GLORIA

GEOMAR Library Ocean Research Information Access

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2021-06-16
    Description: The presence of pressurized fluids influences the mechanical behavior of faults. To test the roles of normal stress and fluid pressure on shear strength and localization behavior of calcite gouges, we conducted a series of rotary-shear experiments with pore fluid pressures up to 10.5 MPa and difference between normal stress and fluid pressure up to 11.2 MPa. Calcite gouges were sheared for displacements of 0.3 m to several meters at slip rates of 1 mm/s and 1 m/s. Drainage conditions in experiments were constrained from estimates of the hydraulic diffusivity. Gouges were found to be drained at 1 mm/s, but possibly partially undrained during sliding at 1 m/s. Shear strength obeys an effective-stress law with an effective-stress coefficient close to unity with a friction coefficient of ~0.7 that decreases to 0.19 due to dynamic weakening. The degree of comminution and slip localization constrained from experimental microstructures depends on the effective normal stress. Slip localization in calcite gouges does not occur at low effective normal stress. The presence of pore fluids lowers the shear strength of gouges sheared at 1 mm/s and causes an accelerated weakening at 1 m/s compared to dry gouges, possibly due to enhanced subcritical crack growth and intergranular lubrication. Thermal pressurization occurs only after dynamic weakening when friction is generally low and relatively independent of normal stress and therefore unaffected by thermal pressurization. The experimental results are consistent with the view that the presence of pressurized fluid in carbonate-bearing faults can facilitate earthquake nucleation.
    Description: ERC StG 205175 USEMS ERC CoG 614705 NOFEAR Ca.Ri.Pa.Ro Foundation Gesellschaft der Freunde der Ruhr‐Universität Bochum e.V.
    Description: Published
    Description: e2020JB019805
    Description: 3T. Sorgente sismica
    Description: JCR Journal
    Keywords: Fault ; Earthquakes ; Carbonates ; Gouges ; Earthquake mechanics ; Rock Friction
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2018-03-07
    Description: Experiments performed on rocks at deformation conditions typical of seismic slip, show an extremely low friction coefficient, the activation of lubrication processes and a power-law strength decay from a peak value to a residual, steady-state value. The weakening curve has an initially very abrupt decay which can be approximated by a powerlaw. The resulting experimental fracture energy (defined, for a given slip amount u, as the integral between the frictional curve and the minimum frictional level reached σf (u)) scales on most of the slip range as G ∝ u α, a power-law in some aspects in agreement with the seismological estimates of G0 ∝ u 1.28 proposed by Abercrombie and Rice (2005). The values of G and G0 are comparable for slips of about u = 1cm (G ≈ 104 J/m2 ). Both gradually increase with slip up to about 106 J/m2, however, it appears that fracture energy G0 is slightly larger than G in the range of slip 0.1 〈 u 〈 10. The effective G0 observed at the seismological scale should implicitly incorporate energy sinks other than frictional dissipation alone, which we discuss (anelastic damage due to high off-fault dynamic stress close to the rupture tip; dissipation during slip-localizing process within fault gouge of finite thickness; strain accomodating fault roughness at different scales). Since G0 is obtained by estimating the amount of dissipation with respect to strain energy and radiated energy, it will implicitly incorporate the sum of all dissipative processes due to rupture propagation and fault slip. From the comparison of G obtained in the lab and in earthquakes, it appears that friction alone explains most of the dissipation, except maybe at the larger magnitudes
    Description: Published
    Description: Vienna
    Description: 2T. Sorgente Sismica
    Keywords: friction, eartquake
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: Conference paper
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2018-03-23
    Description: Foliated gouges and cataclasites are commonly interpreted as the product of distributed (aseismic) fault creep. However, foliated fault rocks are often associated with localized slip surfaces, the latter indicating potentially unstable (seismic) behavior. One possibility is that such fault zones preserve the effects of both seismic slip and slower aseismic creep. An alternative possibility explored here is that some foliated fault rocks and localized slip surfaces develop contemporaneously during seismic slip. We studied the microstructural evolution of calcitedolomite gouges deformed experimentally at slip velocities 〈1.13 m s−1 and for total displacements of 0.03–1 m, in the range expected for the average coseismic slip during earthquakes of Mw 3–7. As strain progressively localized in the gouge layers at the onset of high‐velocity shearing, an initial mixed assemblage of calcite and dolomite grains evolved quickly to an organized, foliated fabric. The foliation was defined mainly by compositional layering and grain size variations that formed by cataclasis and shearing of individual foliation domains. The most significant microstructural changes in the bulk gouge occurred before and during dynamic weakening (〈0.08 m displacement). Strain was localized to a bounding slip surface by the end of dynamic weakening, and thus microstructural evolution in the bulk gouge ceased. Our experiments suggest that certain types of foliated gouge and cataclasite can form by distributed brittle “flow” as strain localizes to a bounding slip surface during coseismic shearing.
