Description: The objectives for Expedition 352 were to drill through the entire volcanic sequence of the Bonin fore arc to 1. Obtain a high-fidelity record of magmatic evolution during subduction initiation and early arc development, 2. Test the hypothesis that fore-arc basalt lies beneath boninite and understand chemical gradients within these units and across the transition, 3. Use drilling results to understand how mantle melting processes evolve during and after subduction initiation, and 4. Test the hypothesis that the fore-arc lithosphere created during subduction initiation is the birthplace of suprasubduction zone (SSZ) ophiolites. Expedition 352 successfully cored 1.22 km of igneous basement and 0.46 km of over-lying sediment, providing diverse, stratigraphically controlled suites of fore-arc basalts (FAB) and boninite related to seafloor spreading and earliest arc development. FAB were recovered at the two deeper water sites (U1440 and U1441) and boninites at the two sites (U1439 and U1442) drilled upslope to the west. FAB lavas and dikes are depleted in high-field strength trace elements such as Ti and Zr relative to mid-ocean-ridge basalt but have relatively diverse concentrations of trace elements bezcause of variation in degrees of melting and amount of subducted fluids involved in their genesis. All FAB magmas underwent significant crystal fractionation in a persistent magma chamber system. Holes U1439C and U1442A yielded entirely boninitic lavas. We defined three boninite differentiation series based on variations in MgO, SiO2, and TiO2 concentrations of the parental magmas. Lavas in both pairs of holes have compositions that generally become more primitive and have lower TiO2 concentrations upward. The presence of dikes at the base of the sections at Sites U1439 and U1440 provides evidence that boninitic and FAB lavas are both underlain by their own conduit systems and that FAB and boninite group lavas are likely offset more horizontally than vertically. We thus propose that seafloor spreading related to subduction initiation migrated from east to west after subduction initiation and during early arc development. Initial spreading was likely rapid, and an axial magma chamber was present. Melting was largely decompressional during this period, but subducted fluids affected some melting. As subduction continued and spreading migrated to the west, the embryonic mantle wedge became more depleted, and the influence of subducted constituents dramatically increased, causing the oceanic crust to be built of boninitic rather than tholeiitic magma. The general decrease in fractionation upward reflects the eventual disappearance of persistent magma chambers, either because spreading rate was decreasing with distance from the trench or because spreading was succeeded by off-axis magmatism trenchward of the ridge. The extreme depletion of the sources for all boninitic lavas was likely related to the incorporation of mantle residues from FAB generation. This mantle depletion continued during generation of lower silica boninitic magmas, exhausting clinopyroxene from the mantle such that the capping high-Si, low-Ti boninites were generated from harzburgite. Additional results of the cruise include recovery of Eocene to recent deep-sea sediment that records variation in sedimentation rates with time resulting from variations in climate, the position of the carbonate compensation depth, and local structural control. Three phases of highly explosive volcanism (latest Pliocene to Pleistocene, late Miocene to earliest Pliocene, and Oligocene) were identified, represented by 132 graded air fall tephra layers. Structures found in the cores and reflected in seismic profiles show that this area had periods of normal, reverse, and strike-slip faulting. Finally, basement rock P-wave velocities were shown to be slower than those observed during logging of normal ocean crust sites.

Description: Valdivia Bank (VB) is a Late Cretaceous oceanic plateau formed by volcanism from the Tristan-Gough hotspot at the Mid-Atlantic Ridge (MAR). To better understand its origin and evolution, magnetic data were used to generate a magnetic anomaly grid, which was inverted to determine crustal magnetization. The magnetization model reveals quasi-linear polarity zones crossing the plateau and following expected MAR paleo-locations, implying formation by seafloor spreading over ∼4 Myr during the formation of anomalies C34n-C33r. Paleomagnetism and biostratigraphy data from International Ocean Discovery Program Expedition 391 confirm the magnetic interpretation. Anomaly C33r is split into two negative bands, likely by a westward ridge jump. One of these negative anomalies coincides with deep rift valleys, indicating their age and mechanism of formation. These findings imply that VB originated by seafloor spreading-type volcanism during a plate reorganization, not from a vertical stack of lava flows as expected for a large volcano. Key Points - Valdivia Bank is characterized by quasi-linear magnetic anomalies that are parallel to the inferred paleo-Mid-Atlantic Ridge - Magnetic anomalies imply that the plateau becomes younger E-W consistent with formation via seafloor spreading during anomalies C34n-C33r - Rift valleys, division of C33r, and anomaly curvature imply complex ridge tectonics and a ridge jump

