Description: Purpose   Managing declining nutrient use efficiency in crop production has been a global priority to maintain high agricultural productivity with finite non-renewable nutrient resources, in particular phosphorus (P). Rapid spectroscopic methods increase measurement density of soil nutrients and improve the accuracy of rates of additional P inputs. Materials and methods   Soil P was measured by a multi-element energy-dispersive X-ray fluorescence spectroscopic (XRFS) method to estimate the spatial distribution of soil total (XRFS-P) and bioavailable P in a Fluvisol occurring on a 20-ha contiguous area comprised of seven elongated field strips under a wheat–maize rotation near the Quzhou Agricultural Experiment Station in the North China Plain. Results and discussion   Soil XRFS-P was highly variable along the length of the field strips and across the entire area after decades of continuous cultivation. A linear relationship existed between XRFS-P and bicarbonate-extractable P or Mehlich 3-extractable P, allowing a description of the spatial distribution of bioavailable P based on XRFS, in both directions of a two-dimensional grid covering the entire area ( p  〈 0.05). Distinct management zones were identified for more precise placement of additional P. Conclusions   Direct element-specific analysis and a high sample throughput make XRFS an indispensable component of a new approach to sustainably manage P, and other macronutrients of low atomic number Z such as K, Ca, or Cl in production fields, based on their site-specific variations in the soil. Concerning P, this rapid precision approach provides a promising avenue to manage soil P as a regionalized variable while preventing zones of deficiency or surplus P that can affect plant productivity or potential loss from a field, respectively. Content Type Journal Article Pages 1-12 DOI 10.1007/s11368-011-0347-2 Authors Thanh H. Dao, USDA-ARS Environmental Management and ByProducts Utilization Laboratory, BARC-East Bldg. 306, Beltsville, MD 20705, USA Yuxin X. Miao, College of Resources and Environmental Science, China Agricultural University, Beijing, People’s Republic of China Fusuo S. Zhang, College of Resources and Environmental Science, China Agricultural University, Beijing, People’s Republic of China Journal Journal of Soils and Sediments Online ISSN 1614-7480 Print ISSN 1439-0108

Description: Present day system Earth research utilizes the tool ‘Scientific Drilling’ to access samples and to monitor deep Earth processes that cannot be tackled by other scientific means. Unlike most laboratory experiments or computer modelling, drilling projects are massive field endeavours requiring intense collaboration of researchers with engineers and service providers. In the framework of the International Continental Scientific Drilling Program, ICDP, more than seventy drilling projects have been conducted, from multiyear big research programs to short, smallscale deployments such as lake drilling projects. ICDP has supported these projects not only through grants covering field-related costs, but also through a variety of scientific-technical services and support, as well as active help in data management, outreach and publication. These services are described in this booklet. Due to its instructional character, we call it the ICDP Primer.

Description: This brochure is designed for scientists and engineers of upcoming drilling projects and explains the key steps and important challenges in planning and executing continental scientific drilling.

Description: This brochure is designed for scientists and engineers of upcoming drilling projects and explains the key steps and important challenges in planning and executing continental scientific drilling.

Description: In July 2007 GFZ hosted ILP’s first Potsdam Conference, titled “Frontiers in Integrated Solid Earth Sciences”. The results of this meeting were presented in an over 400 pages large Springer book, the first volume of a new series on the International Year of Planet Earth (IYPE). In October 2010 ILP’s Second Potsdam Conference took place, entitled “Solid Earth – Basic Science for the Human Habitat”, again in Potsdam. More than 70 scientists from more than 20 states worldwide came together and shared their results, ideas and visions. This time, in September 2015, ILP’s 35th birthday was the motivation for “Celebrating Excellence in Solid Earth Sciences”. Together with more than 50 scientists, members of the ILP Task Forces and Coordinating Committees, the ILP bureau and ILP’s office came together for three days in September.

