Description: We present geochemical data collected from volcanic ash-bearing sediments on the upper slope of the northern Hikurangi margin during the RV SONNE SO247 expedition in 2016. Gravity coring and seafloor drilling with the MARUM-MeBo200 allowed for collection of sediments down to 105 meters below seafloor (mbsf). Release of dissolved Sr2+with isotopic composition enriched in 86Sr (87Sr/86Sr minimum = 0.708461 at 83.5 mbsf) is indicative of ash alteration. This reaction releases other cations in the 30-70 mbsf depth interval as reflected by maxima in pore-water Ca2+and Ba2+concentrations. In addition, we posit that Fe(III) in volcanogenic glass serves as an electron acceptor for methane oxidation, a reaction that releases Fe2+measured in the pore fluids to a maximum concentration of 184 μM. Several lines of evidence support our proposed coupling of ash alteration with Fe-mediated anaerobic oxidation of methane (Fe-AOM) beneath the sulfate-methane transition (SMT), which lies at ∼7 mbsf at this site. In the ∼30-70 mbsf interval, we observe a concurrent increase in Fe2+and a depletion of CH4with a well-defined decrease in δ13C-CH4values indicative of microbial fractionation of carbon. The negative excursions in δ13C values of both DIC and CH4are similar to that observed by sulfate-driven AOM at low SO2−4concentrations, and can only be explained by the microbially-mediated carbon isotope equilibration between CH4and DIC. Mass balance considerations reveal that the iron cycled through the coupled ash alteration and AOM reactions is consumed as authigenic Fe-bearing minerals. This iron sink term derived from the mass balance is consistent with the amount of iron present as carbonate minerals, as estimated from sequential extraction analyses. Using a numerical modeling approach we estimate the rate of Fe-AOM to be on the order of 0.4μmol cm−2yr−1, which accounts for ∼12% of total CH4removal in the sediments. Although not without uncertainties, the results presented reveal that Fe-AOM in ash-bearing sediments is significantly lower than the sulfate-driven CH4consumption, which at this site is 3.0μmol cm−2yr−1. We highlight that Fe(III) in ash can potentially serve as an electron acceptor for methane oxidation in sulfate-depleted settings. This is relevant to our understanding of C-Fe cycling in the methanic zone that typically underlies the SMT and could be important in supporting the deep biosphere.

Description: Shallow seabed depressions attributed to focused fluid seepage, known as pock- marks, have been documented in all continental margins. In this study, we dem- onstrate how pockmark formation can be the result of a combination of multiple factors— fluid type, overpressures, seafloor sediment type, stratigraphy and bot- tom currents. We integrate multibeam echosounder and seismic reflection data, sediment cores and pore water samples, with numerical models of groundwa- ter and gas hydrates, from the Canterbury Margin (off New Zealand). More than 6800 surface pockmarks, reaching densities of 100 per km2, and an undefined number of buried pockmarks, are identified in the middle to outer shelf and lower continental slope. Fluid conduits across the shelf and slope include shal- low to deep chimneys/pipes. Methane with a biogenic and/or thermogenic origin is the main fluid forming flow and escape features, although saline and fresh- ened groundwaters may also be seeping across the slope. The main drivers of fluid flow and seepage are overpressure across the slope generated by sediment loading and thin sediment overburden above the overpressured interval in the outer shelf. Other processes (e.g. methane generation and flow, a reduction in hydrostatic pressure due to sea- level lowering) may also account for fluid flow and seepage features, particularly across the shelf. Pockmark occurrence coin- cides with muddy sediments at the seafloor, whereas their planform is elongated by bottom currents.

Description: The existence of free gas and gas hydrate in the pore spaces of marine sediments causes changes in acoustic velocities that overprint the background lithological velocities of the sediments themselves. Much previous work has determined that such velocity overprinting, if sufficiently pronounced, can be resolved with conventional velocity analysis from long-offset, multichannel seismic data. We used 2D seismic data from a gas hydrate province at the southern end of New Zealand’s Hikurangi subduction margin to describe a workflow for highresolution velocity analysis that delivered detailed velocity models of shallow marine sediments and their coincident gas hydrate systems. The results showed examples of pronounced low-velocity zones caused by free gas ponding beneath the hydrate layer, as well as high-velocity zones related to gas hydrate deposits. For the seismic interpreter of a gas hydrate system, the velocity results represent an extra “layer” for interpretation that provides important information about the distribution of free gas and gas hydrate. By combining the velocity information from the seismic transect with geologic samples of the seafloor and an understanding of sedimentary processes, we have determined that high gas hydrate concentrations preferentially form within coarse-grained sediments at the proximal end of the Hikurangi Channel. Finer grained sediments expected elsewhere along the seismic transect might preclude the deposition of similarly high gas hydrate concentrations away from the channel.

