Description: First-year sea-ice thickness, draft, salinity, temperature, and density were measured during near-weekly surveys at the main first-year ice coring site (MCS-FYI) during the MOSAiC expedition (legs 1 to 4). The ice cores were extracted either with a 9-cm (Mark II) or 7.25-cm (Mark III) internal diameter ice corers (Kovacs Enterprise, US). This data set includes data from 23 coring site visits and were performed from 28 October 2019 to 29 July 2020 at coring locations within 130 m to each other in the MOSAiC Central Observatory. During each coring event, ice temperature was measured in situ from a separate temperature core, using Testo 720 thermometers in drill holes with a length of half-core-diameter at 5-cm vertical resolution. Ice bulk practical salinity was measured from melted core sections at 5-cm resolution using a YSI 30 conductivity meter. Ice density was measured using the hydrostatic weighing method (Pustogvar and Kulyakhtin, 2016) from a density core in the freezer laboratory onboard Polarstern at the temperature of –15°C. Relative volumes of brine and gas were estimated from ice salinity, temperature and density using Cox and Weeks (1983) for cold ice and Leppäranta and Manninen (1988) for ice warmer than –2°C. The data contains the event label (1), time (2), and global coordinates (3,4) of each coring measurement and sample IDs (13, 15). Each salinity core has its manually measured ice thickness (5), ice draft (6), core length (7), and mean snow height (22). Each core section has the total length of its top (8) and bottom (9) measured in situ, as well estimated depth of section top (10), bottom (11), and middle (12). The depth estimates assume that the total length of all core sections is equal to the measured ice thickness. Each core section has the value of its practical salinity (14), isotopic values (16, 17, 18) (Meyer et al., 2000), as well as sea ice temperature (19) and ice density (20) interpolated to the depth of salinity measurements. The global coordinates of coring sites were measured directly. When it was not possible, coordinates of the nearby temperature buoy 2019T66 were used. Ice mass balance buoy 2019T66 installation is described in doi:10.1594/PANGAEA.938134. Brine volume (21) fraction estimates are presented only for fraction values from 0 to 30%. Each core section also has comments (23) describing if the sample is from a false bottom, from rafted ice or has any other special characteristics. Macronutrients from the salinity core, and more isotope data will be published in a subsequent version of this data set.

Description: Algal pigment concentrations were retrieved from samples from first-year (FYI) ice, during the whole MOSAiC expedition (Multidisciplinary drifting Observatory for the Study of Arctic Climate) in 2019 to 2020. During MOSAiC, RV Polarstern anchored into an ice floe to gain new insights into Arctic climate over a full annual cycle. Sea ice data were collected starting with the onset of the study, at 85 degrees north and 137 degrees east, following the drift towards the Fram Strait, and returning to the North Pole in the last leg of the expedition. Ice cores were collected at the various coring sites together with teams ICE and BGC (Nicolaus et al. 2022), to study the development of pigment patterns over time, on 3 specific ice-locations. Altogether, 292 samples have been collected and analysed. Ice cores were sliced in sections of 5-10 cm before analyses. Each of the sections was melted at room temperature after additions of filtered ambient seawater, under dark conditions. After extraction in 90 % acetone, samples were analysed using high-performance liquid chromatography (HPLC) on a Waters system (AWI). Algal pigments contain a multiple set of information. Firstly, pigment concentrations can show the presence of algal biomass in the various domains sampled. Secondly, marker pigments can reveal seasonal and temporal dynamics in algal community structure, by discerning specific algal classes like diatoms, cryptophytes, haptophytes and chlorophytes that have specific roles in biogeochemical cycles. Thirdly, certain pigments are indicative of the (photo)-physiological state of micro-algae and fourth, degradation products of the main chlorophyll a pigment further give an indication about senescence and grazing in the various habitats.