Notes: We reconsider the potential energy surface of the He–LiH system recently examined by Gianturco and co-workers [F. A. Gianturco et al., Chem. Phys. 215, 227 (1997)]. We compute the He–LiH interaction energy at the CCSD(T) level using large correlation consistent atomic basis sets supplemented with bond functions. To capture the severe anisotropy of the He–LiH potential, we interpolate our ab initio points in the angular direction with cubic splines, then expand the splines in terms of Legendre polynomials. The resulting smooth potential surface differs substantially from that of Gianturco et al.; in particular, our attractive He–LiH well is more than twice as deep as that of Gianturco et al., with a He–LiH binding energy of De=176.7 cm−1. © 1999 American Institute of Physics.

Notes: [Auszug] JONES, in his interpretation of the activity cycle of the mosquito Culex pipiens fatigans Wied. in constant light (LL) following a light : dark (LD) regime of 12 h light and 12 h dark1, stated that it was possible to calculate that the first peak should have occurred about 18 h after light-on or 6 ...

Notes: [Auszug] At mid-ocean ridges, plate separation leads to upward advection and pressure-release partial melting of fertile mantle material; the melt is then extracted to the spreading centre and the residual depleted mantle flows horizontally away. In back-arc basins, the subducting slab is ...

Notes: [Auszug] OUR understanding of the processes by which continents rift and sea-floor spreading initiates is derived primarily from studies either of old passive margins and oceanic crust or of young regions of intra-continental extension where spreading has not yet started. It has been thought that ...

Notes: [Auszug] It is widely believed that the Lau basin opened as the Tonga ridge rifted and drifted away from the Lau ridge (Fig. 1), but no consensus exists as to how the crust of the Lau basin was formed. For more than twenty years, geologists and geophysic-ists have debated the relative importance of ...

Notes: Abstract PURPOSE: The aim of this study was to determine if local injection of bupivacaine after hemorrhoidal banding causes a decrease in pain and in the incidence of associated symptoms. METHODS: After hemorrhoidal banding, patients were randomly assigned to receive a local injection of bupivacaine with 1:200,000 epinephrine, an injection of normal saline, or no injection, just superior to each band. Pain was graded by the patient and by the study nurse within 30 minutes, and any associated symptoms were recorded. At intervals 6, 24, and 48 hours postbanding, the patient recorded pain, limitation of activities, and analgesic requirements. Associated symptoms while at home were recorded. RESULTS: Of 115 patients studied, 42 received bupivacaine injection, 42 received normal saline injection, and 31 received no injection. In patients receiving bupivacaine compared with no injection, within 30 minutes postbanding there was a significant reduction in pain graded by the patient (P=0.000002) and by the nurse (P=0.000005) and a significant reduction in incidence of nausea (P=0.01) and shaking (P=0.008). However, in the bupivacaine group compared with the other two groups, at the intervals of 6, 24, and 48 hours postbanding there was no sustained reduction in the severity of pain and no reduction in analgesic requirements or limitation of normal activities. In the week after banding, there was no difference between groups in symptoms of nausea, shaking, lightheadedness, urinary retention, or bleeding. CONCLUSIONS: Bupivacaine injection may be useful for reducing pain and associated symptoms long enough to tolerate a trip home from the outpatient department but does not show a sustained effect.

