Description: This article presents gas hydrate experimental measurements for mixtures containing methane (CH4), carbon dioxide (CO2) and nitrogen (N2) with the aim to better understand the impact of water (H2O) on the phase equilibrium. Some of these phase equilibrium experiments were carried out with a very high water-to-gas ratio that shifts the gas hydrate dissociation points to higher pressures. This is due to the significantly different solubilities of the different guest molecules in liquid H2O. A second experiment focused on CH4-CO2 exchange between the hydrate and the vapor phases at moderate pressures. The results show a high retention of CO2 in the gas hydrate phase with small pressure variations within the first hours. However, for our system containing 10.2 g of H2O full conversion of the CH4 hydrate grains to CO2 hydrate is estimated to require 40 days. This delay is attributed to the shrinking core effect, where initially an outer layer of CO2-rich hydrate is formed that effectively slows down the further gas exchange between the vapor phase and the inner core of the CH4-rich hydrate grain.

Description: Seepage of methane (CH4) on land and in the sea may significantly affect Earth's biogeochemical cycles. However processes of CH4 generation and consumption, both abiotic and microbial, are not always clear. We provide new geochemical and isotope data to evaluate if a recently discovered CH4 seepage from the shallow seafloor close to the Island of Elba (Tuscany) and two small islands nearby are derived from abiogenic or biogenic sources and whether carbonate encrusted vents are the result of microbial or abiotic processes. Emission of gas bubbles (predominantly CH4) from unlithified sands was observed at seven spots in an area of 100 m(2) at Pomonte (Island of Elba), with a total rate of 234 ml m(-2) d(-1). The measured carbon isotope values of CH4 of around -18 parts per thousand (VPDB) in combination with the measured delta H-2 value of -120 parts per thousand (VSMOW) and the inverse correlation of delta C-13-value with carbon number of hydrocarbon gases are characteristic for sites of CH4 formation through abiogenic processes, specifically abiogenic formation of CH4 via reduction of CO2 by H-2. The H-2 for methanogenesis likely derives from ophiolitic host rock within the Ligurian accretionary prism. The lack of hydrothermal activity allows CH4 gas to become decoupled from the stagnant aqueous phase. Hence no hyperalkaline fluid is currently released at the vent sites. Within the seep area a decrease in porewater sulphate concentrations by ca. 5 mmol/l relative to seawater and a concomitant increase in sulphide and dissolved inorganic carbon (DIC) indicate substantial activity of sulphate-dependent anaerobic oxidation of methane (AOM). In absence of any other dissimilatory pathway, the delta C-13-values between -17 and -5 parts per thousand in dissolved inorganic carbon and aragonite cements suggest that the inorganic carbon is largely derived from CH4. The formation of seep carbonates is thus microbially induced via anaerobic oxidation of abiotic CH4.

Description: Natural gas hydrates are considered a potential resource for gas production on industrial scales. Gas hydrates contribute to the strength and stiffness of the hydrate-bearing sediments. During gas production, the geomechanical stability of the sediment is compromised. Due to the potential geotechnical risks and process management issues, the mechanical behavior of the gas hydrate-bearing sediments needs to be carefully considered. In this study, we describe a coupling concept that simplifies the mathematical description of the complex interactions occurring during gas production by isolating the effects of sediment deformation and hydrate phase changes. Central to this coupling concept is the assumption that the soil grains form the load-bearing solid skeleton, while the gas hydrate enhances the mechanical properties of this skeleton. We focus on testing this coupling concept in capturing the overall impact of geomechanics on gas production behavior though numerical simulation of a high-pressure isotropic compression experiment combined with methane hydrate formation and dissociation. We consider a linear-elastic stress-strain relationship because it is uniquely defined and easy to calibrate. Since, in reality, the geomechanical response of the hydrate-bearing sediment is typically inelastic and is characterized by a significant shear-volumetric coupling, we control the experiment very carefully in order to keep the sample deformations small and well within the assumptions of poroelasticity. The closely coordinated experimental and numerical procedures enable us to validate the proposed simplified geomechanics-to-flow coupling, and set an important precursor toward enhancing our coupled hydro-geomechanical hydrate reservoir simulator with more suitable elastoplastic constitutive models.

