ISSN:
0032-3888
Keywords:
Chemistry
;
Chemical Engineering
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Notes:
The solid-state extrusion of polypropylene by hydrostatic pressure has been investigated at four different temperatures: 25, 50, 75, and 100°C. The pressure to effect extrusion was found to be essentially a linear function of the extrusion ratio at each temperature, while the magnitude of the extrusion pressure, for any given extrusion ratio, decreased appreciably with increasing temperature. With increase in extrusion-ratio, the polypropylene extrudates became increasingly transparent. After passing through the extrusion dies; the Sample showed some elastic recovery. The amount of this recovery decreased with increasing extrusion ratio, X-Ray diffraction measurements taken before and after extrusion showed reduction in sharpness of the crystalline Peaks. Differential, scanning calorimetric measurements, on the other hand, indicate that the relative heat of fusion of the extrudates increases with the extrusion ratio at each extrusion temperature. It also increases with extrusion temperature for a given ratio. Tensile stress-strain tests were made at various hydrostatic pressure levels on the extrudates obtained at 25°C and the extrusion ratio of 2.8. Unlike on the virgin sample of polypropylene, ho yield maximum was observed on the extrudate sample at all pressures investigated. However, the effects of pressure on the relative increase in the yield stress-and the modulus of the extrudate are comparable to those of original, unoriented samples.
Additional Material:
11 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/pen.760160808
Permalink
