Beschreibung: [1] Fluid distribution in convergent margins is by most accounts closely related to tectonics. This association has been widely studied at accretionary prisms, but at half of the Earth's convergent margins, tectonic erosion grinds down overriding plates, and here fluid distribution and its relation to tectonics remain speculative. Here we present a new conceptual model for the hydrological system of erosional convergent margins. The model is based largely on new data and recently published observations from along the Middle America Trench offshore Nicaragua and Costa Rica, and it is consistent with observations from other erosional margins. The observations indicate that erosional margins possess previously unrecognized distinct hydrogeological systems: Most fluid contained in the sediment pores and liberated by early dehydration reactions drains from the plate boundary through a fractured upper plate to seep at the seafloor across the slope, rather than migrating along the décollement toward the deformation front as described for accretionary prisms. The observations indicate that the relative fluid abundance across the plate-boundary fault zone and fluid migration influence long-term tectonics and the transition from aseismic to seismogenic behavior. The segment of the plate boundary where fluid appears to be more abundant corresponds to the locus of long-term tectonic erosion, where tectonic thinning of the overriding plate causes subsidence and the formation of the continental slope. This correspondence between observations indicates that tectonic erosion is possibly linked to the migration of overpressured fluids into the overriding plate. The presence of overpressured fluids at the plate boundary is compatible with the highest flow rates estimated at slope seeps. The change from aseismic to seismogenic behavior along the plate boundary of the erosional margin begins where the amount of fluid at the fault declines with depth, indicating a control on interplate earthquakes. A previously described similar observation along accreting plate boundaries strongly indicates that fluid abundance exerts a first-order control on interplate seismogenesis at all types of subduction zones. We hypothesize that fluid depletion with depth increases grain-to-grain contact, increasing effective stress on the fault, and modifies fault zone architecture from a thick fault zone to a narrower zone of localized slip.

Beschreibung: A joint interpretation of swath bathymetric, seismic refraction, wide-angle reflection, and multichannel seismic data was used to derive a detailed tomographic image of the Nazca-South America subduction zone system offshore southern Arauco peninsula, Chile at similar to 38 degrees S. Here, the trench basin is filled with up to 2.2 km of sediments, and the Mocha Fracture Zone (FZ) is obliquely subducting underneath the South American plate. The velocity model derived from the tomographic inversion consists of a similar to 7-km-thick oceanic crust and shows P wave velocities typical for mature fast spreading crust in the seaward section of the profile, with uppermost mantle velocities >8.4 km s(-1). In the trench-outer rise area, the top of incoming oceanic plate is pervasively fractured and likely hydrated as shown by extensional faults, horst-and-graben structures, and a reduction of both crustal and mantle velocities. These slow velocities are interpreted in terms of extensional bending-related faulting leading to fracturing and hydration in the upper part of the oceanic lithosphere. The incoming Mocha FZ coincides with an area of even slower velocities and thinning of the oceanic crust (10-15% thinning), suggesting that the incoming fracture zone may enhance the flux of chemically bound water into the subduction zone. Slow mantle velocities occur down to a maximum depth of 6-8 km into the upper mantle, where mantle temperatures are estimated to be 400-430 degrees C. In the overriding plate, the tomographic model reveals two prominent velocity transition zones characterized by steep lateral velocity gradients, resulting in a seismic segmentation of the marine fore arc. The margin is composed of three main domains: (1) a similar to 20 km wide frontal prism below the continental slope with Vp 〈= 3.5 km s(-1), (2) a similar to 50 km area with Vp = 4.5-5.5 km s(-1), interpreted as a paleoaccretionary complex, and (3) the seaward edge of the Paleozoic continental framework with Vp >= 6.0 km s(-1). Frontal prism velocities are noticeably lower than those found in the northern erosional Chile margin, confirming recent accretionary processes in south central Chile.

Beschreibung: A seismic wide‐angle and refraction experiment was conducted offshore of Nicaragua in the Middle American Trench to investigate the impact of bending‐related normal faulting on the seismic properties of the oceanic lithosphere prior to subduction. On the basis of the reflectivity pattern of multichannel seismic reflection (MCS) data it has been suggested that bending‐related faulting facilitates hydration and serpentinization of the incoming oceanic lithosphere. Seismic wide‐angle and refraction data were collected along a transect which extends from the outer rise region not yet affected by subduction into the trench northwest of the Nicoya Peninsula, where multibeam bathymetric data show prominent normal faults on the seaward trench slope. A tomographic joint inversion of seismic refraction and wide‐angle reflection data yield anomalously low seismic P wave velocities in the crust and uppermost mantle seaward of the trench axis. Crustal velocities are reduced by 0.2–0.5 km s−1 compared to normal mature oceanic crust. Seismic velocities of the uppermost mantle are 7.6–7.8 km s−1 and hence 5–7% lower than the typical velocity of mantle peridotite. These systematic changes in P wave velocity from the outer rise toward the trench axis indicate an evolutionary process in the subducting slab consistent with percolation of seawater through the faulted and fractured lithosphere and serpentinization of mantle peridotites. If hydration is indeed affecting the seismic properties of the mantle, serpentinization might be reaching 12–17% in the uppermost 3–4 km of the mantle, depending on the unknown degree of fracturing and its impact on the elastic properties of the subducting lithosphere.