Description: Microbial degradation of substrates to terminal products is commonly understood as a unidirectional process. In individual enzymatic reactions, however, reversibility (reverse reaction and product back flux) is common. Hence, it is possible that entire pathways of microbial degradation are associated with back flux from the accumulating product pool through intracellular intermediates into the substrate pool. We investigated carbon and sulfur back flux during the anaerobic oxidation of methane (AOM) with sulfate, one of the least exergonic microbial catabolic processes known. The involved enzymes must operate not far from the thermodynamic equilibrium. Such an energetic situation is likely to favor product back flux. Indeed, cultures of highly enriched archaeal–bacterial consortia, performing net AOM with unlabeled methane and sulfate, converted label from 14C-bicarbonate and 35S-sulfide to 14C-methane and 35S-sulfate, respectively. Back fluxes reached 5% and 13%, respectively, of the net AOM rate. The existence of catabolic back fluxes in the reverse direction of net reactions has implications for biogeochemical isotope studies. In environments where biochemical processes are close to thermodynamic equilibrium, measured fluxes of labeled substrates to products are not equal to microbial net rates. Detection of a reaction in situ by labeling may not even indicate a net reaction occurring in the direction of label conversion but may reflect the reverse component of a so far unrecognized net reaction. Furthermore, the natural isotopic composition of the substrate and product pool will be determined by both the forward and back flux. This finding may have to be considered in the interpretation of stable isotope records.

Description: The influence of hydrostatic pressure on microbial sulfate reduction (SR) was studied using sediments obtained at cold seep sites from 5500 to 6200 m water depth of the Japan Trench. Sediment samples were stored under anoxic conditions for 17 months in slurries at 4°C and at in situ pressure (50 MPa), at atmospheric pressure (0.1 MPa), or under methanic conditions with a methane partial pressure of 0.2 MPa. Samples without methane amendment stored at in situ pressure retained higher levels of sulfate reducing activity than samples stored at 0.1 MPa. Piezophilic SR showed distinct substrate specificity after hydrogen and acetate addition. SR activity in samples stored under methanic conditions was one order of magnitude higher than in non-amended samples. Methanic samples stored under low hydrostatic pressure exhibited no increased SR activity at high pressure even with the amendment of methane. These new insights into the effects of pressure on substrate specific sulfate reducing activity in anaerobic environmental samples indicate that hydrostatic pressure must be considered to be a relevant parameter in ecological studies of anaerobic deep-sea microbial processes and long-term storage of environmental samples.

Description: Due to the strong interest in geochemical CO2-fluid-rock interaction in the context of geological storage of CO2 a growing number of research groups have used a variety of different experimental ways to identify important geochemical dissolution or precipitation reactions and – if possible – quantify the rates and extent of mineral or rock alteration. In this inter-laboratory comparison the gas-fluid-mineral reactions of three samples of rock-forming minerals have been investigated by 11 experimental labs. The reported results point to robust identification of the major processes in the experiments by most groups. The dissolution rates derived from the changes in composition of the aqueous phase are consistent overall, but the variation could be reduced by using similar corrections for changing parameters in the reaction cells over time. The comparison of experimental setups and procedures as well as of data corrections identified potential improvements for future gas-fluid-rock studies.

Description: The recovery of natural gas from CH4-hydrate deposits in sub-marine and sub-permafrost environments through injection of CO2 is considered a suitable strategy towards emission-neutral energy production. This study shows that the injection of hot, supercritical CO2 is particularly promising. The addition of heat triggers the dissociation of CH4-hydrate while the CO2, once thermally equilibrated, reacts with the pore water and is retained in the reservoir as immobile CO2-hydrate. Furthermore, optimal reservoir conditions of pressure and temperature are constrained. Experiments were conducted in a high-pressure flow-through reactor at different sediment temperatures (2 °C, 8 °C, 10 °C) and hydrostatic pressures (8 MPa, 13 MPa). The efficiency of both, CH4 production and CO2 retention is best at 8 °C, 13 MPa. Here, both CO2- and CH4-hydrate as well as mixed hydrates can form. At 2 °C, the production process was less effective due to congestion of transport pathways through the sediment by rapidly forming CO2-hydrate. In contrast, at 10 °C CH4 production suffered from local increases in permeability and fast breakthrough of the injection fluid, thereby confining the accessibility to the CH4 pool to only the most prominent fluid channels. Mass and volume balancing of the collected gas and fluid stream identified gas mobilization as equally important process parameter in addition to the rates of methane hydrate dissociation and hydrate conversion. Thus, the combination of heat supply and CO2 injection in one supercritical phase helps to overcome the mass transfer limitations usually observed in experiments with cold liquid or gaseous CO2.

