Description: Large quantities of the greenhouse gas methane (CH4) are stored in the seafloor. The flux of CH4 from the sediments into the water column and finally to the atmosphere is mitigated by a series of microbial methanotrophic filter systems of unknown efficiency at highly active CH4-release sites in shallow marine settings. Here, we studied CH4-oxidation and the methanotrophic community at a high-CH4-flux site in the northern North Sea (well 22/4b), where CH4 is continuously released since a blowout in 1990. Vigorous bubble emanation from the seafloor and strongly elevated CH4 concentrations in the water column (up to 42 µM) indicated that a substantial fraction of CH4 bypassed the highly active (up to ∼2920 nmol cm−3 d−1) zone of anaerobic CH4-oxidation in sediments. In the water column, we measured rates of aerobic CH4-oxidation (up to 498 nM d−1) that were among the highest ever measured in a marine environment and, under stratified conditions, have the potential to remove a significant part of the uprising CH4 prior to evasion to the atmosphere. An unusual dominance of the water-column methanotrophs by Type II methane-oxidizing bacteria (MOB) is partially supported by recruitment of sedimentary MOB, which are entrained together with sediment particles in the CH4 bubble plume. Our study thus provides evidence that bubble emission can be an important vector for the transport of sediment-borne microbial inocula, aiding in the rapid colonization of the water column by methanotrophic communities and promoting their persistence close to highly active CH4 point sources.

Description: During the discovery and description of seven New Zealand methane seep sites, an infaunal assemblage dominated by ampharetid polychaetes was found in association with high seabed methane emission. This ampharetid-bed assemblage had a mean density of 57,000 ± 7800 macrofaunal individuals m−2 and a maximum wet biomass of 274 g m−2, both being among the greatest recorded from deep-sea methane seeps. We investigated these questions: Does the species assemblage present within these ampharetid beds form a distinct seep community on the New Zealand margin? and What type of chemoautotrophic microbes fuel this heterotrophic community? Unlike the other macro-infaunal assemblages, the ampharetid-bed assemblage composition was homogeneous, independent of location. Based on a mixing model of species-specific mass and isotopic composition, combined with published respiration measurements, we estimated that this community consumes 29–90 mmol C m−2 d−1 of methane-fueled biomass; this is 〉 290 times the carbon fixed by anaerobic methane oxidizers in these ampharetid beds. A fatty acid biomarker approach supported the finding that this community, unlike those previously known, consumes primarily aerobic methanotrophic bacteria. Due to the novel microbial fueling and high methane flux rates, New Zealand's ampharetid beds provide a model system to study the influence of metazoan grazing on microbially mediated biogeochemical cycles, including those that involve greenhouse gas emissions

Description: A recently developed deep-sea telemetry (DST), based on the digital subscriber line technology, has been successfully used to equip various remotely operated underwater devices with online video control, high-speed data transmission, and power supply via standard coaxial cables with a length of up to 8,000 m. The system has been applied to study and sample the extreme saline and high-temperature conditions of the Red Sea brines and to detect gas emissions at abandoned wells in the North Sea. In both applications, it has been integrated into a water sampler rosette, providing live video streaming and internal recording from commercial high-definition and analog cameras as well as simultaneous data transmission from a suite of sensors to record and sample the distribution of dissolved gases (e.g., methane and CO2) and oceanographic parameters. This combination makes an ideal survey and monitoring tool for leak detection even in harsh subsea environments. The DST has also been used to deploy landers at selected spots at the seafloor. In combination with remotely operated vehicle (ROV) deployments, this technique can be used to increase significantly the efficiency of ROV bottom time during deep-water operations. The high quality of the video transmission, ease of operation, and versatile application make this novel system superior to existing conventional analog transmission systems.

Description: Recently developed methane sensors, based on infrared (IR) absorption technology, were successfully utilized for subsea methane release measurements. Long-term investigation of methane emissions (fluid flux determination) from natural methane seeps in the Hikurangi Margin offshore New Zealand were performed by using seafloor lander technology. Small centimeter-sized seep areas could be sampled at the seafloor by video-guided lander deployment. In situ sensor measurements of dissolved methane in seawater could be correlated with methane concentrations measured in discrete water samples after lander recovery. High backscatter flares determined by lander-based Acoustic Doppler Current Profiler (ADCP) measurement indicate bubble release from the seafloor. Highest methane concentrations determined by the IR sensor coincided with periods of high ADCP backscatter signals. The high fluid release cannot be correlated with tidal changes only. However, this correlation is possible with variability in spatial bubble release, sudden outbursts, and tidal changes in more quiescent seepage phases. A recently developed IR sensor (2,000 m depth-rated) with a detection limit for methane of about 1 ppm showed good linearity in the tested concentration range and an acceptable equilibration time of 10 min. The sensor was successfully operated offshore Santa Barbara by a small work-class ROV at a natural methane seep (Farrar Seep). High background methane concentration of 50 nmol L−1 was observed in the coastal water, which increases up to 560 nmol L−1 in dissolved methane plumes south of the seepage area. ROV- and lander-based sensor deployments have proven the applicability of IR sensor technology for the determination of subsea methane release rates and plume distribution. The wide concentration range, low detection limit, and its robust detection unit enable this technology for both subsea leak detection and oceanographic trace gas investigations.

Description: During RV Poseidon cruise POS469 (May 2014), the distribution of pCO2 in the near field of submarine volcanic gas flares in shallow water depths down to 50 m below sea level was continuously monitored using three different and independent methodologies. In situ nondispersive infrared (NDIR) spectrometry, pH measurements, and onboard membrane inlet mass spectrometry (MIMS) were used to determine the fate of rising CO2 bubbles and the dissolved CO2 plume patterns in a 300 × 400-m working area. The in situ sensor carrier platform, a towed video-controlled water sampling rosette, equipped with CTD sensors, guaranteed excellent ground truthing of seafloor characteristics and bubble discharge. Sensor data and nearseafloor observations indicated that the gas bubbles (〈9 mm in diameter, 〉97 vol.% of CO2) dissolved very rapidly within the first 10 m above seafloor. Bottom water masses enriched with pCO2 (up to 1,100 μatm) show low pH values (up to 7.80) and tend to spread rather downslope west than following the measured weak current in SSE-SSW direction. The 3-D evaluation of pCO2 plume is a valuable tool to backtrace the origin of CO2 leakage when compared with local current regimes, water column CTD data, and seafloor bathymetry. Seep sites offshore Panarea can be used for studying CO2 leakage behavior and testing measuring strategies in shallow waters. Moreover, this area is a naturally designed laboratory to improve existing physicochemical and oceanographic transport models for subsea CO2 leakage.