GLORIA

GEOMAR Library Ocean Research Information Access

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Analytical chemistry 44 (1972), S. 1064-1065 
    ISSN: 1520-6882
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 87 (2000), S. 3570-3572 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: High-resolution spectroscopic study of the 7F0→5D0 transition revealed more than 40 different sites for the rare-earth ion. The multisite behavior was found to be due to clustering of the dopants and dopant induced microscopic defects. Hole-burning efficiencies were measured for some sites. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Pharmaceutical research 12 (1995), S. 700-708 
    ISSN: 1573-904X
    Keywords: bioequivalence ; rate of absorption ; rate of availability ; parent drug ; metabolite ; linear pharmacokinetics ; first-pass
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Simulations were conducted to address the question of whether metabolite data are required for bioequivalence evaluation of immediate release formulations with drugs exhibiting linear pharmacokinetics and first-pass effect. Plasma level-time profiles were generated for parent drug and metabolite using relevant rate constants obtained from a bivariate normal distribution and designated random error. Simulation results showed that the need for metabolite data (Cmax) in the assessment of bioequivalence depends on the relative variability between the absorption process of the drug and first-pass route for metabolite(s). The importance of metabolite Cmax data in the evaluation of rate of availability is clearly demonstrated for drugs with a high degree of intra-subject variation in the first-pass metabolism compared to the absorption process of the drug. Under such conditions, a wider confidence interval was found for the metabolite rather than parent drug. Opposite results were obtained when the intra-subject variance was high for drug absorption relative to first-pass effect. Discrepancies were observed for the scenarios in which the elimination pathway of the metabolite is more variable than the absorption process of the drug. The simulation results were in agreement with real bioequivalence data. It is thus recommended that, in the absence of the information on the relative variability of absorption and first-pass process, both parent drug and metabolite data be included for documentation of bioequivalence, should the metabolite(s) play an important role in the determination of efficacy and safety of the drug.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Pharmaceutical research 17 (2000), S. 1432-1436 
    ISSN: 1573-904X
    Keywords: intrinsic clearance ; metabolites ; bioequivalence
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. Simulated pharmacokinetic (PK) studies were done to determine the effect of intrinsic clearance (CLINT) on the probability of meeting bioequivalence criteria for extent (AUC) and rate (Cmax) of drug absorption when the absorption rate and fraction absorbed (F) were formulated either to be equivalent or to differ by 25%. Methods. Simulated PK studies were done using a linear first-pass model with CLINT values ranging from 15 L/HR to 900 L/HR. Test/Reference absorption rate constants (Ka) and fraction absorbed (Fa) ratios of 1.0 or 1.25 were used for all simulations. The impact of the value of CLINT and its intrasubject variation upon the probability of concluding bioequivalence at the two different Ka and F ratios was studied. Additionally, the effect of fraction metabolized i.v., (Fm) on the probabilities of concluding equivalence was studied at values of 0.25 and 0.75. Results. When CLINT values were raised above those for liver blood flow, the frequency of trials in which bioequivalence was correctly declared decreased when parent AUC was used as a bioequivalence criterion. Only when CLINT exceeded liver blood flow did the metabolite become important in assessing extent of absorption. Conclusions. The Cmax for the parent drug provided the most accurate assessment of bioequivalence. The Cmax for the metabolite was insensitive to changes related to rate of input, and when CLINT exceeded liver blood flow, evaluation of the metabolite Cmax data may lead to a conclusion of bioequivalence for products that were not.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 5
    ISSN: 1573-904X
    Keywords: bioequivalence ; truncated area ; clearance
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. To compare the applicability and accuracy of truncated area (AUCt; where t represents truncated time) versus area to the last quantifiable time point [AUC(O-T)] for assessing bioequivalence. Drugs with either very low or very high intra-subject variability in clearance (CL) were selected for study. Clearance variability was defined by the number of subjects with a quantifiable plasma value (Cp) at each collection time from 24 hrs to last collection time (T). Methods. Data for amiodarone and danazol, drugs with different distributions of subject CL were examined. For amiodarone, the number of subject samples observed (test + reference) at the time of the last quantifiable concentrations was 60 at 240 hrs(T), 16 at 144 hrs and 4 at 96 hrs; while danazol had 4 at 96 hr(T), 3 at 72 hrs, 16 at 60 hrs, 7 at 48 hrs, 14 at 36 hrs, 11 at 24 hrs, 13 and 2 at 16 and 12 hrs, respectively. Simulations (Scenarios A and B) were performed to obtain populations (N = 24) with CL patterns similar to those of amiodarone and danazol. For scenario A (CL pattern similar to amiodarone), log-normally distributed CL values (28.8 L/HR) with intra-subject coefficient of variation (CV) of 25%, 40% and 60% gave the desired CL pattern. Scenario B (CL pattern similar to danazol) required that a subpopulation with an increase in CL of 40% from baseline (i.e., 40.32 L/HR) in 5%, 10% and 20% of the population represent the desired distribution. Power was evaluated by the percentage of times the simulated trials were declared bioequivalent (i.e., the number of times the test vs. reference 90% CI was within 80−125%), while accuracy was determined when the true difference in fraction absorbed (i.e., 1.25) was within the CI. Each simulation was repeated 300 times. Results. The simulation results for Scenario A indicated that the statistical results using truncated area (AUCt) had power and accuracy equivalent to that obtained using the AUC(O-T) metric. However, results for Scenario B indicated that AUCt had less power and accuracy than that obtained using AUC(O-T). The confidence interval (CI) for amiodarone was the same whether AUC (0-T) or AUCt was used as the metric for extent, while for danazol, the AUC(O-T) and AUCt differed in the lower limit by 7%. Conclusions. The truncated area, AUCt, has the greatest power and accuracy when the population clearance is such that most subjects have measurable plasma concentrations at last collection time(T), resulting in a proportional loss of data from each subject.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1573-904X
