In:
Defect and Diffusion Forum, Trans Tech Publications, Ltd., Vol. 426 ( 2023-06-06), p. 93-114
Abstract:
Bobbin friction stir welding (BT-FSW) is a variant of the conventional friction stir welding (C-FSW). This method has been applied of welding high density polyethylene (HDPE) plates; where a rotating symmetrical tool causes a fully penetrated bond, it can weld the upper and lower surface of the work-piece in the same pass. BT-FSW process involves complex heat generation and HDPE flow, which directly affects on the weld area and on mechanical properties of welded joint. Heat generation and material flow during BT-FSW are significantly affected by the tool design features, process parameters and mechanical behavior of work piece materials. Studying the temperature of polyethylene sheets welded by BT-FSW can help in analyzing the mechanism of weld formation and also can provide theoretical guidance for the tool design, process parameter selection and even new process development. In the unique work described in this paper, the 11.4 mm-thick HDPE plates were welded successfully by bobbin-tool friction stir welding. Measurements of the material temperatures were performed by thermocouples which are placed near and at the weld seam. The weld quality was determined in terms of no defects in the stir zone and the tensile strength of the joint. It was found that considerable melting occurred between the rotating shoulders and on the trailing side of the rotating pin. Movement of the molten material by the rotating tool created a very black band in the stir zone. Thermocouples measurements indicated that the temperatures were higher on the advancing side (AS) compared to those on the retreating side (RS). Tensile tests and hardness measurements were performed on welded and seamless sheet samples. The results were analyzed to compare the mechanical properties. To demonstrate the variation in micromechanical properties between welded and seamless sheet samples, micro hardness (HV) testing was used to explain the difference. The HV of the HDPE plates weld by BT-FSW, were relatively symmetrical with respect to the parting line. The maximum hardness levels were reached in the weld bead at around 66 HV in the welded nugget; there was a rise in the level of hardness, in particular at retreating side (RS) and at advancing side (AS) where the value reached 68.60 HV.
Type of Medium:
Online Resource
ISSN:
1662-9507
Language:
Unknown
Publisher:
Trans Tech Publications, Ltd.
Publication Date:
2023
detail.hit.zdb_id:
2051135-8
