Notes: Dunes that are morphologically of linear type, many of which are probably of longitudinal type in a morphodynamic sense, are common in modern deserts, but their deposits are rarely identified in aeolian sandstones. One reason for non-recognition of such dunes is that they can migrate laterally when they are not exactly parallel to the long-term sand-transport direction, thereby depositing cross-strata that have unimodal cross-bed dip directions and consequently resemble deposits of transverse dunes. Dune-parallel components of sand transport can be recognized in ancient aeolian sands by examining compound cross-bedding formed by small dunes that migrated across the lee slopes of large dunes and documenting that the small dunes migrated with a component in a preferred along-crest direction over the large dunes.

Notes: Where bedforms migrate during deposition, they move upward (climb) with respect to the generalized sediment surface. Sediment deposited on each lee slope and not eroded during the passage of a following trough is left behind as a cross-stratified bed. Because sediment is thus transferred from bedforms to underlying strata, bedforms must decrease in cross-sectional area or in number, or both, unless sediment lost from bedforms during deposition is replaced with sediment transported from outside the depositional area. Where sediment is transported solely by downcurrent migration of two-dimensional bedforms, the mean thickness of cross-stratified beds is equal to the decrease in bedform cross-sectional area divided by the migration distance over which that size decrease occurs; where bedforms migrate more than one spacing while depositing cross-strata, bed thickness is only a fraction of bedform height.Equations that describe this depositional process explain the downcurrent decrease in size of tidal sand waves in St Andrew Bay, Florida, and the downwind decrease in size of transverse aeolian dunes on the Oregon coast. Using the same concepts, dunes that deposited the Navajo, De Chelly, and Entrada Sandstones are calculated to have had mean heights between several tens and several hundreds of metres.

Notes: For more than a century geologists have wondered why some bedforms are orientated roughly transverse to flow, whereas others are parallel or oblique to flow. This problem of bedform alignment was studied experimentally using subaqueous dunes on a 3–6-m-diameter sand-covered turntable on the floor of a 4-m-wide flume.In each experiment, two flow directions (relative to the bed) were produced by alternating the turntable between two orientations. The turntable was held in each orientation for a short time relative to the reconstitution time of the bedforms; the resulting bedforms were in equilibrium with the time-averaged conditions of the bimodal flows. Dune alignment was studied for five divergence angles (the angle between the two flow directions): 45°, 67–5°, 90°, 112–5° and 135°. The flow depth during all experiments was approximately 30 cm; mean velocity was approximately 50 cm s-1 and mean grain diameter was 0–6 mm. Each experiment continued for 30–75 min, during which time the flume flow was steady and the turntable position changed every 2 min. At the end of each experiment, water was slowly drained from the flume and dune alignment was measured. Transverse dunes (defined relative to the resultant transport direction) were created when the divergence angle was 45° and 67–5°, and longitudinal dunes were created when the divergence angle was 135°. At intermediate divergence angles, dunes with both orientations were produced, but transverse dunes were dominant at 90°, and longitudinal dunes were dominant at 112–5°.One experiment was conducted with a divergence angle of 135° and with unequal amounts of transport in the two flow directions. This was achieved by changing the orientation of the turntable at unequal time intervals, thereby causing the amount of transport to be unequal in the two directions. The dunes formed during this experiment were oblique to the resultant transport direction.These experimental dunes follow the same rule of alignment as wind ripples studied in previous turntable experiments. In both sets of experiments, the bedforms developed with the orientation having the maximum gross bedform-normal transport (the orientation at which the sum of the bedform-normal components of the two transport vectors reaches its maximum value). In other words, the bedforms develop with an orientation that is as transverse as possible to the two flows. In those cases where the two flows diverge by more than 90° and transport equal amounts of sand, bedforms that are as transverse as possible to the two separate flows will be parallel to the resultant of the two flow vectors. Although such bedforms have been defined by previous work as longitudinal bedforms, they are intrinsically the same kind of bedform as transverse bedforms.