Description: Gashydrate sind eisähnliche Verbindungen, in denen Hydratbildner, z.B. Methan, in hoher Dichte gespeichert werden können. Methanhydrate sind nur bei hohen Drücken und tiefen Temperaturen sowie in Anwesenheit hoher Methankonzentrationen stabil. Diese Stabilitätsbedingungen sind unter bestimmten Voraussetzungen in marinen Sedimenten erfüllt, in denen Methan durch den mikrobiellen Abbau von abgelagerter Biomasse entsteht oder aus größeren Tiefen zugeführt wird. Die globale Menge an Methan in marinen Gashydraten überschreitet die Menge an Erdgas in konventionellen Lagerstätten vermutlich um ein Mehrfaches. Eine potenzielle Nutzung von Gashydraten als zukünftige Energiequelle wird daher gegenwärtig weltweit untersucht. Erste Feldtests in Permafrostregionen und marinen Lagerstätten haben gezeigt, dass eine Produktion von Methan aus Gashydraten prinzipiell möglich ist. Eine Förderung von Methan aus Gashydraten kann technisch realisiert werden mittels Druckabsenkung, durch thermische Stimulation oder chemische Aktivierung. Die Injektion von CO2, ebenfalls ein Hydratbildner, kann eine solche Aktivierung der natürlichen Hydrate bewirken und das Methan in der Hydratstruktur ersetzen. Infolgedessen erscheint eine verfahrenstechnische Kombination von Hydratabbau und CO2-Speicherung als besonders sinnvoll, da im Idealfall eine emissionsarme bis -freie Energiegewinnung ermöglicht würde. Untersuchungen zur Aufklärung mechanistischer und fluiddynamischer Aspekte der CH4-CO2-Hydratumwandlung sowie zur Entwicklung eines technischen Verfahrens werden in unterschiedlichen Hochdruckanlagen auf verschiedenen Skalen durchgeführt. Diese speziellen Systeme bieten die Möglichkeit, marine Druck-, Temperatur- und Durchflussbedingungen zu simulieren. Sie sind mit verschiedenen Sensoren und Messsystemen (z.B. CTD, IR, Raman, MRI) ausgerüstet, um den Prozessverlauf störungsfrei zu überwachen. Basierend auf derzeitigen Ergebnissen erscheint die Injektion von erwärmtem, überkritischem CO2 als vielversprechender technischer Baustein für die Verfahrensentwicklung. Die Zuführung von Wärmeenergie bewirkt die initiale Destabilisierung der Gashydrate und die Freisetzung von CH4, während nach Abkühlung das CO2 seinerseits Hydrate bildet und als feste, immobile Phase im Sediment zurückgehalten wird. Sowohl Methanproduktion als auch CO2-Speicherung sind dabei abhängig von der Reservoirtemperatur, so dass die Prozesseffizienz und -ausbeute bei mittleren Temperaturen (8°C) höher ist als bei niedrigeren (2°C) und höheren Temperaturen (10°C). Dies deutet darauf hin, dass der Gesamtprozess durch die Raten der jeweiligen Teilreaktionen der Hydratzersetzung und Hydratneubildung stark beeinflusst wird. Der experimentelle Vergleich unterschiedlicher Injektionsmodi zeigt, dass eine alternierende CO2-Injektion bestehend aus Injektions- und Reaktionsintervallen höhere Ausbeuten erreicht als eine kontinuierliche Injektion.