Description: Trends of Aitken, accumulation and coarse mode fractions (a), temperature and relative humidity (b), aerosol scattering at 530 nm (c), absorption coefficients (d), single scattering albedo (SSA) at 530 nm (orange line, right scale) and absorption Angstrom exponent (AAE, grey line, left scale; e) of the aerosol at GVB during the BB event.

Description: Data belonging to the manuscript: "Individual particle characteristics, optical properties and evolution of an extreme long range transported biomass burning event in the European Arctic (Ny-Ålesund, Svalbard Islands)"

Description: The simulation of open quantum dynamics has recently allowed the direct investigation of the features of system-environment interaction and of their consequences on the evolution of a quantum system. Such interaction threatens the quantum properties of the system, spoiling them and causing the phenomenon of decoherence. Sometimes however a coherent exchange of information takes place between system and environment, memory effects arise and the dynamics of the system becomes non-Markovian. Here we report the experimental realisation of a non-Markovian process where system and environment are coupled through a simulated transverse Ising model. By engineering the evolution in a photonic quantum simulator, we demonstrate the role played by system-environment correlations in the emergence of memory effects. Scientific Reports 2 doi: 10.1038/srep00968

Description: Author(s): Massimo Borrelli, Laura Mazzola, Mauro Paternostro, and Sabrina Maniscalco We discuss a simple architecture for a quantum toffoli gate implemented using three trapped ions. The gate, which, in principle, can be implemented with a single laser-induced operation, is effective under rather general conditions and is strikingly robust (within any experimentally realistic range ... [Phys. Rev. A 84, 012314] Published Wed Jul 13, 2011

Description: A prolonged and exceptionally intense air mass advection event transporting biomass burning aerosols generated in Alaska affected Ny-Ålesund in the mid of July 2015. This paper reports the morphochemical characteristics and mixing state of individual aerosol particles collected during the event. To this aim aerosol samples were collected on nucleopore polycarbonate membrane filters using a DEKATI 12-stage low volume impactor and analyzed by scanning electron microscopy (SEM) techniques. Results of SEM investigations depict a complex aerosol characterized by an external mixing between a main part of carbonaceous organic particles (tar balls and organic particles), lower ammonium sulfate and minor potassium chloride and mineral dust amounts. The carbonaceous particles are spherical to slightly elongated and the organic particles show an internal mixing of low density organics and/or ammonium sulfate upon denser nuclei. Most particles are in the accumulation mode size range although the size and the morphology of the chloride and the sulfate salts evidence the growth of these species both in the air and upon the sampling membranes. Individual particle analyses were complemented by aerosol size distribution (Aerodynamic Particle Sizer, Scanning Mobility Particle Sizer) and optical (Particle Soot Absorption Photometer, nephelometer) measurements at ground level in order to retrieve the optical and radiative properties of the aerosol in the atmosphere and to predict the fate and behaviour of particles upon deposition at ground level. Individual particle analyses were also compared with bulk chemical analyses on daily sampling filters and back-trajectory analyses of the air mass movement in order to enucleate distinct sources of the aerosol during the long range transport.

Description: New calculations of the relative optical air mass function are made over the 0°–87° range of apparent solar zenith angle θ, for various vertical profiles of background aerosol, diamond dust and thin cirrus cloud particle extinction coefficient in the Arctic and Antarctic atmospheres. The calculations were carried out by following the Tomasi and Petkov (2014) procedure, in which the above-mentioned vertical profiles derived from lidar observations were used as weighting functions. Different sets of lidar measurements were examined, recorded using: (i) the Koldewey-Aerosol-Raman Lidar (KARL) system (AWI, Germany) at Ny-Ålesund (Spitsbergen, Svalbard) in January, April, July and October 2013; (ii) the Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observations (CALIPSO) satellite-based sensor over Barrow (Alaska), Eureka (Nunavut, Canada) and Sodankylä (northern Finland), and Neumayer III, Mario Zucchelli and Mirny coastal stations in Antarctica in the local summer months of the last two years; (iii) the National Institute of Optics (INO), National Council of Research (CNR) Antarctic lidar at Dome C on the Antarctic Plateau for a typical “diamond dust” case; and (iv) the KARL lidar at Ny-Ålesund and the University of Rome/National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA) lidar at Thule (northwestern Greenland) for some cirrus cloud layers in the middle and upper troposphere. The relative optical air mass calculations are compared with those obtained by Tomasi and Petkov (2014) to define the seasonal changes produced by aerosol particles, diamond dust and cirrus clouds. The results indicate that the corresponding air mass functions generally decrease as angle θ increases with rates that are proportional to the increase in the pure aerosol, diamond dust and cirrus cloud particle optical thickness.

