNE expedition SO260: a site dominated by contouritic deposition on a terrace (Contourite Site) and the lower continental slope (Slope Site) dominated by hemipelagic sedimentation. Sequentially extracted sedimentary Fe [1] and δ56Fe analyses of extracts and pore water [2,3] were combined with sedimentological, radioisotope, geochemical and magnetic data. Our study presents the first sedimentary δ56Fe dataset at the Argentina Continental Margin. The depositional conditions differed between and within both sites as evidenced by variable grain sizes, organic carbon contents and sedimentation rates. At the Contourite Site, non-steady state pore-water conditions and diagenetic overprint occurs in the post-oxic zone and the sulfate-methane transition (SMT). In contrast, pore-water profiles at the Slope Site suggest that currently steady-state conditions prevail, leading to a strong diagenetic overprint of Fe oxides at the SMT. Pore-water δ56Fe values at the Slope Site are mostly negative, which is typical for on-going microbial Fe reduction. At the Contourite Site the pore-water δ56Fe values are mostly positive and range between -0.35‰ to 1.82‰. Positive δ56Fe values are related to high sulfate reduction rates that dominate over Fe reduction in the post-oxic zone. The HS- liberated during organoclastic sulfate reduction or sulfate-mediated anaerobic oxidation of methane (AOM) reacts with Fe2+ to form Fe sulfides. Hereby, light Fe isotopes are preferentially removed from the dissolved pool. The isotopically light Fe sulfides drive the acetate-leached Fe pool towards negative values. Isotopic trends were absent in other extracted Fe pools, partly due to unintended dissolution of silicate Fe masking the composition of targeted Fe oxides. Significant amounts of reactive Fe phases are preserved below the SMT and are possibly available for reduction processes, such as Fe-mediated AOM [4]. Fe2+ in the methanic zone is isotopically light at both sites, which is indicative for a microbial Fe reduction process. Our results demonstrate that depositional conditions exert a significant control on geochemical conditions and dominant (bio)geochemical processes in the sediments of both contrasting sites. We conclude that the applicability of sedimentary δ56Fe signatures as a proxy to trace diagenetic Fe overprint is limited to distinct Fe pools. The development into a useful tool depends on the refining of extraction methods or other means to analyse δ56Fe in specific sedimentary Fe phases. References: [1]Poulton and Canfield, 2005. Chemical Geology 214: 209-221. [2]Henkel et al., 2016. Chemical Geology 421: 93-102. [3]Homoky et al., 2013. Nature Communications 4: 1-10. [4]Riedinger et al., 2014. Geobiology 12: 172-181.

Description: The Argentina Continental Margin represents a unique geologic setting where fundamental interactions between bottom currents and sediment deposition as well as their impact on biogeochemical processes and element cycling, in particular iron, can be studied. The aims of this study were to investigate 1) the consequences of different depositional conditions on biogeochemical processes and 2) diagenetic cycling of Fe mineral phases in surface sediments. Furthermore, it was 3) studied how sedimentary stable Fe isotope signatures (δ56Fe) are affected during early diagenesis and finally 4) evaluated, under which conditions δ56Fe might be used as proxy for microbial Fe reduction in methanic sediments. During RV SONNE expedition SO260, carried out in the framework of the DFG-funded Cluster of Excellence “The Ocean in the Earth System”, surface sediments from two depositional environments were sampled each using gravity corer and multi corer. One study site is located on the lower continental slope at 3605 m water depth (Biogeochemistry Site), while the other site is situated in a contourite system on the Northern Ewing Terrace at 1078 m water depth (Contourite Terrace Site). Sequential Fe extractions were performed on the collected sediments to determine four operationally defined reactive Fe phases targeting Fe carbonates, (easily) reducible Fe (oxyhydr)oxides and hardly reducible Fe oxides [1]. Purification of extracts for δ56Fe analysis of the Fe carbonates and easily reducible Fe (oxyhydr)oxide fractions followed [2]. The dataset was combined with pore-water data obtained during the cruise and complemented by concentrations and stable carbon isotope signatures of dissolved methane determined post-cruise. The extent of the redox zonation and depth of the sulfate-methane-transition (SMT) differ between the two sites. It is suggested that sedimentation rates at the Biogeochemistry Site are low and that steady state conditions prevail, leading to a strong diagenetic overprint of sedimentary Fe phases. In contrast the Contourite Terrace Site is characterized by high sedimentation rates and a lack of pronounced diagenetic overprint [3]. Reactive Fe phases are subject to reductive dissolution at the SMT. Nevertheless, significant amounts of reactive Fe phases are preserved below the SMT as evidenced by the presence of dissolved Fe in the methanic sediments, and are available for deep Fe reduction possibly through Fe-mediated anaerobic oxidation of methane [4]. In this study, δ56Fe signatures of reactive Fe phases in methanic sediments were determined for the first time. These data suggest significant microbial fractionation of Fe isotopes during deep Fe reduction at the Biogeochemistry Site, whereas at the Contourite Terrace Site the δ56Fe signatures do not indicate remarkable microbial Fe isotope fractionation. It is concluded that the applicability of δ56Fe signatures as tracer for microbial Fe reduction might be sensitive to the depositional regime, and thus may be limited in high sedimentation areas. References: [1]Poulton SW and Canfield DE, 2005. Chemical Geology 214: 209-221. [2]Henkel, S. et al., 2016. Chemical Geology 421: 93-102. [3]Riedinger, N. et al., 2005. Geochimica et Cosmochimica Acta 69: 4117-4126. [4]Riedinger, N. et al., 2014. Geobiology 12: 172-181.