Description: The formation of mud volcanoes in the Gulf of Cadiz is closely linked to diapirism in the deep subsurface. The Mercator mud volcano (MMV) is a rare example where diapiric emplacement, in addition to being key for upward fluid migration, is also an important zone for fluid and mineral diagenesis. The most intriguing findings in the near-surface muds of the MMV are extremely high salinities of up to 5.2 M of NaCl from diapiric and evaporitic halite dissolution and the occurrence of authigenic gypsum and anhydrite crystals, both of which have not been observed to date in the Gulf of Cadiz. Employing a thermodynamic model we elucidate how the interplay of temperature pulses, strong salinity gradients, and fluid flow dynamically drive mineral dissolution and re-formation. The strong increase in salinity in the pore fluids has important implications for thermodynamic equilibria by significantly lowering the activity of water, thereby raising the gypsum–anhydrite transition zone from 〉1 km to about 400 m sediment depth at the MMV. This transition is further shifted to immediately below the seafloor during intervals of active mud and fluid expulsion when the MV surface temperature is heated up to at least 30 °C. As a consequence, precipitation of authigenic gypsum near the sediment surface (1–2 mbsf) has been linked to the dissolution of evaporites below the MMV. More precisely, the mechanisms generating supersaturation in the ascending gypsum-saturated MMV fluids are (1) the slow and constant cooling of these fluids along the geothermal gradient during their ascent leading to formation of ubiquitous micro-crystals and (2) the more rapid cooling after a heat pulse or transport from greater and warmer depth during an active mud volcano phase leading to the precipitation of cm-scale gypsum crystals or even fist-size concretions. The MMV fluids approaching the salt diapir from farther below have experienced a genesis similar to those of other mud volcanoes in the Gulf of Cadiz located above deep-rooted faults. These processes include clay mineral dewatering, thermogenic degradation of organic matter and deep high-temperature leaching of terrigenous sediments or continental crust.

Description: Lithium concentration and isotope data (δ7Li) are reported for pore fluids from 18 cold seep locations together with reference fluids from shallow marine environments, a sediment-hosted hydrothermal system and two Mediterranean brine basins. The new reference data and literature data of hydrothermal fluids and pore fluids from the Ocean Drilling Program follow an empirical relationship between Li concentration and δ7Li (δ7Li = −6.0(±0.3) · ln[Li] + 51(±1.2)) reflecting Li release from sediment or rocks and/or uptake of Li during mineral authigenesis. Cold seep fluids display δ7Li values between +7.5‰ and +45.7‰, mostly in agreement with this general relationship. Ubiquitous diagenetic signals of clay dehydration in all cold seep fluids indicate that authigenic smectite–illite is the major sink for light pore water Li in deeply buried continental margin sediments. Deviations from the general relationship are attributed to the varying provenance and composition of sediments or to transport-related fractionation trends. Pore fluids on passive margins receive disproportionally high amounts of Li from intensely weathered and transported terrigenous matter. By contrast, on convergent margins and in other settings with strong volcanogenic input, Li concentrations in pore water are lower because of intense Li uptake by alteration minerals and, most notably, adsorption of Li onto smectite. The latter process is not accompanied by isotope fractionation, as revealed from a separate study on shallow sediments. A numerical transport-reaction model was applied to simulate Li isotope fractionation during upwelling of pore fluids. It is demonstrated that slow pore water advection (order of mm a−1) suffices to convey much of the deep-seated diagenetic Li signal into shallow sediments. If carefully applied, Li isotope systematics may, thus, provide a valuable record of fluid/mineral interaction that has been inherited several hundreds or thousands of meters below the actual seafloor fluid escape structure.