Notes: Abstract SeaMARC II sidescan (imagery and bathymetry) and seismic data reveal the morphology, sedimentary processes, and structural controls on submarine canyon development in the central Izu-Bonin forearc, south of Japan. Canyons extend up to 150 km across the forearc from the trench-slope break to the active volcanic arc. The canyons are most deeply incised (1200–1700 m) into the gentle gradients (1–2°) upslope on the outer arc high (OAH) and lose bathymetric expression on the steep (6–18°) inner trench-slope. The drainage patterns indicate that canyons are formed by both headward erosion and downcutting. Headward erosion proceeds on two scales. Initially, pervasive small-scale mass wasting creates curvilinear channels and pinnate drainage patterns. Large-scale slumping, evidenced by abundant crescent-shaped scarps along the walls and tributaries of Aoga Shima Canyon, occurs only after a channel is present, and provides a mechanism for canyon branching. The largest slump has removed 〉16 km3 of sediment from an ∼85 km2 area of seafloor bounded by scarps more than 200 m high and may be in the initial stages of forming a new canyon branch. The northern branch of Aoga Shima Canyon has eroded upslope to the flanks of the arc volcanoes allowing direct tapping of this volcaniclastic sediment source. Headward erosion of the southern branch is not as advanced but the canyon may capture sediments supplied by unconfined (non-channelized) mass flows. Oligocene forearc sedimentary processes were dominated by unconfined mass flows that created sub-parallel and continuous sedimentary sequences. Pervasive channel cut-and-fill is limited to the Neogene forearc sedimentary sequences which are characterized by migrating and unconformable seismic sequences. Extensive canyon formation permitting sediment bypassing of the forearc by canyon-confined mass flows began in the early Miocene after the basin was filled to the spill points of the OAH. Structural lows in the OAH determined the initial locus of canyon formation, and outcropping basement rocks have prevented canyon incision on the lower slope. A major jog in the canyon axis, linear tributaries, and a prominent sidescan lineament all trend NW-NNW, reflecting OAH basement influence on canyon morphology. This erosional fabric may reflect joint/fracture patterns in the sedimentary strata that follow the basement trends. Once the canyons have eroded down to more erosion-resistant levels, channel downcutting slows relative to lateral erosion of the canyon walls. This accounts for the change from a narrow canyon axis in the thickly sedimented forearc basin to a wider, more rugged canyon morphology near the OAH. About 9500 km3 of sediment has been eroded from the central, 200 km long, segment of the Izu-Bonin forearc by the formation of Aoga Shima, Myojin Sho and Sumisu Jima canyons. The volume of sediment presently residing in the adjacent trench, accretionary wedge, and lower slope terrace basin accounts for 〈25% of that eroded from the canyons alone. This implies that a large volume (〉3500 km3 per 100 km of trench, ignoring sediments input via forearc bypassing) has been subducted beneath the toe of the trench slope and the small accretionary prism. Unless this sediment has been underplated beneath the forearc, it has recycled arc material into the mantle, possibly influencing the composition of arc volcanism.

Notes: Abstract The Woodlark triple junction region, a topographically and structurally complex triangular area of Quaternary age, lies east of Simbo Ridge and southwest of the New Georgia island group, Solomon Islands, at the junction of the Pacific, Australian and Solomon Sea plates. SeaMARC II side-scan imagery and bathymetry in conjunction with seismic reflection profiles, 3.5 kHz records, and petrologic, magnetic and gravity data show that the active Woodlark spreading centre does not extend into this region. South of the triple junction region, the Woodlark spreading centre reoriented at about 2 Ma into a series of short ESE-trending segments. These segments continued to spread until about 0.5 Ma, when the lithosphere on their northern sides was transferred from the Solomon Sea plate to the Australian plate. Simultaneously the Simbo transform propagated northwards along the western side of the transferred lithosphere, forming a trench-trench-transform triple junction located NNW of Simbo island and a new leaky plate boundary segment that built Simbo Ridge. As the Pacific plate approached, the area east of northern Simbo Ridge was tilted northwards, sheared by dominantly right-lateral faults, elevated, and intruded by arc-related magmas to form Ghizo Ridge. Calc-alkalic magmas sourced beneath the Pacific plate built three large strato-volcanic edifices on the subducting Australian plate: Simbo at the northern end of Simbo Ridge, and Kana Keoki and Coleman seamounts on an extensional fracture adjoining the SE end of Ghizo Ridge. A sediment drape, supplied in part from Simbo and Kana Keoki volcanoes, mantles the east-facing slopes of northern Simbo and Ghizo Ridges and passes distally into sediment ponded in the trench adjoining the Pacific plate. As a consequence of plate convergence, parts of the sediment drape and pond are presently being deformed, and faults are dismembering Kana Keoki and Coleman seamounts. The Woodlark system differs from other modern or Tertiary ridge subduction systems, which show wide variation in character and behaviour. Existing models describing the consequences of ridge subduction are likely to be predictive in only a general way, and deduced rules for the behaviour of oceanic lithosphere in ridge subduction systems may not be generally applicable.

