Description: When volcanic mountains slide into the sea, they trigger tsunamis. How big are these waves, and how far away can they do damage? Ritter Island provides some answers.

Description: Highlights • 3D seismic imaging of an entire landslide complex. • Shallow gas accumulation within and underneath Tuaheni Landslide Complex. • Imaging of a basal shear zone within a subaqueous landslide complex. Abstract The Hikurangi margin is an active continental margin east of New Zealand's North Island. It is well recognized as a seismically active zone and is known for the occurrence of free gas and gas hydrates within the shallow sediments. A variety of subaqueous landslides can be observed at the margin, including the Tuaheni Landslide Complex off Poverty Bay. This slide complex has been interpreted previously as a slowly creeping landform, as its morphology and internal deformation is comparable to terrestrial earthflows and rock glaciers. In 2014, we acquired a high-resolution 3D seismic volume covering major parts of the Tuaheni South landslide. The 3D data show a variety of fluid migration indicators, free gas accumulations and manifestations of the base of gas hydrate stability in the pre-slide sedimentary units and the lower unit of the landslide system. The data also show that the landslide system is composed of an upper and lower unit that are separated by an intra-debris negative-polarity reflection. Free gas accumulations directly beneath the landslide units suggest that the debris acts as a boundary for rising fluids and only few migration pathways to the intra-debris reflector are observed in the distal parts of the landslide. Deformation within the landslide's debris is focused in the upper landslide unit, and we interpret the intra-debris reflector as a basal shear zone or ‘glide plane’ upon which the debris has been remobilized. The origin of the intra-debris reflector is unclear, but we suggest it could be a relatively coarse-grained horizon that would be prone to fluid flow focusing and the development of excess fluid pressure. Our seismic study provides one of the most detailed examples of a subaqueous landslide system and reveals insights into the fluid flow system and potential basal shear zone development of the Tuaheni Landslide Complex.

Description: Upper‐plate normal faults are a widespread structural element in erosive plate margins. Increasing coverage of marine geophysical data has proven that similar features also exist in accretionary margins where horizontal compression usually results in folding and thrust‐faulting. There is a general lack of understanding of the role and importance of normal faulting for the structural and tectonic evolution of accretionary margins. Here, we use high‐resolution 2D and 3D seismic reflection data and derived seismic attributes to map and analyze upper‐plate normal faulting in the marine forearc of the accretionary Hikurangi margin, New Zealand. We document extension of the marine forearc over a wide area along the upper continental slope. The seismically imaged normal faults show low vertical displacements, high dip angles, a preference for landward dip and often en echelon patterns. We evaluate different processes, which may cause the observed extension, including (1) stress change during the earthquake cycle, (2) regional or local uplift and decoupling of shallow strata from compression at depth, as well as (3) rotation of crustal blocks and resulting differential stresses at the block boundaries. The results suggest that normal faults play an important role in the structural and tectonic evolution of accretionary margins, including the northern Hikurangi forearc.

Description: Highlights • Gas release from wells may counteract efforts to mitigate greenhouse gas emissions. • An approach for assessing methane release from marine decommissioned wells. • This gas release largely depends on the presence of shallow gas accumulations. • Methane release from hydrocarbon wells represents a major source in the North Sea. Abstract Hydrocarbon gas emissions from with decommissioned wells are an underreported source of greenhouse gas emissions in oil and gas provinces. The associated emissions may partly counteract efforts to mitigate greenhouse gas emissions from fossil fuel infrastructure. We have developed an approach for assessing methane leakage from marine decommissioned wells based on a combination of existing regional industrial seismic and newly acquired hydroacoustic water column imaging data from the Central North Sea. Here, we present hydroacoustic data which show that 28 out of 43 investigated wells release gas from the seafloor into the water column. This gas release largely depends on the presence of shallow gas accumulations and their distance to the wells. The released gas is likely primarily biogenic methane from shallow sources. In the upper 1,000 m below the seabed, gas migration is likely focused along drilling-induced fractures around the borehole or through non-sealing barriers. Combining available direct measurements for methane release from marine decommissioned wells with our leakage analysis suggests that gas release from investigated decommissioned hydrocarbon wells is a major source of methane in the North Sea (0.9-3.7 [95% confidence interval = 0.7-4.2] kt yr−1 of CH4 for 1,792 wells in the UK sector of the Central North Sea). This means hydrocarbon gas emissions associated with marine hydrocarbon wells are not significant for the global greenhouse gas budget, but have to be considered when compiling regional methane budgets.