Description: The imbricated frontal wedge of the central Hikurangi subduction margin is characteristic of wide (ca. 150 km), poorly drained and over pressured, low taper (not, vert, similar 4°) thrust systems associated with a relatively smooth subducting plate, a thick trench sedimentary sequence (not, vert, similar 3–4 km), weak basal décollement, and moderate convergence rate (not, vert, similar 40 mm/yr). New seismic reflection and multibeam bathymetric data are used to interpret the regional tectonic structures, and to establish the geological framework for gas hydrates and fluid seeps. We discuss the stratigraphy of the subducting and accreting sequences, characterize stratigraphically the location of the interplate décollement, and describe the deformation of the upper plate thrust wedge together with its cover sequence of Miocene to Recent shelf and slope basin sediments. We identify approximately the contact between an inner foundation of deforming Late Cretaceous and Paleogene rocks, in which widespread out-of-sequence thrusting occurs, and a 65–70 km-wide outer wedge of late Cenozoic accreted turbidites. Although part of a seamount ridge is presently subducting beneath the deformation front at the widest part of the margin, the morphology of the accretionary wedge indicates that frontal accretion there has been largely uninhibited for at least 1–2 Myr. This differs from the offshore Hawkes Bay sector of the margin to the north where a substantial seamount with up to 3 km of relief has been subducted beneath the lower margin, resulting in uplift and complex deformation of the lower slope, and a narrow (10–20 km) active frontal wedge. Five areas with multiple fluid seep sites, referred to informally as Wairarapa, Uruti Ridge, Omakere Ridge, Rock Garden, and Builders Pencil, typically lie in 700–1200 m water depth on the crests of thrust-faulted, anticlinal ridges along the mid-slope. Uruti Ridge sites also lie in close proximity to the eastern end of a major strike-slip fault. Rock Garden sites lie directly above a subducting seamount. Structural permeability is inferred to be important at all levels of the thrust system. There is a clear relationship between the seeps and major seaward-vergent thrust faults, near the outer edge of the deforming Cretaceous and Paleogene inner foundation rocks. This indicates that thrust faults are primary fluid conduits and that poor permeability of the Cretaceous and Paleogene inner foundation focuses fluid flow to its outer edge. The sources of fluids expelling at active seep sites along the middle slope may include the inner parts of the thrust wedge and subducting sediments below the décollement. Within anticlinal ridges beneath the active seep sites there is a conspicuous break in the bottom simulating reflector (BSR), and commonly a seismically-resolvable shallow fault network through which fluids and gas percolate to the seafloor. No active fluid venting has yet been recognized over the frontal accretionary wedge, but the presence of a widespread BSR, an extensive protothrust zone (〉 200 km by 20 km) in the Hikurangi Trough, and two unconfirmed sites of possible previous fluid expulsion, suggest that the frontal wedge could be actively dewatering. There are presently no constraints on the relative fluid flux between the frontal wedge and the active mid-slope fluid seeps. Article Outline

Description: Submarine spreading is a type of mass movement that involves the extension and fracturing of a thin surficial layer of sediment into coherent blocks and their finite displacement on a gently sloping slip surface. Its characteristic seafloor signature is a repetitive pattern of parallel ridges and troughs oriented perpendicular to the direction of mass movement. We map ~30 km2 of submarine spreads on the upper slope of the Hikurangi margin, east of Poverty Bay, North Island, New Zealand, using multibeam echosounder and 2D multichannel seismic data. These data show that spreading occurs in thin, gently-dipping, parallel-bedded clay, silt and sandy sedimentary units deposited as lowstand clinoforms. More importantly, high-amplitude and reverse polarity seismic reflectors, which we interpret as evidence of shallow gas accumulations, occur extensively in the fine sediments of the upper continental slope, but are either significantly weaker or entirely absent where the spreads are located. We use this evidence to propose that shallow gas, through the generation of pore pressure, has played a key role in establishing the failure surface above which submarine spreading occurred. Additional dynamic changes in pore pressure could have been triggered by a drop in sea level during the Last Glacial Maximum and seismic loading.

Description: The southern Tuaheni Landslide Complex (TLC) at the Hikurangi subduction margin displays distinctive morphological features along its distribution over the Tuaheni slope offshore Gisborne, New Zealand. We here present first analyses of a gravity core transect that systematically samples surficial sediments from the source area to the toe of this landslide complex, thus providing important new insight into shallow lithological variation in the slide complex. Geophysical and geochemical core logs and core descriptions form the basis for a characterization of representative sediment successions that are indicative of the respective slope segment of recovery. Our results show that the lithology of surficial sediments varies significantly along the length of the landslide complex. Depending on the slope segment observed, this variation includes post-Last Glacial Maximum (LGM) outer-shelf sediments, and hemipelagic drape and near-surface reworked debris avalanche deposits, as well as multiple intercalated thinner turbidites and tephra layers at the distal end of the profile. Lithological downslope variability suggests ongoing mass transport events through the late Holocene that were likely to have been limited to small mud-turbidite flows. Integration with acoustic sub-bottom imagery reveals the presence of multiple stacked mass-transport deposits at depth, contrasting with previous interpretations of a single parent failure.