Description: Several known gas seep sites along the Hikurangi Margin off the east coast of New Zealand were surveyed by marine controlled source electromagnetic (CSEM) experiments. A bottom-towed electric dipole–dipole system was used to reveal the occurrence of gas hydrate and methane related to the seeps. The experiments were part of the international multidisciplinary research program “New Vents” carried out on German R/V Sonne in 2007 (cruise SO191) to study key parameters controlling the release and transformation of methane from marine cold vents and shallow gas hydrate deposits. Two CSEM lines have been surveyed over known seep sites on Opouawe Bank in the Wairarapa region off the SE corner of the North Island. The data have been inverted to sub-seafloor apparent resistivity profiles and one-dimensional layered models. Clearly anomalous resistivities are coincident with the location of two gas seep sites, North Tower and South Tower on Opouawe Bank. A layer of concentrated gas hydrate within the uppermost 100 m below the seafloor is likely to cause the anomalous resistivities, but free gas and thick carbonate crusts may also play a role. Seismic data show evidence of fault related venting which may also indicate the distribution of gas hydrates and/or authigenic carbonate. Geochemical profiles indicate an increase of methane flux and the formation of gas hydrate in the shallow sediment section around the seep sites. Takahe is another seep site in the area where active venting, higher heat flow, shallow gas hydrate recovered from cores, and seismic fault planes, but only moderately elevated resistivities have been observed. The reasons could be a) the gas hydrate concentration is too low, even though methane venting is evident, b) strong temporal or spatial variation of the seep activity, and c) the thermal anomaly indicates rather temperature driven fluid expulsion that hampers the formation of gas hydrate beneath the vent.

Description: This study combines sediment geochemical analysis, in situ benthic lander deployments and numerical modeling to quantify the biogeochemical cycles of carbon and sulfur and the associated rates of Gibbs energy production at a novel methane seep. The benthic ecosystem is dominated by a dense population of tube-building ampharetid polychaetes and conspicuous microbial mats were unusually absent. A 1D numerical reaction-transport model, which allows for the explicit growth of sulfide and methane oxidizing microorganisms, was tuned to the geochemical data using a fluid advection velocity of 14 cm yr−1. The fluids provide a deep source of dissolved hydrogen sulfide and methane to the sediment with fluxes equal to 4.1 and 18.2 mmol m−2 d−1, respectively. Chemosynthetic biomass production in the subsurface sediment is estimated to be 2.8 mmol m−2 d−1 of C biomass. However, carbon and oxygen budgets indicate that chemosynthetic organisms living directly above or on the surface sediment have the potential to produce 12.3 mmol m−2 d−1 of C biomass. This autochthonous carbon source meets the ampharetid respiratory carbon demand of 23.2 mmol m−2 d−1 to within a factor of 2. By contrast, the contribution of photosynthetically-fixed carbon sources to ampharetid nutrition is minor (3.3 mmol m−2 d−1 of C). The data strongly suggest that mixing of labile autochthonous microbial detritus below the oxic layer sustains high measured rates of sulfate reduction in the uppermost 2 cm of the sulfidic sediment (100–200 nmol cm−3 d−1). Similar rates have been reported in the literature for other seeps, from which we conclude that autochthonous organic matter is an important substrate for sulfate reducing bacteria in these sediment layers. A system-scale energy budget based on the chemosynthetic reaction pathways reveals that up to 8.3 kJ m−2 d−1 or 96 mW m−2 of catabolic (Gibbs) energy is dissipated at the seep through oxidation reactions. The microorganisms mediating sulfide oxidation and anaerobic oxidation of methane (AOM) produce 95% and 2% of this energy flux, respectively. The low power output by AOM is due to strong bioenergetic constraints imposed on the reaction rate by the composition of the chemical environment. These constraints provide a high potential for dissolved methane efflux from the sediment (12.0 mmol m−2 d−1) and indicates a much lower efficiency of (dissolved) methane sequestration by AOM at seeps than considered previously. Nonetheless, AOM is able to consume a third of the ascending methane flux (5.9 mmol m−2 d−1 of CH4) with a high efficiency of energy expenditure (35 mmol CH4 kJ−1). It is further proposed that bioenergetic limitation of AOM provides an explanation for the non-zero sulfate concentrations below the AOM zone observed here and in other active and passive margin sediments.