Description: Volcanic island flank collapses have the potential to trigger devastating tsunamis threatening coastal communities and infrastructure. The 1888 sector collapse of Ritter Island, Papua New Guinea (in the following called Ritter) is the most voluminous volcanic island flank collapse in historic times. The associated tsunami had run-up heights of more than 20 m on the neighboring islands and reached settlements 600 km away from its source. This event provides an opportunity to advance our understanding of volcanic landslide-tsunami hazards. Here, we present a detailed reconstruction of the 1888 Ritter sector collapse based on high-resolution 2D and 3D seismic and bathymetric data covering the failed volcanic edifice and the associated mass-movement deposits. The 3D seismic data reveal that the catastrophic collapse of Ritter occurred in two phases: (1) Ritter was first affected by deep-seated, gradual spreading over a long time period, which is manifest in pronounced compressional deformation within the volcanic edifice and the adjacent seafloor sediments. A scoria cone at the foot of Ritter acted as a buttress, influencing the displacement and deformation of the western flank of the volcano and causing shearing within the volcanic edifice. (2) During the final, catastrophic phase of the collapse, about 2.4 km³ of Ritter disintegrated almost entirely and travelled as a highly energetic mass flow, which incised the underlying sediment. The irregular topography west of Ritter is a product of both compressional deformation and erosion. A crater-like depression underlying the recent volcanic cone and eyewitness accounts suggest that an explosion may have accompanied the catastrophic collapse. Our findings demonstrate that volcanic sector collapses may transform from slow gravitational deformation to catastrophic collapse. Understanding the processes involved in such a transformation is crucial for assessing the hazard potential of other volcanoes with slowly deforming flanks such as Mt. Etna or Kilauea.

Description: Highlights • Ritter Island's sector collapse provides an exemplar of volcanic tsunami hazards. • Deposit heterogeneity reflects erosion, secondary failure and a triggered eruption. • The volume of the distal deposit alone far exceeds the tsunamigenic failure. • A single catastrophic collapse led to stratigraphically complex distal deposits. • Accurate assessment of tsunami potential requires internal imaging and sampling. Abstract The current understanding of tsunamis generated by volcanic-island landslides is reliant on numerical models benchmarked against reconstructions of past events. As the largest historical event with timed tsunami observations, the 1888 sector collapse of Ritter Island, Papua New Guinea provides an outstanding opportunity to better understand the linked process of landslide emplacement and tsunami generation. Here, we use a combination of geophysical imaging, bathymetric mapping, seafloor observations and sampling to demonstrate that the Ritter landslide deposits are spatially and stratigraphically heterogeneous, reflecting a complex evolution of mass-flow processes. The primary landslide mass was dominated by well-bedded scoriaceous deposits, which rapidly disintegrated to form an erosive volcaniclastic flow that incised the substrate over much of its pathway. The major proportion of this initial flow is inferred to have been deposited up to 80 km from Ritter. The initial flow was followed by secondary failure of seafloor sediment, over 40 km from Ritter. The most distal part of the 1888 deposit has parallel internal boundaries, suggesting that multiple discrete units were deposited by a series of mass-flow processes initiated by the primary collapse. The last of these flows was derived from a submarine eruption triggered by the collapse. This syn-collapse eruption deposit is compositionally distinct from pre- and post-collapse eruptive products, suggesting that the collapse immediately destabilised the underlying magma reservoir. Subsequent eruptions have been fed by a modified plumbing system, constructing a submarine volcanic cone within the collapse scar through at least six post-collapse eruptions. Our results show that the initial tsunami-generating landslide at Ritter generated a stratigraphically complex set of deposits with a total volume that is several times larger than the initial failure. Given the potential for such complexity, there is no simple relationship between the volume of the tsunamigenic phase of a volcanic-island landslide and the final deposit volume, and deposit area or run-out cannot be used to infer primary landslide magnitude. The tsunamigenic potential of prehistoric sector-collapse deposits cannot, therefore, be assessed simply from surface mapping, but requires internal geophysical imaging and direct sampling to reconstruct the event.

Description: Abrupt fluid emissions from shallow marine sediments pose a threat to seafloor installations like wind farms and offshore cables. Quantifying such fluid emissions and linking pockmarks, the seafloor manifestations of fluid escape, to flow in the sub-seafloor remains notoriously difficult due to an incomplete understanding of the underlying physical processes. Here, using a compositional multi-phase flow model, we test plausible gas sources for pockmarks in the south-eastern North Sea, which recent observations suggest have formed in response to major storms. We find that the presence of free gas in the subsurface effectively damps storm wave-induced pressure changes due to its high compressibility, so that the mobilization of pre-existing gas pockets is unlikely. Rather, our results point to spontaneous appearance of a free gas phase via storm-induced gas exsolution from pore fluids. This mechanism is primarily driven by the pressure-sensitivity of gas solubility. We show that in highly permeable sediments containing gas-rich pore fluids, wave-induced pressure changes result in the appearance of a persistent gas phase. This suggests that seafloor fluid escape structures are not always proxies for overpressured shallow gas and that periodic seafloor pressure changes can induce persistent free gas phase to spontaneously appear.