Description: Purpose   At present, many urban areas in Mediterranean climates are coping with water scarcity, facing a growing water demand and a limited conventional water supply. Urban design and planning has so far largely neglected the benefits of rainwater harvesting (RWH) in the context of a sustainable management of this resource. Therefore, the purpose of this study was to identify the most environmentally friendly strategy for rainwater utilization in Mediterranean urban environments of different densities. Materials and methods   The RWH systems modeled integrate the necessary infrastructures for harvesting and using rainwater in newly constructed residential areas. Eight scenarios were defined in terms of diffuse (D) and compact (C) urban models and the tank locations ((1) underground tank, (2) below-roof tank, (3) distributed-over-roof tank, and (4) block tank). The structural and hydraulic sizing of the catchment, storage, and distribution subsystems was taken into account using an average Mediterranean rainfall, the area of the harvesting surfaces, and a constant water demand for laundry. The quantification of environmental impacts was performed through a life cycle assessment, using CML 2001 Baseline method. The necessary materials and processes were considered in each scenario according to the lifecycle stages (i.e., materials, construction, transportation, use, and deconstruction) and subsystems. Results and discussion   The environmental characterization indicated that the best scenario in both urban models is the distributed-over-roof tank (D3, C3), which provided a reduction in impacts compared to the worst scenario of up to 73% in diffuse models and even higher in compact ones, 92% in the most dramatic case. The lower impacts are related to the better distribution of tank weight on the building, reducing the reinforcement requirements, and enabling energy savings. The storage subsystem and the materials stage contributed most significantly to the impacts in both urban models. In the compact density model, the underground-tank scenario (C1) presented the largest impacts in most categories due to its higher energy consumption. Additionally, more favorable environmental results were observed in compact densities than in diffuse ones for the Global Warming Potential category along with higher water efficiencies. Conclusions   The implementation of one particular RWH scenario over another is not irrelevant in drought-stress environments. Selecting the most favorable scenario in the development of newly constructed residential areas provides significant savings in CO 2 emissions in comparison with retrofit strategies. Therefore, urban planning should consider the design of RWH infrastructures using environmental criteria in addition to economic, social, and technological factors, adjusting the design to the potential uses for which the rainwater is intended. Recommendations and perspectives   Additional research is needed to quantify the energy savings associated with the insulation caused by using the tank distributed over the roof. The integration of the economic and social aspects of these infrastructures in the analysis, from a life cycle approach, is necessary for targeting the planning and design of more sustainable cities in an integrated way. Content Type Journal Article Category WATER USE IN LCA Pages 1-18 DOI 10.1007/s11367-011-0330-6 Authors Sara Angrill, Sostenipra (ICTA-IRTA-Inèdit), Institute of Environmental Science and Technology (ICTA), School of Engineering (EE), Universitat Autònoma de Barcelona (UAB), Campus of the UAB, 08193 Bellaterra (Cerdanyola del Vallès), Barcelona, Catalonia, Spain Ramon Farreny, Sostenipra (ICTA-IRTA-Inèdit), Institute of Environmental Science and Technology (ICTA), School of Engineering (EE), Universitat Autònoma de Barcelona (UAB), Campus of the UAB, 08193 Bellaterra (Cerdanyola del Vallès), Barcelona, Catalonia, Spain Carles M. Gasol, Sostenipra (ICTA-IRTA-Inèdit), Institute of Environmental Science and Technology (ICTA), School of Engineering (EE), Universitat Autònoma de Barcelona (UAB), Campus of the UAB, 08193 Bellaterra (Cerdanyola del Vallès), Barcelona, Catalonia, Spain Xavier Gabarrell, Sostenipra (ICTA-IRTA-Inèdit), Institute of Environmental Science and Technology (ICTA), School of Engineering (EE), Universitat Autònoma de Barcelona (UAB), Campus of the UAB, 08193 Bellaterra (Cerdanyola del Vallès), Barcelona, Catalonia, Spain Bernat Viñolas, Department of Geotechnical Engineering and Geosciences, School of Civil Engineering (ETSECCPB), Technical University of Catalonia—Barcelona Tech (UPC), Campus Nord, C/ Jordi Girona 1-3, Building D2, 08034 Barcelona, Catalonia, Spain Alejandro Josa, Department of Geotechnical Engineering and Geosciences, School of Civil Engineering (ETSECCPB), Technical University of Catalonia—Barcelona Tech (UPC), Campus Nord, C/ Jordi Girona 1-3, Building D2, 08034 Barcelona, Catalonia, Spain Joan Rieradevall, Sostenipra (ICTA-IRTA-Inèdit), Institute of Environmental Science and Technology (ICTA), School of Engineering (EE), Universitat Autònoma de Barcelona (UAB), Campus of the UAB, 08193 Bellaterra (Cerdanyola del Vallès), Barcelona, Catalonia, Spain Journal The International Journal of Life Cycle Assessment Online ISSN 1614-7502 Print ISSN 0948-3349

Description: Dimethyl sulphide (DMS) and carbon monoxide (CO) are climate-relevant trace gases that play key roles in the radiative budget of the Arctic atmosphere. Under global warming, Arctic sea ice retreats at an unprecedented rate, altering light penetration and biological communities, and potentially affect DMS and CO cycling in the Arctic Ocean. This could have socio-economic implications in and beyond the Arctic region. However, little is known about CO production pathways and emissions in this region and the future development of DMS and CO cycling. Here we summarize the current understanding and assess potential future changes of DMS and CO cycling in relation to changes in sea ice coverage, light penetration, bacterial and microalgal communities, pH and physical properties. We suggest that production of DMS and CO might increase with ice melting, increasing light availability and shifting phytoplankton community. Among others, policy measures should facilitate large-scale process studies, coordinated long term observations and modelling efforts to improve our current understanding of the cycling and emissions of DMS and CO in the Arctic Ocean and of global consequences.

Description: Seafloor massive sulfide(SMS) deposits which consist of Au, Ag, Cu, and other metal elements, have been a target of commercial mining in recent decades. The demand for established and reliable commercial mining system for SMS deposits is increasing within the marine mining industry. The current status and progress of mining technology and equipment for SMS deposits are introduced. First, the mining technology and other recent developments of SMS deposits are comprehensively explained and analyzed. The seafloor production tools manufactured by Nautilus Minerals and similar mining tools from Japan for SMS deposits are compared and discussed in turn. Second, SMS deposit mining technology research being conducted in China is described, and a new SMS deposits mining tool is designed according to the environmental requirement. Finally, some new trends of mining technology of SMS deposits are summarized and analyzed. All of these conclusions and results have reference value and guiding significance for the research of SMS deposit mining in China.