In:
Tire Science and Technology, The Tire Society, Vol. 42, No. 3 ( 2014-07-01), p. 116-144
Abstract:
For modeling an aircraft tire using the brush model method, the friction coefficient μ between rubber and asphalt should not only be described in terms of the applied pressure and sliding velocity/slip ratio, but also by local temperature inside the contact area. Its influence cannot be neglected, since it leads to significant material property changes. Therefore, investigations on different test rigs are analyzed using thermal recordings of an infrared camera. First measurements are done on a high speed linear tester (HiLiTe), a test rig at the Institute of Dynamics and Vibration Research (IDS) at Leibniz University Hanover, Germany. It allows testing single tread block samples with a constant slip ratio of 100%, that is, pure sliding, on a variety of surfaces such as dry and wet asphalt or concrete, as well as on snow and ice. Results in this paper show that the convection has a smaller impact on tread block cooling than the actual contact between runway surface and sample. Since colder surface temperatures lead to higher friction, this effect antagonizes the excitation frequency, which heats up the rubber sample at high velocities. On long-lasting test sequences a quasi–steady-state friction coefficient might be achieved once these effects start to converge. Still, owing to permanent slip, the abrasion leads to cooling as the hot top layer of the rubber is removed occasionally. In addition to these quasi–steady-state measurements on HiLiTe, the thermal behavior of an aircraft tire is investigated with an autonomously running test rig. It allows realistic testing on an airfield runway by altering load, speed, and slip angle of the tire within and beyond the regions of a passenger aircraft. During the measurements, new and partially unknown effects could be observed. The temperature is mostly influenced by the slip angle followed by speed and load. Furthermore, the contact between tire and runway leads to cooling of the tread but does not affect the temperature inside the grooves. They heat up separately and tend to transfer heat to the tread if the cooling by the runway becomes too low.
Type of Medium:
Online Resource
ISSN:
1945-5852
,
0090-8657
DOI:
10.2346/tire.14.420301
Language:
English
Publisher:
The Tire Society
Publication Date:
2014
Permalink