    Description: Published
    Description: 81-102
    Description: 7T. Struttura della Terra e geodinamica
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: book chapter
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 4
    Publication Date: 2020-02-18
    Description: Nanograins (≪1 μm) are common in the principal slip zones of natural and experimental faults, but their formation and influence on fault mechanical behavior are poorly understood. We performed transmission Kikuchi diffraction (spatial resolution 20–50 nm) on the principal slip zone of an experimental carbonate gouge (50 wt% calcite, 50 wt% dolomite) that was deformed at a maximum slip rate of 1.2 m/s for 0.4 m displacement. The principal slip zone (PSZ) consists of nanogranular aggregates of calcite, Mg‐calcite, dolomite and periclase, dominated by grain sizes in the range of 100–300 nm. Nanograins in the ultrafine (〈 800 nm) PSZ matrix have negligible internal lattice distortion, while grains 〉 800 nm in size contain subgrains. A weak crystallographic preferred orientation is observed as a clustering of calcite c‐axes within the PSZ. The high‐resolution microstructural observations from transmission Kikuchi diffraction, in combination with published flow laws for calcite, are compatible with high‐velocity slip in the PSZ having been accommodated by a combination of grain size sensitive creep in the ultrafine matrix, and grain size insensitive creep in the larger grains, with the former process likely controlling the bulk rheology of the PSZ after dynamic weakening. If the activation energy for creep is lowered by the nanogranular nature of the aggregates, this could facilitate grain size sensitive creep at high (coseismic) strain rates and only moderate bulk temperatures of approximately 600 °C, although temperatures up to 1000 °C could be locally achieved due to processes such as flash heating.
    Description: Published
    Description: 10197-10209
    Description: 3T. Sorgente sismica
    Description: 2IT. Laboratori analitici e sperimentali
    Description: JCR Journal
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 5
    Publication Date: 2021-12-16
    Description: Calcite and dolomite are the two most common minerals in carbonate-bearing faults and shear zones. Motivated by observations of exhumed seismogenic faults in the Italian Central Apennines, we used a rotary-shear apparatus to investigate the frictional and microstructural evolution of ca. 3 mm thick gouge layers consisting of 50 wt % calcite and 50 wt % dolomite. The gouges were sheared at a range of slip rates (30 µm s−1–1 m s−1), displacements (0.05–0.4 m), and a normal load of 17.5 MPa under both room-humidity and water-dampened conditions. The frictional behaviour and microstructural evolution of the gouges were strongly influenced by the presence of water. At room humidity, slip strengthening was observed up to slip rates of 0.01 m s−1, which was associated with gouge dilation and the development of a 500–900 µm wide slip zone cut by Y-, R-, and R1-shear bands. Above a slip rate of 0.1 m s−1, dynamic weakening accompanied the development of a localised 〈 100 µm thick principal slip zone preserving microstructural evidence for calcite recrystallisation and dolomite decarbonation, while the bulk gouges developed a well-defined foliation consisting of organised domains of heavily fractured calcite and dolomite. In water-dampened conditions, evidence of gouge fluidisation within a fine-grained principal slip zone was observed at a range of slip rates from 30 µm s−1 to 0.1 m s−1, suggesting that caution is needed when relating fluidisation textures to seismic slip in natural fault zones. Dynamic weakening in water-dampened conditions was observed at 1 m s−1, where the principal slip zone was characterised by patches of recrystallised calcite. However, local fragmentation and reworking of recrystallised calcite suggests a cyclic process involving formation and destruction of a heterogeneous slip zone. Our microstructural data show that development of well-defined gouge foliation under the tested experimental conditions is limited to high velocities (〉0.1 m s−1) and room humidity, supporting the notion that some foliated gouges and cataclasites may form during seismic slip in natural carbonate-bearing faults.
    Description: Published
    Description: 595–612
    Description: 3T. Fisica dei terremoti e Sorgente Sismica
    Description: JCR Journal
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 6
    Publication Date: 2022-06-09
    Description: The Foiana Fault Zone (FFZ) is a major sinistral transpressive fault zone exhumed from 〈 2 km depth in the Italian Southern Alps. The fault zone crosscuts thick sequences of sedimentary dolostones and shows increasing cumulative throw (0.3–1.8 km) moving from south to north along fault strike. The FFZ consists of variably fractured and fragmented dolostones locally cut by small-displacement (〈 0.5 m) faults containing discrete, highly-reflective (so-called “mirror-like”) slip surfaces. The mirror-like slip surfaces are typically embedded within fine-grained cataclasite layers up to a few centimeters thick. Preservation of bedding planes in the fragmented dolostones indicates a lack of significant shear strain. Instead, the fragmented dolostones are affected by in-situ shattering from the centimeter down to the micrometer scale, resembling pulverized rocks in crystalline lithologies. Detailed field and aerial structural mapping reveals significant changes in the structure of the FFZ along strike. In particular, the fault zone exhibits large variations in thickness (from c. 100 m in the north to more than 300 m in the south) and changes in mean fault orientation and fault kinematics (from dominant oblique- and strike-slip in the north to dip-slip reverse in the south), together with the reactivation of preexisting anisotropies (i.e. bedding). Overall, the structure of the FFZ, when considered together with possible variable exhumation levels along strike, compares favorably to the predicted damage distribution in three-dimensional earthquake rupture simulations on strike-slip faults, as well as to the characteristics of active seismic sources hosted in carbonate rocks as illuminated by recent seismological studies.
    Description: Published
    Description: 56-74
    Description: 2T. Sorgente Sismica
    Description: JCR Journal
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...