In:
Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, SAGE Publications, Vol. 237, No. 7 ( 2023-04), p. 1647-1667
Abstract:
Thin-walled workpieces are widely used in the aerospace field, and milling is the main processing method of such components. However, thin-walled workpieces are prone to vibrate during milling because of their weak stiffness, and the vibrations significantly affect the processing quality. Therefore, it is important to develop a novel milling vibration suppression method for thin-walled parts. The present work focused on the milling vibration control of a thin-walled workpiece using a semi-active magnetorheological (MR) damper. The forward dynamic model and inverse control model of the MR damper were first established, and its actuating position on the workpiece was then determined by modal analysis. The dynamic model of the MR damper at this position was built based on the proposed dynamic parameter acquisition method and used in the following semi-active control algorithm design. The effectiveness of this algorithm was verified by MATLAB/Simulink simulations. Finally, six groups of milling experiments were carried out using the non-damper, the rigid rod, the damper applied with 1-, 2-, and 3-A currents, and the semi-active control damper to validate the practical effect of the proposed algorithm. It was found that the designed semi-active control MR damper outperformed the constant-current control dampers or the rigid rod. In comparison to the non-damper experiment, the root mean square (RMS) values of milling forces in x- and y-directions decreased by 45.12% and 48.58%, respectively, and surface roughness decreased by 40.22%.
Type of Medium:
Online Resource
ISSN:
0954-4062
,
2041-2983
DOI:
10.1177/09544062221132698
Language:
English
Publisher:
SAGE Publications
Publication Date:
2023
detail.hit.zdb_id:
2024890-8
Permalink