    Keywords: bioequivalence ; absorption rate ; steady-state bioavailability ; Monte Carlo simulations
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract The purpose of this study was to evaluate the relative performance and usefulness of single dose (SD) and multiple dose (MD) regimens for bioequivalence (BE) determination. Drugs such as indomethacin, procainamide, erythromycin, quinidine, nifedipine were tested for BE under SD and MD dose regimens. Drugs characterized by low accumulation indices (AI) showed virtually no change in the 90% confidence interval (CI) of AUC and CMAX upon multiple dosing. On the other hand, drugs with higher AI appeared to have smaller CI at steady-state. For example, the CI range of AUC and CMAX of quinidine (AI of 1.54) decreased from 26 to 12 and from 22 to 12, respectively, upon multiple dosing. A Monte Carlo simulation study of SD and MD bioequivalence trials was performed. The probability of failing the bioequivalence test was evaluated for several situations defined by different levels of variability and correlation in ka constants, presence or absence of inter- and/or intra-individual variability in clearance (CL) and volume of distribution (V), and different degrees of accumulation. All the possible combinations of these factors were tested with SD and MD study designs. All simulations used 1000 data sets with 30 subjects in each data set for a total of 144 unique designs (total of 144,000 simulations of bioequivalence trials). Upon multiple dosing, narrowing of CI ranges was observed for drugs simulated to have high AI, high variability and a large difference in absorption constants (ka) between test and reference formulations. The mean AUC and CMAX CI ranges for this situation decreased from 15 to 6 and from 16 to 10, respectively, in going from SD to MD design. Thus, there was concordance between simulated and experimental data. The probability of failing the bioequivalence test is shown to dramatically decrease upon multiple dosing due to the changes (range and shift) in the confidence interval.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 7
    ISSN: 1573-904X
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Pharmaceutical research 15 (1998), S. 1077-1084 
    ISSN: 1573-904X
    Keywords: bioequivalence ; steady-state ; area below the Cmin curve
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. Two methods to confirm attainment of steady-state conditions in multiple-dose bioequivalence studies are described and evaluated: (1) the Cmin method and (2) the Area Below the Cmin plasma-concentration-versus-time-curve method (ABCM method). Methods. Cmin Method—After repetitive drug administration to presumed steady-state, successive trough, or Cmin, values are evaluated to determine if they are equal. ABCM Method—The ABCM of successive doses from dose two to presumed steady-state [ABCM(ss)] are divided by the ABCM for the first dose, ABCM(t), to give ABCM(ss)/ ABCM(t)=R, which describes the increase in ABCM(n) with successive doses. The quantity, R, is then divided by an accumulation ratio to render the value independent of intra-subject clearance differences. Monte Carlo simulations were done to test the effects of data error and slow-clearing subpopulations on the method's performance. Data from multiple-dose bioequivalence studies were evaluated using confidence intervals for both methods to determine how well each predicted steady-state for immediate-release and controlled-release drug products. Results/Conclusions. The Cmin method more accurately predicted the attainment of steady-state conditions for immediate-release formulations compared to the ABCM method. Conversely, the ABCM procedure more accurately predicted the attainment of steady-state conditions for controlled-release formulations compared to the Cmin method. The simulation results were further supported by the experimental data.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 9
    ISSN: 1573-904X
    Keywords: bioequivalence ; highly variable drugs ; absorption rate ; Monte Carlo simulations ; single dose bioequivalence trials ; multiple dose bioequivalence trials
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Purpose. A Monte Carlo simulation study was done to investigate the effects of high intrasubject variation in clearance (CL), and volume of distribution (V) on the calculation of the 90% confidence interval (CI) for Cmax for single dose and multiple dose studies. Methods. Simulations were done for both immediate release and sustained release scenarios. The simulated data were compared with clinical data from bioequivalence studies performed on indomethacin and verapamil. Results. Previous reviews and simulations have shown that the probability of failure for the Cmax for single dose studies was always greater than that for multiple dose studies. However, the results for the simulated scenarios currently investigated indicate that if intrasubject (period-to-period) variation in CL and V is high (% CV's above 25%, and 12%, respectively), multiple dose studies can exhibit a higher probability of failure for Cmax than do single dose studies. Furthermore, Cmax values from studies performed with a sustained release scenario are more sensitive to changes in Ka, CL, and V than are results of studies on immediate release products. As an example, the probability of failure for immediate release products in simulated single dose studies is about 11% and 21% when the mean difference in Ka is 10% and 20%, respectively; while, the probability of failure for multiple dose studies is about 36% regardless of the difference in Ka. The corresponding values for the probability of failure for sustained release products were 25%, 53% for single dose studies and 39% for multiple dose studies. The simulations also indicate that changes in the fraction absorbed have a greater effect on the estimation of Cmax in multiple dose regimens than in single dose studies. Conclusions. The results from these investigations indicate that multiple dose studies do not necessarily always reduce variability in Cmax.
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1573-904X
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Location Call Number Limitation Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...