Description: Bottom shots have been used for a number of years in seismic studies on the ocean floor. Most experiments utilized explosives as the energy source, though researchers have recognized the usefulness of collapsing water voids to produce seismoacoustic signals. Implosive sources, however, suffered generally from a lack of control of source depth. We present a new experimental tool, called SEEBOSEIS, to carry out seismic experiments on the seafloor utilizing hollow glass spheres as controlled implosive sources. The source is a 10-inch BENTHOS float with penetrator. Inside the sphere we place a small explosive charge (two detonators) to destabilize the glass wall. The time of detonation is controlled by an external shooting device. Test measurements on the Ninetyeast Ridge, Indian Ocean, show that the implosive sources can be used in seismic refraction experiments to image the subbottom P- wave velocity structure in detail beyond that possible with traditional marine seismic techniques. Additionally, the implosions permit the efficient generation of dispersed Scholte waves, revealing upper crustal S-wave velocities. The frequency band of seismic energy ranges from less than 1 Hz for Scholte modes up to 1000 Hz for diving P-waves. Therefore, broadband recording units with sampling rates 〉2000 Hz are recommended to sample the entire wave field radiated by implosive sources.

Description: Recent seismic field work has revealed high lower-crustal velocities under Ninetyeast Ridge, Indian Ocean, indicating the presence of crustal underplating (Grevemeyer et al. 2000). We used results from Ocean Drilling Program (ODP) drill cores and cross-spectral analysis of gravity and bathymetric data to study the impact of the underplating body on the subsidence history and the mode of isostatic compensation along Ninetyeast Ridge. Compared with the adjacent Indian basin, the subsidence of Ninetyeast Ridge is profoundly anomalous. Within the first few millions of years after crustal emplacement the ridge subsided rapidly. Thereafter, however, subsidence slowed down significantly. The most reliable model of isostasy suggests loading of a thin elastic plate on and beneath the seafloor. Isostatic compensation of subsurface loading occurs at a depth of about 25km, which is in reasonably good agreement with seismic constraints. Subsurface loading is inherently associated with buoyant forces acting on the lithosphere. The low subsidence may therefore be the superposition of cooling of the lithosphere and uplift due to buoyant material added at the base of the crust. A model including prolonged crustal growth in the form of subcrustal plutonism may account for all observations.

Description: A 550-km-long transect across the Ninetyeast Ridge, a major Indian ocean hotspot trail, provided seismic refraction and wide-angle reflection data recorded on 60 ocean bottom instruments. About 24 000 crustal and 15 000 upper mantle arrivals have been picked and used to derive an image of the hotspot track. Two approaches have been chosen: (i) a first-arrival tomographic inversion yielding crustal properties; and (ii) forward modelling of mantle phases revealing the structure at the crust–mantle boundary region and of the uppermost mantle. Away from the volcanic edifice, seismic recordings show the typical phases from oceanic crust, that is, two crustal refraction branches (Pg), a wide-angle reflection from the crust–mantle boundary (PmP) and a wave group turning within the upper mantle (Pn). Approaching the edifice, three additional phases have been detected. We interpret these arrivals as a wide-angle reflection from the base of material trapped under the pre-hotspot crust (Pm2P) and as a wide-angle reflection (PnP) and its associated refraction branch (PN) from a layered upper mantle. The resulting models indicate normal oceanic crust to the west and east of the edifice. Crustal thickness averages 6.5–7 km. Wide-angle reflections from both the pre-hotspot and the post-hotspot crust–mantle boundary suggest that the crust under the ridge has been bent downwards by loading the lithosphere, and hotspot volcanism has underplated the pre-existing crust with material characterized by seismic velocities intermediate between those of mafic lower crustal and ultramafic upper mantle rocks (7.5–7.6 km s−1). In total, the crust is up to ≈ 24 km thick. The ratio between the volume of subcrustal plutonism forming the underplate and extrusive and intrusive volcanism forming the edifice is about 0.7. An important observation is that underplating continued to the east under the Wharton Basin. During the shield-building phase, however, Ninetyeast Ridge was located adjacent to the Broken Ridge and was subsequently pulled apart along a transform fault boundary. Therefore, underplating eastwards of the fracture zone separating the edifice from the Wharton Basin suggests that prolonged crustal growth by subcrustal plutonism occurred over millions of years after the major shield-building stage. This fact, however, requires mantle flow along the fossil hotspot trail. The occurrence of PnP and PN arrivals is probably associated with a layered and anisotropic upper mantle due to the preferential alignment of olivine crystals and may have formed by rising plume material which spread away under the base of the lithosphere.

