Description: Studies of convergent margin tectonics along the Japan Trench Transect are based on geophysical as well as on drill and conventional sampling data. The large number of geophysical and geological studies in the 1960's made this area an attractive target for convergent margin drill core sampling. Once the transect was scheduled for drilling by the Glomar Challenger, the earth science community in Japan intensified its efforts to collect geophysical and geological data within the transect area. Many of these data are published in Japanese and international journals. This chapter describes both the seismic reflection records along which Legs 56 and 57 drilling took place and the reflection records made after drilling. The seismic data are interpreted in light of the drilling results.

Description: Hole 504B is by far the deepest hole yet drilled into the oceanic crust in situ, and it therefore provides the most complete “ground truth” now available to test our models of the structure and evolution of the upper oceanic crust. Cored in the eastern equatorial Pacific Ocean in 5.9-m.y.-old crust that formed at the Costa Rica Rift, hole 504B now extends to a total depth of 1562.3 m below seafloor, penetrating 274.5 m of sediments and 1287.8 m of basalts. The site was located where the rapidly accumulating sediments impede active hydrothermal circulation in the crust. As a result, the conductive heat flow approaches the value of about 200 mW/m² predicted by plate tectonic theory, and the in situ temperature at the total depth of the hole is about 165°C. The igneous section was continuously cored, but recovery was poor, averaging about 20%. The recovered core indicates that this section includes about 575 m of extrusive lavas, underlain by about 200 m of transition into over 500 m of intrusive sheeted dikes; the latter have been sampled in situ only in hole 504B. The igneous section is composed predominantly of magnesium-rich olivine tholeiites with marked depletions in incompatible trace elements. Nearly all of the basalts have been altered to some degree, but the geochemistry of the freshest basalts is remarkably uniform throughout the hole. Successive stages of on-axis and off-axis alteration have produced three depth zones characterized by different assemblages of secondary minerals: (1) the upper 310 m of extrusives, characterized by oxidative “seafloor weathering“; (2) the lower extrusive section, characterized by smectite and pyrite; and (3) the combined transition zone and sheeted dikes, characterized by greenschist-facies minerals. A comprehensive suite of logs and downhole measurements generally indicate that the basalt section can be divided on the basis of lithology, alteration, and porosity into three zones that are analogous to layers 2A, 2B, and 2C described by marine seismologists on the basis of characteristic seismic velocities. Many of the logs and experiments suggest the presence of a 100- to 200-m-thick layer 2A comprising the uppermost, rubbly pillow lavas, which is the only significantly permeable interval in the entire cored section. Layer 2B apparently corresponds to the lower section of extrusive lavas, in which original porosity is partially sealed as a result of alteration. Nearly all of the logs and experiments showed significant changes in in situ physical properties at about 900–1000 m below seafloor, within the transition between extrusives and sheeted dikes, indicating that this lithostratigraphic transition corresponds closely to that between seismic layers 2B and 2C and confirming that layer 2C consists of intrusive sheeted dikes. A vertical seismic profile conducted during leg 111 indicates that the next major transition deeper than the hole now extends—that between the sheeted dikes of seismic layer 2C and the gabbros of seismic layer 3, which has never been sampled in situ—may be within reach of the next drilling expedition to hole 504B. Therefore despite recent drilling problems deep in the hole, current plans now include revisiting hole 504B for further drilling and experiments when the Ocean Drilling Program returns to the eastern Pacific in 1991.

Description: Transects of the submersible Alvin across rock outcrops in the Oregon subduction zone have furnished information on the structural and stratigraphic framework of this accretionary complex. Communities of clams and tube worms, and authigenic carbonate mineral precipitates, are associated with venting sites of cool fluids located on a fault-bend anticline at a water depth of 2036 meters. The distribution of animals and carbonates suggests up-dip migration of fluids from both shallow and deep sources along permeable strata or fault zones within these clastic deposits. Methane is enriched in the water column over one vent site, and carbonate minerals and animal tissues are highly enriched in carbon-12. The animals use methane as an energy and food source in symbiosis with microorganisms. Oxidized methane is also the carbon source for the authigenic carbonates that cement the sediments of the accretionary complex. The animal communities and carbonates observed in the Oregon subduction zone occur in strata as old as 2.0 million years and provide criteria for identifying other localities where modern and ancient accreted deposits have vented methane, hydrocarbons, and other nutrient-bearing fluids.