Beschreibung: Seafloor elongated depressions are indicators of gas seepage or slope instability. Here we report a sequence of slope-parallel elongated depressions that link to headwalls of sediment slides on upper slope. The depressions of about 250 m in width and several kilometers in length are areas of focused gas discharge indicated by bubble-release into the water column and methane enriched pore waters. Sparker seismic profiles running perpendicular and parallel to the coast, show gas migration pathways and trapped gas underneath these depressions with bright spots and seismic blanking. The data indicate that upward gas migration is the initial reason for fracturing sedimentary layers. In the top sediment where two young stages of landslides can be detected, the slope-parallel sediment weakening lengthens and deepens the surficial fractures, creating the elongated depressions in the seafloor supported by sediment erosion due to slope-parallel water currents.

Beschreibung: Cold seeps on the Hikurangi Margin off New Zealand exhibit various seabed morphologies producing different intensity patterns in backscatter images. Acoustic backscatter characteristics of 25 investigated seep sites do not show a continuous range of patterns between two end members, but fall into four distinct types characterised by variations in backscatter intensity, distribution and inferred structural heights. The types reflect different carbonate morphologies including up to 20 m high structures (type 1), low-relief crusts (type 2), scattered blocks (type 3) and carbonate free sites (type 4). Each seep corresponds to a single type; ntermediates were not observed. Although the observed morphologies and backscatter patterns may have been caused by variations in sediment burial of seep carbonates or differential exhumation by erosion, they probably epresent varying onsets of authigenic carbonate precipitation. Precipitation of carbonate is episodic, which is likely the result of internal forcing. Blocking and subsequent reorganisation of the seep plumbing system lead to abandonment of old seeps and formation of new sites.

Beschreibung: This study presents 2D seismic reflection data, seismic velocity analysis, as well as geochemical and isotopic porewater compositions from Opouawe Bank on New Zealand’s Hikurangi subduction margin, providing evidence for essentially pure methane gas seepage. The combination of geochemical information and seismic reflection images is an effective way to investigate the nature of gas migration beneath the seafloor, and to distinguish between water advection and gas ascent. The maximum source depth of the methane that migrates to the seep sites on Opouawe Bank is 1,500–2,100 m below seafloor, generated by low-temperature degradation of organic matter via microbial CO2 reduction. Seismic velocity analysis enabled identifying a zone of gas accumulation underneath the base of gas hydrate stability (BGHS) below the bank. Besides structurally controlled gas migration along conduits, gas migration also takes place along dipping strata across the BGHS. Gas migration on Opouawe Bank is influenced by anticlinal focusing and by several focusing levels within the gas hydrate stability zone.

Beschreibung: The central Chilean subduction zone between 35°S and 37°S was investigated in order to identify, document and possibly understand fluid flow and fluid venting within the forearc region. Several areas were mapped using multibeam bathymetry and backscatter, high-resolution sidescan sonar, chirp subbottom profiling and reflection seismic data. On a subsequent cruise ground-truthing observations were made using a video sled. In general, this dataset shows surprisingly little evidence of fluid venting along the mid-slope region, in contrast to other subduction zones such as Central America and New Zealand. There were abundant indications of active and predominantly fossil fluid venting along the upper slope between 36.5°S and 36.8°S at the seaward margin of an intraslope basin. Here, backscatter anomalies suggest widespread authigenic carbonate deposits, likely the result of methane-rich fluid expulsion. There is unpublished evidence that these fluids are of biogenic origin and generated within the slope sediments, similar to other accretionary margins but in contrast to the erosional margin off Central America, where fluids have geochemical signals indicating an origin from the subducting plate.

Beschreibung: The Black Sea has undergone several limnic and marine stages due to fluctuations in the global sea level. The exchange of saline water from the Mediterranean Sea to the Black Sea through the Bosporus Strait was interrupted when the sea level dropped below the Bosporus sill. This induced limnic conditions, while marine conditions were established after the reconnection to saline Mediterranean seawater. Extended river fan systems developed during sea level low-stands, providing large amounts of organic material being buried by rapid sedimentation on the slopes of the Black Sea margins. The biogenic degradation of this material produces most of the methane gas expelled into the anoxic water column today. This largely happens by ubiquitous cold vents at ~700 m water depth (i.e. at the stability boundary of methane hydrates) and by mud volcanoes in ~2000 m water depth. A significant amount of gas is expected to accumulate in the sediment within the methane hydrate stability zone. However, bottom-simulating reflectors, the seismic indicator for gas hydrates, are not found everywhere along the margin. Recent analyses of the Danube and Dniepr fans have revealed a discontinuous gas hydrate formation in an area with no active seeps, while areas of active seepage located in the vicinity of BSR reflections held no gas hydrates. In addition, the ongoing diffusion of salt into the uppermost Black Sea sediment pore space since the last glacial maximum further reduces the volume of the gas hydrate stability zone. Estimates of the total amount of gas stored in gas hydrates therefore require a detailed structural analysis prior to regional- or basin-scale modelling attempts.

Beschreibung: Introduction Since the discovery of ‘bright spots’ associated with hydrocarbon deposits, ever increasing interest in determining lithological subsurface parameters has been a driving force for technological development in the hydrocarbon exploration industry. Quantification of lithological parameters is of utmost importance for reservoir prediction and monitoring. Amongst various attempts to determine these, attribute analysis of pwave data and the direct observation of shear wave data are the most visible and successful methods applied. The direct observation of shear waves in the marine environment has been attempted by several means, mainly using ocean bottom cables (OBC) that have three-component geophones (3C) and a hydrophone in addition (thus 4C in total). Some manufacturers offer two component geophones with only one horizontal component. These cables are laid out on the seafloor, sometimes even buried using specialized tools like ROVs (remotely operated vehicles). Data transfer is through the cables as in streamers or land operations, recording is made on a boat or platform where the cable terminates. Geophones are housed in tubes with a self-levelling gimballed mounting system, damped by a viscous fluid. This technique is regarded as proven technology and has been widely accepted. Especially in production areas with many man-made obstacles, this technique also offers a safe operation, and is especially suitable for monitoring purposes (4D–4C seismic). Any desired geometry and density of receivers can be laid out. Direct shear wave observations have been made by several academic institutions, both for active seismic exploration as well as for passive seismological monitoring of earthquakes. These institutions have built ocean bottom seismometers (OBS), which are also four component, two sensor instruments. Unlike OBC, they are autonomously lowered to the seafloor, record within specified time windows, and are later brought back to the surface. Amongst the various instruments designed over the past decades is the OBS range built at GEOMAR, which – due to its modular design – has been used for a wide range of applications.