Description: Mud extrusion is frequently observed as a dewatering phenomenon in compressional tectonic settings such as subduction zones. Along the Middle American Trench, several of these features have been recently discovered. This paper presents a heat flow study of actively venting Mound Culebra, offshore Nicoya Peninsula, and is complemented by data from geophysical surveys and coring. The mud diapir is characterised by methane emission and authigenic carbonate formation at its crest, and is composed of overconsolidated scaly clays and clast-bearing muds. Compared with the conductive background heat flow, the flux through the mud dome is elevated by 10–20 mW/m2, possibly related to advection of heat by fluids rising from greater depth. Decreased chlorinity in the pore waters from gravity cores may support a deep-seated fluid origin. Geothermal measurements across the mound and temperature measurements made with outriggers on gravity corers were corrected for the effects of thermal refraction, forced by the topography of the mound. Corrected values roughly correlate with the topography, suggesting advection of heat by fluids rising through the mound, thereby generating the prominent methane anomaly over the dome and nurturing vent biota. However, elevated values occur also to the southeast of the mound. We believe that the overconsolidated clays and carbonates on the crest form an almost impermeable lid. Fluids rising from depth underneath the dome are therefore partially channelled towards the flanks of the mound.

Description: Gas hydrates were recovered from a mud diapir (Mound 11) located on the southern continental slope off Costa Rica at a water depth of about 1000 m during expedition M54/2 with RV METEOR in September 2002. A massive layer of solid methane gas hydrate was retrieved from the base of a gravity corer at a sediment depth of 2 m. Several mound-shaped and carbonate-covered mud diapirs were previously discovered off Costa Rica and Nicaragua during the ongoing research within the framework of the Sonderforschungsbereich 574 "Volatiles and Fluids in Subduction Zones" but solid hydrates were recovered only from Mound 11. This structure has a diameter of about 300 m and protrudes the surrounding seafloor by about 20 m. The seamount sits on approximately 1 km of hemipelagic sediment disrupted by normal faults, which could provide fluid and mass transport pathways from greater depth to the sea floor. Video observations of Mound 11 revealed the presence of authigenic carbonates and bacterial mats indicating methane-charged fluids reaching the sediment surface. Water sampling and gas chromatographic analyses showed methane enrichments in the overlying bottom water confirming the release of methane. In-situ temperature measurements indicated elevated heat flow within the hydrate-bearing sediment strata. Pore fluids recovered from the mound were strongly depleted in dissolved chloride and enriched in boron indicating a deep origin of rising fluids and gases. The results of the ongoing isotopic analysis of gas hydrates and pore waters will be used to further constrain the source of methane-rich fluids.

Description: Microseism recordings from four European broadband stations and from three seismic arrays in Scotland, Norway, and Germany are compared with model wave data of the oceanic wave field in the North Atlantic and local ocean wave data from the Norwegian coast at 60�N, both measured during February–March 2000. Two approaches have been tested to locate generation areas of microseismic energy: a new amplitude correlation technique and beam backprojection from the three seismic arrays. Both techniques reveal that the main generation areas are located in specific regions off the coast of Southwest Norway and North Scotland. Seismic stations distant from these generation areas record a superposition of seismic energy from different source regions. Those close to a specific source region also show a high correlation with it. Both techniques give upper limits for the extent of the generation area of the strongest storm on 6/7 March at the southwest Norwegian coast of about 500 km. By using marine X-band radar measurements of the two-dimensional wave height spectrum, we estimate that the relative change of the extension of the generation area off the coast of southwest Norway during several storms is less than a factor of 3. This indicates that the size of the generation area is controlled by static features as coastline or bathymetry, and not by the extent of the storms. Microseism energy appears to be mainly controlled by the wave height in distinct and identifiable generation regions, so that the wave climate in these regions can be studied using historical records of microseisms.