Description: Marine controlled source electromagnetic (CSEM) data have been collected to investigate methane seep sites and associated gas hydrate deposits at Opouawe Bank on the southern tip of the Hikurangi Margin, New Zealand. The bank is located in about 1000 m water depth within the gas hydrate stability field. The seep sites are characterized by active venting and typical methane seep fauna accompanied with patchy carbonate outcrops at the seafloor. Below the seeps, gas migration pathways reach from below the bottom-simulating reflector (at around 380 m sediment depth) toward the seafloor, indicating free gas transport into the shallow hydrate stability field. The CSEM data have been acquired with a seafloor-towed, electric multi-dipole system measuring the inline component of the electric field. CSEM data from three profiles have been analyzed by using 1-D and 2-D inversion techniques. High-resolution 2-D and 3-D multichannel seismic data have been collected in the same area. The electrical resistivity models show several zones of highly anomalous resistivities (〉50 Ωm) which correlate with high amplitude reflections located on top of narrow vertical gas conduits, indicating the coexistence of free gas and gas hydrates within the hydrate stability zone. Away from the seeps the CSEM models show normal background resistivities between ~1 and 2 Ωm. Archie's law has been applied to estimate gas/gas hydrate saturations below the seeps. At intermediate depths between 50 and 200 m below seafloor, saturations are between 40 and 80% and gas hydrate may be the dominating pore filling constituent. At shallow depths from 10 m to the seafloor, free gas dominates as seismic data and gas plumes suggest.

Description: The MARCAN project, launched last January, is working to fill a gap in our knowledge of how freshwater flowing underground shapes and alters the continental margins.

Description: The study of offshore freshened groundwater (OFG) is gaining importance due to population growth and environmental pressure on coastal water resources. Marine controlled source electromagnetic (CSEM) methods can effectively map the spatial extent of OFG systems using electrical resistivity as a proxy. Integrating these resistivity models with sub-surface properties, such as host-rock porosity, allows for estimates of pore-water salinity. However, evaluating the uncertainty in pore-water salinity using resistivity models obtained from deterministic inversion approaches presents challenges, as they provide only one best-fit model, with no associated estimate of uncertainty. To address this limitation, we employ trans-dimensional Markov-Chain Monte-Carlo inversion on marine time-domain CSEM data, acquired in the Canterbury Bight, New Zealand. We integrate resistivity posterior probability distributions with borehole and seismic reflection data to estimate pore-water salinity with corresponding uncertainty estimates. The results highlight a low-salinity groundwater body in the center of the survey area, hosted by consecutive silty- and fine-sand layers approximately 20–60 km from the coast. The posterior probability distribution of resistivity models indicates freshening of the OFG body toward the shoreline within a permeable, coarse-sand layer 40–150 m beneath the seafloor, suggesting an active connection between the OFG body and the terrestrial groundwater system. The approach demonstrates how Bayesian inversion constrains the uncertainties in resistivity models and subsequently in pore-water salinity estimates. Our findings highlight the potential of Bayesian inversion to enhance our understanding of OFG systems and provide uncertainty constraints for hydrogeological modeling, thereby contributing to sustainable water resource development. Key Points A Bayesian workflow is employed to evaluate uncertainty in pore-water salinity estimates Offshore groundwater in Canterbury Bight stores freshened pore-water in fine-grained sediments, likely extending from the onshore aquifer Correlation between pore-water salinities and seismic-derived stratigraphy provides boundary conditions for hydrogeological modeling Plain Language Summary Geophysical methods that measure the electromagnetic properties of the Earth are effective in investigating freshwater sources beneath the seafloor. By combining the geophysical and geological information, we can better assess the quality of this groundwater. In this study, we develop a workflow that uses statistical methods to integrate electromagnetic observations with borehole and acoustic measurements along the eastern coast of the South Island of New Zealand. We aim to improve our understanding of the groundwater quality beneath the seafloor. Our research confirms the presence of freshened groundwater within the sandy seafloor up to 60 km from the coastline. Importantly, our observations indicate that the groundwater quality increases toward the coast. These findings are significant as they enhance the hydrogeological modeling of the groundwater system and suggest its potential as a source of freshwater.

Description: Although marine controlled source electromagnetic (CSEM) methods are effective for investigating offshore freshened groundwater (OFG) systems, interpreting the spatial extent and salinity of OFG remains challenging. Integrating CSEM resistivity models with information on sub-surface properties, such as host-rock porosity, allows for estimates of pore-water salinity. However, deterministic inversion approaches pose challenges in quantitatively analyzing these estimates as they provide only one best-fit model with no associated estimate of model parameter uncertainty. To address this limitation, we employ a trans-dimensional Markov-Chain Monte-Carlo inversion on marine CSEM data, under the assumption of horizontal stratification, collected from the Canterbury Bight, New Zealand. We integrate the resulting posterior distributions of electrical resistivity with borehole and seismic reflection data to quantify pore-water salinity with uncertainty estimates. The results reveal a low-salinity groundwater body in the center of the survey area at varying depths, hosted by consecutive silty- and fine-sand layers approximately 20 to 60 km from the coast. These observations support the previous study’s results obtained through deterministic 2-D inversion and suggest freshening of the OFG body closer to the shore within a permeable, coarse-sand layer 40 to 150 m beneath the seafloor. This implies a potential active connection between the OFG body and the terrestrial groundwater system. We demonstrate how the Bayesian approach constrains the uncertainties in resistivity models and subsequently in pore-water salinity estimates. Our findings highlight the potential of Bayesian inversions in enhancing our understanding of OFG systems, providing crucial boundary conditions for hydrogeological modeling and sustainable water resource development.