Beschreibung: Large-scale landslides occur on the flanks of many volcanic oceanic islands worldwide. None have taken place in historical time, but their geohazard potential, especially their ability to generate tsunamis, is large. The Cape Verde Islands are a group of 10 large and several smaller volcanic islands off the coast of West Africa between 15 and 17°N. A single flank landslide has previously been described from the island of Fogo, but systematic analysis of the Cape Verde group has until now been lacking. This paper describes and interprets a multibeam bathymetry data set covering the slopes of the western Cape Verde Islands, including those of the islands with the most recent volcanic activity, Fogo in the southwest, and Santo Antao in the northwest. All of the larger islands show evidence of large flank landslides, although only Fogo and the southwest part of Santo Antao have failed in the last 400 ka. Tope de Coroa, the volcano at the southwest end of Santo Antao, has been inactive for the past 170 ka and is judged to have a low landslide potential unless volcanic activity resumes. In contrast, there would seem to be a high probability of a future east directed landslide on Fogo, from the area of the highly active Pico do Fogo volcano, although it is impossible to predict a timescale for such an event. A tsunami generated by such a landslide could have a catastrophic effect on the adjacent island of Santiago and possibly even farther afield on the West African coast.

Beschreibung: We combine structural balancing with thermal and strength-envelope analysis of the Cascadia accretionary wedge to determine the influence thermal gradient has on the structure of the prism. BSR-derived heat flow in the Cascadia accretionary margin decreases from 90–110 mW/m2 at the deformation front to 45–70 mW/m2 in the upper slope. Extension of the thermal gradient to the top of the oceanic crust shows that the base of the prism reaches temperatures between 150–200°C and 250–300°C at the deformation front and the base of the upper slope, respectively. This high thermal gradient favors the development of a vertical strain gradient, which is accommodated by heterogeneous deformation of the accretionary prism. This process produces two overlying thrust wedges, a basal duplex and an overlying landward- or seaward-vergent imbricate stack. The thermal structure also influences the deformation distribution and structural style along the shortening direction. Initiation of plastic deformation at the base of the prism below the Cascadia upper slope affects the wedge geometry, changing its taper angle and favoring the development of a midcrustal duplex structure that propagates seaward as a dynamic backstop. Uplift related with this underplating process is accompanied with deep incision of submarine canyons, sliding and normal faulting in the upper slope. Heterogeneous deformation accommodated by the development of transfer faults separating landward-vergent from seaward-vergent domains is also observed along the margin. Landward-vergent areas accommodate 30–40% shortening at the front of the wedge, while in the narrower and thicker seaward-vergent segments shortening occurs mostly by underplating below the upper slope.

Beschreibung: The Cape Verde Islands are located on a mid-plate topographic swell and are thought to have formed above a deep mantle plume. Wide-angle seismic data have been used to determine the crustal and uppermost mantle structure along a ~ 440 km long transect of the archipelago. Modelling shows that ‘normal’ oceanic crust, ~ 7 km in thickness, exists between the islands and is gently flexed due to volcano loading. There is no direct evidence for high density bodies in the lower crust or for an anomalously low density upper mantle. The observed flexure and free-air gravity anomaly can be explained by volcano loading of a plate with an effective elastic thickness of 30 km and a load and infill density of 2600 kg m− 3. The origin of the Cape Verde swell is poorly understood. An elastic thickness of 30 km is expected for the ~ 125 Ma old oceanic lithosphere beneath the islands, suggesting that the observed height of the swell and the elevated heat flow cannot be attributed to thermal reheating of the lithosphere. The lack of evidence for high densities and velocities in the lower crust and low densities and velocities in the upper mantle, suggests that neither a crustal underplate or a depleted swell root are the cause of the shallower than expected bathymetry and that, instead, the swell is supported by dynamic uplift associated with the underlying plume.

Beschreibung: We examine the micro-earthquake seismicity recorded by two temporary arrays of ocean bottom seismometers on the outer rise offshore southern Chile on young oceanic plate of ages 14 Ma and 6 Ma, respectively. The arrays were in operation from December 2004–January 2005 and consisted of 17 instruments and 12 instruments, respectively. Approximately 10 locatable events per day were recorded by each of the arrays. The catalogue, which is complete for magnitudes above 1.2–1.5, is characterized by a high b value, i.e., a high ratio of small to large events, and the data set is remarkable in that a large proportion of the events form clusters whose members show a high degree of waveform similarity. The largest cluster thus identified consisted of 27 similar events (average inter-event correlation coefficient 〉 0.8 for a 9.5 s window), and waveform similarity persists far into the coda. Inter-event spacing is irregular, but very short waiting times of a few minutes are far more common than expected from a Poisson distribution. Seismicity with these features (high b value, large number of similar events with short waiting times) is typical of swarm activity, which, based on empirical evidence and theoretical considerations, is generally thought to be driven by fluid pressure variations. Because no pronounced outer rise bulge exists on the very young plate in the study region, it is unlikely that melt is accessible from decompression melting or opening of cracks. A fluid source related to processes at the nearby ridge is conceivable for the younger segment but less likely for the older one. We infer that the fluid source could be seawater, which enters through fractures in the crust. Most of the similar-earthquake clusters are within the crust, but some of them locate significantly below the Moho. If our interpretation is correct, this implies that water is present within the mantle. Hydration of the mantle is also indicated by a decrease of Pn velocities below the outer rise seen on a refraction profile through one of the arrays [Contreras-Reyes, E., Grevemeyer, I., Flueh, E.R., Scherwath, M., Heesemann, M., 2007. Alteration of the subducting oceanic lithosphere at the southern central Chile trench-outer rise. Geochem., Geophys. Geosyst. 8, Q07003.]. The deepest events within the array on the 6 Ma old plate occur where the temperature reaches 500–600 °C, consistent with the value observed for large intraplate earthquakes within the mantle (650 °C), suggesting that the maximum temperature at which these fluid-mediated micro-earthquakes can occur is similar or identical to that of large earthquakes.