Notes: Abstract The Manus Basin in the eastern Bismarck Sea is a fastopening backarc basin behind the New Britain arc-trench system. Within the basin, motion between the Pacific and Bismarck plates about a pole located at 11° S, 145° E, occurs along three major leftlateral transform faults and a variety of extensional segments. We interpret SeaMARC II sidescan and other geophysical data to show that a Brunhes age plate reorganization created new extensional boundaries and a microplate between the NW-trending Willaumez, Djaul, and Weitin transforms. Two linked spreading segments formed in backarc basin crust between the Willaumez and Djaul transforms: the ESE-trending extensional transform zone (ETZ) in the west and the Manus spreading center (MSC) in the east. Positively magnetized crust on the MSC forms a wedge varying in width from 72 km at its southwest end to zero at its northeast tip, with corresponding Brunhes spreading rates varying from 92 mm/yr to zero. The MSC forms the northwestern boundary of the 100 km-scale Manus microplate and opens at 51°/m.y. about a pole near its apex at 3°02′S, 150°32′E. Opposite the MSC, bordering the arc margin of New Britain, the microplate is bound by a zone of broadly distributed strike slip motion, extension, and volcanism. Within this area, the Southern Rifts contain a series of grabens partially floored by lava flows. Left-lateral motion between the Pacific and Bismarck plates appears to drive the counterclockwise pivoting motion of the Manus microplate and the complementary wedge-like opening of the MSC and the Southern Rifts. The pivoting motion of the microplate has resulted in compressional areas along its NE and SW boundaries with the Pacific and Bismarck plates respectively. East of the microplate, between the Djaul and Weitin transforms and within the arc margin of New Ireland, another zone of broad extension referred to as the Southeast Rifts takes up opening in a pull-apart basin. There, en echelon volcanic ridges may be the precursors of spreading segments, but erupted lavas include calcalkaline volcanics. Kinematic modeling and marine geophysical observations indicate that the responses to similar amounts of extension in the eastern Manus Basin have varied as a function of the different types of pre-existing crust: arc crust tectonically stretched over a broad area whereas backarc crust underwent relatively little stretching before accommodating extension by seafloor spreading.

Notes: Abstract Four new bathymetric maps of the Tonga Trench and forearc between 14 °S and 27 °S display the important morphologic and structural features of this dynamic convergent margin. The maps document a number of important geologic features of the margin. Major normal faults and fault lineaments on the Tonga platform can be traced along and across the upper trench slope. Numerous submarine canyons incised in the landward slope of the trench mark the pathways of sediment transport from the platform to mid- and lower-slope basins. Discontinuities in the trench axis and changes in the morphology of the landward slope can be clearly documented and may be associated with the passage and subduction of the Louisville Ridge and other structures on the subducting Pacific Plate. Changes in the morphology of the forearc as convergence changes from normal in the south to highly-oblique in the north are clearly documented. The bathymetric compilations, gridded at 500- and 200-m resolutions and extending along ∼500 km of the landward trench slope and axis, provide complete coverage of the outer forearc from the latitude of the Louisville Ridge-Tonga Trench collision to the northern terminus of the Tonga Ridge. These maps should serve as a valuable reference for other sea-going programs in the region, particularly the Ocean Drilling Program (ODP) and the National Science Foundation MARGINS initiative.