Description: Electromagnetic loop systems rely on the use of non‐conductive materials near the sensor to minimize bias effects superimposed on measured data. For marine sensors, rigidity, compactness, and ease of platform handling are essential. Thus, commonly a compromise between rigid, cost‐effective, and non‐conductive materials (e.g. stainless steel versus fiberglass composites) needs to be found. For systems dedicated to controlled‐source electromagnetic measurements, a spatial separation between critical system components and sensors may be feasible, whereas compact multi‐sensor platforms, remotely operated vehicles, and autonomous unmanned vehicles require the use of electrically conductive components near the sensor. While data analysis and geological interpretations benefit vastly from each added instrument and multidisciplinary approaches, this introduces a systematic and platform immanent bias in the measured electromagnetic data. In this scope we present two comparable case studies targeting loop‐source electromagnetic applications in both time and frequency domain: the MARTEMIS time domain system trades the compact design for a clear separation of 15 m between an upper fiberglass frame, holding most critical titanium system components, and a lower frame with its coil and receivers. In case of the GOLDEN EYE frequency domain profiler, the compact and rigid design is achieved by a circular fiberglass platform, carrying the transmitting and receiving coils, as well as several titanium housings and instruments. In this study, we analyze and quantify the quasi‐static influence of conductive objects on time and frequency domain coil systems by applying an analytically and experimentally verified 3D finite element model. Moreover, we present calibration and optimization procedures to minimize bias inherent in the measured data. The numerical experiments do not only show the significance of the bias on the inversion results, but also the efficiency of a system calibration against the analytically calculated response of a known environment. The remaining bias after calibration is a time/frequency dependent function of seafloor conductivity, which doubles the commonly estimated noise‐floor from 1% to 2%, decreasing the sensitivity and resolution of the devices. By optimizing size and position of critical conductive system components (e.g. titanium housings) and/or modifying the transmitter/receiver geometry, we significantly reduce the effect of this residual bias on the inversion results as demonstrated by 3D‐modelling. These procedures motivate the opportunity to design dedicated, compact, low‐bias platforms and provide a solution for autonomous and remotely steered designs by minimizing their effect on the sensitivity of the controlled‐source electromagnetic sensor.

Description: First reported in the 1960s, offshore freshened groundwater (OFG) has now been documented in most continental margins around the world. In this review we compile a database documenting OFG occurrences and analyse it to establish the general characteristics and controlling factors. We also assess methods used to map and characterise OFG, identify major knowledge gaps and propose strategies to address them. OFG has a global volume of 1 million km3; it predominantly occurs within 55 km of the coast and down to a water depth of 100 m. OFG is mainly hosted within siliciclastic aquifers on passive margins and recharged by meteoric water during Pleistocene sea‐level lowstands. Key factors influencing OFG distribution are topography‐driven flow, salinisation via haline convection, permeability contrasts, and the continuity/connectivity of permeable and confining strata. Geochemical and stable isotope measurements of pore waters from boreholes have provided insights into OFG emplacement mechanisms, while recent advances in seismic reflection, electromagnetic surveys and mathematical models have improved our understanding of OFG geometry and controls. Key knowledge gaps, such as the extent and function of OFG, and the timing of their emplacement, can be addressed by the application of isotopic age tracers, joint inversion of electromagnetic and seismic reflection data, and development of three‐dimensional hydrological models. We show that such advances, combined with site‐specific modelling, are necessary to assess the potential use of OFG as an unconventional source of water and its role in sub‐seafloor geomicrobiology.

Description: Carbonate lithologies host considerable quantities of the Earth’s freshwater resources and partially supply a quarter of the global population with drinkable water. Carbonates constitute substantial amounts of the global coastlines, yet it is not known if and how they can sustain freshened groundwater offshore. Here, we use controlled source electromagnetic, seismic reflection, and core sample data to derive a lithological model for the eastern margin of the Maltese Islands and identify four distinct resistivity anomalies within the Upper Coralline Limestone, Globigerina Limestone, and Blue Clay formations. The anomalies hosted in the former are likely associated to low porosities, whereas the anomaly within the latter is indicative of pore fluid freshening. Hydrogeological modeling suggests that freshened pore fluids, emplaced during sea-level lowstands and preserved in low permeability units, are potentially still found within carbonate shelves. However, resource potential is low due to its relict nature and low permeability host environment. Key points ● Geophysical data and hydrogeological modeling are applied to detect offshore freshened groundwater in a semi-arid carbonate setting ● Globigerina Limestone and Blue Clay located offshore SE Malta likely host a disconnected offshore freshened groundwater body ● The resistive anomalies within the Upper Coralline Limestone are interpreted as localized porosity variations.Accepted Article This article is protected by copyright. All rights reserved. ● This OFG was emplaced during sea-level lowstands and preserved in low permeability units