Description: Seismic investigations across the convergent Sunda margin off Indonesia provide a detailed image of the crustal architecture of the Sunda plate boundary. The combined analysis and interpretation of wide-angle and reflection seismic data along two coincident profiles across the subduction zone are complemented by additional lines within the forearc domain, which yield some three-dimensional (3-D) constraints on the velocity-depth structure across the margin. A detailed cross section of the subduction zone is presented, which is confirmed by supplementary gravity modeling. The Sunda convergence zone is a prime example of an accretionary margin, where sediment accretion has led to the formation of a massive accretionary prism, with a total width of 〉110 km between the trench and the forearc basin. It is composed of a frontal wedge which documents ongoing accretion and a fossil part behind the present backstop structure which constitutes the outer high. Moderate seismic velocities derived from wide-angle modeling indicate a sedimentary composition of the outer high. The subducting oceanic slab is traced to a depth of almost 30 km underneath the accretionary prism. The adjacent forearc domain is characterized by a pronounced morphological basin which is underlain by a layer of increased seismic velocities and a shallow upper plate Moho at 16 km depth. We speculate that remnant fragments of oceanic crust might be involved in the formation of this oceanic-type crust found at the leading edge of the upper plate beneath the forearc basin.

Description: A seismic wide-angle section offshore Costa Rica is presented across the boundary between oceanic crust generated at the East Pacific rise (EPR) and at the Galápagos spreading center (GSC) as indicated by magnetic anomalies. This suture, where the Farallon plate broke up ∼23 Ma ago, is marked by pronounced velocity variations throughout the crust including a low-velocity body in the lower crust. This body is well constrained by refracted waves above the inversion zone and by strong PmP reflections from its lower boundary. The distinctness of this body and the local gravity field point to an igneous intrusion rather than serpentinized rock. Typical oceanic crust is found adjacent to the suture zone.

Description: Introduction Since the discovery of ‘bright spots’ associated with hydrocarbon deposits, ever increasing interest in determining lithological subsurface parameters has been a driving force for technological development in the hydrocarbon exploration industry. Quantification of lithological parameters is of utmost importance for reservoir prediction and monitoring. Amongst various attempts to determine these, attribute analysis of pwave data and the direct observation of shear wave data are the most visible and successful methods applied. The direct observation of shear waves in the marine environment has been attempted by several means, mainly using ocean bottom cables (OBC) that have three-component geophones (3C) and a hydrophone in addition (thus 4C in total). Some manufacturers offer two component geophones with only one horizontal component. These cables are laid out on the seafloor, sometimes even buried using specialized tools like ROVs (remotely operated vehicles). Data transfer is through the cables as in streamers or land operations, recording is made on a boat or platform where the cable terminates. Geophones are housed in tubes with a self-levelling gimballed mounting system, damped by a viscous fluid. This technique is regarded as proven technology and has been widely accepted. Especially in production areas with many man-made obstacles, this technique also offers a safe operation, and is especially suitable for monitoring purposes (4D–4C seismic). Any desired geometry and density of receivers can be laid out. Direct shear wave observations have been made by several academic institutions, both for active seismic exploration as well as for passive seismological monitoring of earthquakes. These institutions have built ocean bottom seismometers (OBS), which are also four component, two sensor instruments. Unlike OBC, they are autonomously lowered to the seafloor, record within specified time windows, and are later brought back to the surface. Amongst the various instruments designed over the past decades is the OBS range built at GEOMAR, which – due to its modular design – has been used for a wide range of applications.