Description: Marine sediments host large amounts of methane (CH4), which is a potent greenhouse gas. Quantitative estimates for methane release from marine sediments are scarce, and a poorly constrained temporal variability leads to large uncertainties in methane emission scenarios. Here, we use 2D and 3D seismic reflection, multibeam bathymetric, geochemical and sedimentological data to (I) map and describe pockmarks in the Witch Ground Basin (central North Sea), (II) characterize associated sedimentological and fluid migration structures, and (III) analyze the related methane release. More than 1500 pockmarks of two distinct morphological classes spread over an area of 225 km2. The two classes form independently from another and are corresponding to at least two different sources of fluids. Class 1 pockmarks are large in size (〉 6 m deep, 〉 250 m long, and 〉 75 m wide), show active venting, and are located above vertical fluid conduits that hydraulically connect the seafloor with deep methane sources. Class 2 pockmarks, which comprise 99.5 % of all pockmarks, are smaller (0.9‐3.1 m deep, 26‐140 m long, and 14‐57 m wide) and are limited to the soft, fine‐grained sediments of the Witch Ground Formation and possibly sourced by compaction‐related dewatering. Buried pockmarks within the Witch Ground Formation document distinct phases of pockmark formation, likely triggered by external forces related to environmental changes after deglaciation. Thus, greenhouse gas emissions from pockmark fields cannot be based on pockmark numbers and present‐day fluxes but require an analysis of the pockmark forming processes through geological time.

Description: Highlights • Unprecedented dense coverage of ocean-bottom seismometer data reveals seismic velocity variations within a vertical fluid pathway. • There are zones of both positive (faster) and negative (slower) velocity within the fluid pathway compared to the background formation velocities. • Velocity reductions are related to free gas in the fluid pathway, while the reason for velocity increases is unclear but potentially caused by cementation. Abstract Subsurface CO2 storage is a key strategy to reduce greenhouse gas emission, but leakage of CO2 along natural fluid pathways may affect storage formation integrity. However, the internal structure and the physical properties of these focused fluid conduits are poorly understood. Here, we present a three-dimensional seismic velocity model of an active fluid conduit beneath the Scanner Pockmark in the Central North Sea, derived from ocean-bottom seismometer data. We show that the conduit, which manifests as a pipe structure in seismic data, is separated into two parts. The upper part, extending to 260 m depth, i.e. 110 m below the seafloor, is characterised by seismic velocities up to 100 m/s slower than the surrounding strata. The deeper part is characterized by a 50 m/s seismic velocity increase compared to background velocity. We suggest that the upper part of the pipe structure represents a network of open fractures, partly filled with free gas, while the reason for the velocity increase in the lower part remains speculative. These observations suggest that active pipes can be internally heterogeneous with some intervals probably being open fluid pathways and other intervals being closed. This study highlights the complexity in evaluating focused fluid conduits and the necessity of their detailed assessment when selecting CO2 storage sites.

Description: Seafloor heat flow provides information about the thermal evolution of the lithosphere, the magnitude and timing of volcanic activity, and hydrothermal circulation patterns. In the central Gulf of California, the Guaymas Basin is part of a young marginal spreading rift system that experiences high sedimentation (1–5 km/Myr) and widespread magmatic intrusions in the axial troughs and the off-axis regions. Heat flow variations record magmatic and sedimentary processes affecting the thermal evolution of the basin. Here, we present new seismic evidence of a widespread bottom-simulating reflection (BSR) in the northwestern Guaymas Basin. Using the BSR depths and thermal conductivity measurements, we determine geothermal gradient and surface heat flow variations. The BSR-derived heat flow values are less than the conductive lithospheric heat flow predictions for mid-oceanic ridges. They suggest that high sedimentation (0.3–1 km/Myr) suppresses the lithospheric heat flow. In the central and southeastern regions of the basin, the BSR-derived geothermal gradient increases as the intruded magmatic units reach shallower subsurface depths. Thermal modeling shows that recent (〈5000 years) igneous intrusions (〈500 m below the seafloor) and associated fluid flow elevate the surface heat flow up to five times. BSR-derived geothermal gradients correlate little with the depth of the shallowest magmatic emplacements to the north, where the intrusions have already cooled for some time, and the associated hydrothermal activity is about to shut down. Key Points - A regional bottom-simulating reflection (BSR) in the Guaymas Basin indicates a widespread occurrence of gas hydrates - The BSR derived thermal gradients show wavy patterns farther away from the spreading centre, indicating strong lateral heat flow variations - High sedimentation suppresses heat flow, while recent magmatic intrusion and fluid advection increase heat flow