Description: The aim of the presented study was to investigate the impact on the radiation budget of a biomass-burning plume, transported from Alaska to the High Arctic region of Ny-Ålesund, Svalbard, in early July 2015. Since the mean aerosol optical depth increased by the factor of 10 above the average summer background values, this large aerosol load event is considered particularly exceptional in the last 25 years. In situ data with hygroscopic growth equations, as well as remote sensing measurements as inputs to radiative transfer models, were used, in order to estimate biases associated with (i) hygroscopicity, (ii) variability of single-scattering albedo profiles, and (iii) plane-parallel closure of the modelled atmosphere. A chemical weather model with satellite-derived biomass-burning emissions was applied to interpret the transport and transformation pathways. The provided MODTRAN radiative transfer model (RTM) simulations for the smoke event (14:00 9 July–11:30 11 July) resulted in a mean aerosol direct radiative forcing at the levels of −78.9 and −47.0 W m ^-2 at the surface and at the top of the atmosphere, respectively, for the mean value of aerosol optical depth equal to 0.64 at 550 nm. This corresponded to the average clear-sky direct radiative forcing of −43.3 W/m ^2, estimated by radiometer and model simulations at the surface. Ultimately, uncertainty associated with the plane-parallel atmosphere approximation altered results by about 2 W m^−2. Furthermore, model-derived aerosol direct radiative forcing efficiency reached on average −126 W m^−2/τ550 and −71 W^m−2/τ550 at the surface and at the top of the atmosphere, respectively. The heating rate, estimated at up to 1.8 K day^−1 inside the biomass-burning plume, implied vertical mixing with turbulent kinetic energy of 0.3 m^2s^−2

Description: A closure experiment was conducted over Svalbard by comparing Lidar measurements and optical aerosol properties calculated from aerosol vertical profiles measured using a tethered balloon. Arctic Haze was present together with Icelandic dust. Chemical analysis of filter samples, aerosol size distribution and a full set of meteorological parameters were determined at ground. Moreover, scanning electron microscopy coupled with energy-dispersive X-ray (SEM-EDS) data were at disposal showing the presence of several mineralogical phases (i.e., sheet silicates, gypsum, quartz, rutile, hematite). The closure experiment was set up by calculating the backscattering coefficients from tethered balloon data and comparing them with the corresponding lidar profiles. This was preformed in three subsequent steps aimed at determining the importance of a complete aerosol speciation: (i) a simple, columnar refractive index was obtained by the closest Aerosol Robotic Network (AERONET) station, (ii) the role of water-soluble components, elemental carbon and organic matter (EC/OM) was addressed, (iii) the dust composition was included. When considering the AERONET data, or only the ionic water-soluble components and the EC/OM fraction, results showed an underestimation of the backscattering lidar signal up to 76, 53 and 45% (355, 532 and 1064 nm). Instead, when the dust contribution was included, the underestimation disappeared and the vertically-averaged, backscattering coefficients (1.45±0.30, 0.69±0.15 and 0.34±0.08 Mm-1 sr-1, at 355, 532 and 1064 nm) were found in keeping with the lidar ones (1.60±0.22, 0.75±0.16 and 0.31±0.08 Mm-1 sr-1). Final results were characterized by low RMSE (0.36, 0.08 and 0.04 Mm-1 sr-1) and a high linear correlation (R2 of 0.992, 0.992 and 0.994) with slopes close to one (1.368, 0.931 and 0.977, respectively). This work highlighted the importance of all the aerosol components and of the synergy between single particle and bulk chemical analysis for the optical property characterization in the Arctic .