Description: The past ∼200 million years of Earth's geomagnetic field behavior have been recorded within oceanic basalts, many of which are only accessible via scientific ocean drilling. Obtaining the best possible paleomagnetic measurements from such valuable samples requires an a priori understanding of their magnetic mineralogies when choosing the most appropriate protocol for stepwise demagnetization experiments (either alternating field or thermal). Here, we present a quick, and non‐destructive method that utilizes the amplitude‐dependence of magnetic susceptibility to screen submarine basalts prior to choosing a demagnetization protocol, whenever conducting a pilot study or other detailed rock‐magnetic characterization is not possible. We demonstrate this method using samples acquired during International Ocean Discovery Program Expedition 391. Our approach is rooted in the observation that amplitude‐dependent magnetic susceptibility is observed in basalt samples whose dominant magnetic carrier is multidomain titanomagnetite (∼TM 60–65 , (Ti 0.60–0.65 Fe 0.35–0.40 )Fe 2 O 4 ). Samples with low Ti contents within titanomagnetite or samples that have experienced a high degree of oxidative weathering do not display appreciable amplitude dependence. Due to their low Curie temperatures, basalts that possess amplitude‐dependence should ideally be demagnetized either using alternating fields or via finely‐spaced thermal demagnetization heating steps below 300°C. Our screening method can enhance the success rate of paleomagnetic studies of oceanic basalt samples. Plain Language Summary Oceanic basalts are ideal recorders of the Earth's magnetic field. To decipher magnetic histories recorded in rocks, paleomagnetists need to isolate the magnetization directions and intensities within rocks by one of two possible methods. One method typically involves progressively heating the samples to high temperatures. The other method involves exposing samples to alternating magnetic fields with increasing peak field intensities. Both of these methods are ultimately destructive to the original magnetization preserved within rocks. However, without knowledge of a given rock's magnetic mineralogy, randomly choosing thermal or alternating field demagnetization methods may result in high failure rates. We developed a pre‐screening method to help decide which cleaning method will likely be more successful for a given sample based on low‐field magnetic susceptibility measurements. These measurements do not affect the original magnetic information recorded in a rock, thereby permitting subsequent paleomagnetic studies on the same sample. Our technique can be performed as rapidly as 2 min per sample, is non‐destructive, and does not require complicated sample preparation. Key Points Paleomagnetic studies utilize either alternating field or thermal demagnetization, but it is difficult to choose the best protocol a priori Amplitude‐dependence of magnetic susceptibility measurements permits preliminary magnetic mineralogy characterization in submarine basalts Rapid amplitude‐dependence measurements may aid in deciding upon the best demagnetization protocol for submarine basalt samples

Description: The intrusion mechanism and internal structure of sills are still under debate. We present a detailed magnetic study, including anisotropy of magnetic susceptibility and rock magnetic analyses of a Cretaceous (94 Ma), 7-m-thick sill from the Lusitanian Basin in Portugal, the Foz da Fonte sill. The results, from both the top surface and a vertical profile, allow us to propose a model for the magmatic flow pattern and sense of flow. According to their location in the vertical profile, three magnetic fabric domains are identified: (1) at the borders, qualified as chilled margins (~0–50 cm), low anisotropies suggest that low velocity gradients and heterogeneous flow paths occurred during the initial emplacement stages; (2) in the centre of the sill, where low anisotropies are observed, low shear gradients and magma displacement close to pure translation is inferred and (3) in the intermediate zones, high anisotropy values are ascribed to zones having undergone high shear gradients. The mean magnetic lineations from the top surface and basal contact indicate an almost horizontal and NW–SE orientation (azimuth: 310°) which agrees with the preferred orientation of iron oxide grain clusters and with the elongation of vesicles considered as coaxial with the magma flow direction. Moreover, the magnetic foliation planes and the lineations show both a mirror imbrication relative to the average upper and lower border surfaces of the sill, pointing to a flow direction towards the SE. Based on these results and on the interpretation of two seismic reflection lines, we show that the Cabo Raso magnetic anomaly, located 25 km to NW of the FF-sill, is associated to Cretaceous magmatic intrusions from which the sill likely originated. This tectono-magmatic setting is discussed with respect to the West Iberia Late Cretaceous magmatism, integrating magnetic anomalies, isotope chronology and tectonics.

Description: IODP Expedition 324 cored igneous rocks from Shatsky Rise, an oceanic plateau in the northwest Pacific Ocean that formed mainly during late Jurassic and Early Cretaceous times. We selected 60 samples from 3 different holes for Thellier–Thellier palaeointensity determinations. Induced and remanent magnetization curves measured at low- and high-temperature suggest a diverse and complex magnetic mineralogy, with large variations in Ti content and oxidation state. Hysteresis and FORC measurements show that most samples contain single-domain magnetic grains. After carrying out the palaeointensity determinations, only 9 samples satisfied all reliability criteria. These gave palaeointensity values between 16.5 and 21.5 μT, which correspond to average VDM values of (4.9 ± 0.2)  x 10 22 Am 2 for an estimated age of 140–142 Ma. This value is lower than that for the recent field, which agrees with the hypothesis of a Mesozoic Dipole Low.

Description: The Hawaiian-Emperor hotspot track has a prominent bend, which has served as the basis for the theory that the Hawaiian hotspot, fixed in the deep mantle, traced a change in plate motion. However, paleomagnetic and radiometric age data from samples recovered by ocean drilling define an age-progressive paleolatitude history, indicating that the Emperor Seamount trend was principally formed by the rapid motion (over 40 millimeters per year) of the Hawaiian hotspot plume during Late Cretaceous to early-Tertiary times (81 to 47 million years ago). Evidence for motion of the Hawaiian plume affects models of mantle convection and plate tectonics, changing our understanding of terrestrial dynamics.

Description: First-order reversal curve (FORC) diagrams were measured on a variety of synthetic and natural (submarine basalts and potsherds) samples, as well as for a mixture, between room temperature and 10 K. Measuring FORC diagrams allowed us to examine the behavior of the coercivity field and interaction field distributions with decreasing temperature. Generally, as the temperature is decreased, FORC contours were observed to expand in all directions, e.g., the maximum coercivity peak migrates toward a higher coercivity. For synthetic magnetite samples, there were abrupt changes in the FORC distribution at the Verwey transition (120 K), while in the more complex natural magnetite samples the FORC distribution gradually progressed with temperature. As the temperature decreased, FORC diagrams were found to display different domain state characteristics. For example, samples with dominant superparamagnetic signals became single-domain (SD)-like, a SD-like sample stayed SD-like, and a PSD-like sample became more SD-like. In addition to these general features, we also observed some more specialized features. First, in both synthetic and natural magnetite samples, a secondary higher-coercivity peak is occasionally present below the Verwey transition, which we suggest is a twinning contribution. Second, the coercivity increases by a factor 15 between 300 K and 20 K in some of the seamount samples. Third, the effect of field cooling/zero-field cooling on FORC diagrams is negligible, with the hysteresis parameters HC and HCR displaying a greater dependency. Finally, it is shown that in mixtures of magnetite and hematite, the hematite contribution disappears on cooling below the Morin transition, leaving a strong, well-defined magnetite signal.